A. 2 pts: In terms of conservation of mass, what were the results of each experiment (which one conserved mass and which one did not)?
B. 4 pts: PROVIDE a SPECIFIC explanation for "why" the results in both videos were different.
. 2 pts: Discuss differences in the experimental steps between the two videos (for example what was done in video one that was not done in
video two, why would this make a difference in conserving mass?)
• 2 pts: Look at both chemical equations (below for convenience), what difference in the type of products would have contributed to the
differences in why one conserved mass and one did not?
REACTION 1: Pb(NO3)2 (aq) + 2K1 (aq) --> 2KNO3 (aq) +Pölz (s)
• REACTION 2: NaHCO3(s) + CH3COOH(aq) → CO2(g) + H2Om + CH3COONa(aq)

Answer:

A

Explanation:

Answer:

I think It should be option A. It would have been B but, solar energy is not giving out, it's taken in

Answer:

the answer is salt because it has a uniform and definite composition

Explanation:

Answer:

O-H F-H N-Hy

Explanation:

C-H N-H O-H F-H

Answer:

Key Concepts

The hydrogen ion concentration in a solution, [H+], in mol L-1, can be calculated if the pH of the solution is known.

pH is defined as the negative logarithm (to base 10) of the hydrogen ion concentration in mol L-1 pH = -log10[H+] ...

[H+] in mol L-1 can be calculated using the equation (formula): [H+] = 10-pH

More items...

Explanation:

Answer:

[tex]pH = - log[H {}^{ + } ] \\ 6.5 = - log[H {}^{ + } ] \\ [H {}^{ + } ] = {10}^{ - 6.5} \\ [H {}^{ + } ] = 3.16 \times {10}^{ - 7} \: mol {dm}^{ - 3} [/tex]

Answer:

it would be option A

Explanation:

This is becuase if you look at the chart you can see tyhat the group of rats that got feed to vitamans did gain more wati then the ones on the normal diet.

Answer:

H2 and O2

Explanation:

A coffee cup calorimeter is basically a type of calorimeter that operates at constant pressure. The heat measured in the calorimeter is equal to the change in enthalpy of the reaction.

This type of calorimeter is apt for reactions involving solutions where there is little or no change in volume.

It is not generally applicable to gas phase reactions such as the reaction between H2 and O2.

Answer:

You will not measure the enthalpy of the reaction of

✔ H2 and O2

in the coffee cup calorimeter because this reaction involves gases. Instead, you will use a well-known published value.

C. H2 and O2

Is Correct

Answer:

D. Point into Leaf: water(H₂O), carbon dioxide (CO₂) sunlight, Point away from leaf: Sugars, oxygen (O₂)

Explanation:

Photosynthesis is the process used in the production of chemical energy in the form of energy containing organic compounds and oxygen from atmospheric carbon dioxide and liquid water enabled with the energy captured from light (mainly Sunlight) by the chlorophyll in green plants and other organisms

The basic chemical reaction involved in a photosynthesis reaction is presented as follows;

[tex]{}[/tex]                                    Sunlight

[tex]{}[/tex]                                          ↓

[tex]{}[/tex]       CO₂           +  H₂O (l)  →   C₆H₁₂O₆   +    O₂

Carbon dioxide [tex]{}[/tex]  Water        Glucose       Oxygen    

Answer:A

Explanation:

Option D. They all have extremely long half-lives makes radioisotopes useful for dating objects.

Radioisotopes exist as radioactive isotopes of an element. They can also be described as atoms that include an unstable combination of neutrons and protons, or surplus energy in their nucleus.

A radionuclide exists as a nuclide that contains excess nuclear energy, causing it unstable. This excess energy can be utilized in one of three methods: emitted from the nucleus as gamma radiation; assigned to one of its electrons to terminate it as a conversion electron; or utilized to create and emit a unique particle from the nucleus.

Radioactive isotopes of radium, thorium, and uranium, for example, exist found naturally in rocks and soil. Uranium and thorium also happen in trace amounts in water. Radon, induced by the radioactive decay of radium, stands present in the air.

Hence, Option D. They all have extremely long half-lives makes radioisotopes useful for dating objects.

To learn more about radioisotopes refer to:

https://brainly.com/question/18640165

#SPJ2

Answer:

That is, a pH meter is useful in detecting or knowing the acidity (due to ions) or alkalinity (due to ions) of a solution. Thus, we can conclude that out of the given options it is true about a pH meter that it can be used in any acid-base titration

Answer: D. It can be used in any acid-base titration.

Explanation:

Answer:

slope = 3

Explanation:

[tex]slope = \frac{3 - 0}{1 - 0} \\ = 3[/tex]

Answer:

B. Prepare solutions of different acid concentrations, measure 50 milliliters of each into different beakers, and place metal samples of different types but of the same mass into the beakers.

Explanation:

Since Michael is studying the factors that affect corrosion of metals, and wants to test the effect that different concentrations of an acid will have on the corrosion of a metal, using different acid concentrations of the same volume on different metal samples of the same size would give a much better than all the other options because, a standard volume of acid is used and also a standard mass of metal is used. So, the effect can be measured quantitatively since we have the same quantity of sample.

So, option B is the answer

Explanation:

just use the molar ratios to figure it out. Notice, you have to balance the chemical equation.

Answer:

Insulation reduces the exchange of heat through a surface such as a wall, attic, duct or roof. In a well-insulated home, less warm air escapes from the house during the winter, and less cool air escapes during the summer, reducing the amount of energy needed for heating and cooling

Answer:

THE answer is all of above

Explanation:

Answer:

The amount of heat required is 4681.6 J.

Explanation:

mass, m = 16 g = 0.016 kg

initial temperature, T = 5 C

final temperature, T' = 75 C

specific heat, c = 4.18 J/g C

The amount of heat required is

H = m c (T'- T)

H = 16 x 4.18 x (75 - 5)

H = 4681.6 J

Answer: The correct net ionic equation for the reaction is [tex]2H^{+}(aq)+2OH^{-}(aq)\rightarrow 2H_2O(l)[/tex]

Explanation:

Net ionic equation is defined as the equations in which spectator ions are not included.

Spectator ions are the ones that are present equally on the reactant and product sides. They do not participate in the reaction.  

The balanced molecular equation is:

[tex]Ca(OH)_2(aq)+H_2SO_4(aq)\rightarrow CaSO_4(aq)+2H_2O(l)[/tex]

The complete ionic equation follows:

[tex]Ca^{2+}(aq)+2OH^-(aq)+2H^+(aq)+SO_4^{2-}(aq)\rightarrow 2Ca^{2+}(aq)+SO_4^{2-}(aq)+H_2O(l)[/tex]

As calcium and sulfate ions are present on both sides of the reaction. Thus, they are considered spectator ions.

The net ionic equation follows:

[tex]2H^{+}(aq)+2OH^{-}(aq)\rightarrow 2H_2O(l)[/tex]

Hence, the correct net ionic equation for the reaction is [tex]2H^{+}(aq)+2OH^{-}(aq)\rightarrow 2H_2O(l)[/tex]

Answer:

B. no reaction     

Explanation:

Answer:

a helium nucleus emitted by some radioactive substances, originally regarded as a ray.

Explanation:

Answer:

They're charged particles Identical to the Helium Nucleus

Having 2 protons and 2neutrons and having a Mass of 4.

They're Heavy and slow(speed)In comparison to Beta particles and gamma rays

Usually Emitted from nucleus of radioactive nuclides during decay

Answer:

Percent Yield = 80%

Explanation:

Percent yield of a reaction is defined as one hundred times the ratio between the actual yield and the theoretical yield. That is:

Percent yield = Actual Yield / Theoretical Yield * 100

Where theoretical yield of CaHPO4 is 10g and actual yield is 8g

Replacing:

Percent yield = 8g / 10g * 100

Answer:

Just add a plenty of dots in the first one and very few dots in the second one

An area with high population density will have many dots while areas will low population density will have few dots when using dots to illustrate population density.

Population density is the ratio of the total number of organisms found in a given area to the total of the area of that place or habitat.

An area with high population density indicates that more organised ate found per unit area than an area with low population density.

Therefore, using dots to illustrate population density, an area with high population density will have plenty dots while areas will low population density will have few dots scattered over.

Learn more about population density at: https://brainly.com/question/13902749

Answer:

HFusion*mass + Spec.Heat*mass*ΔT + HVap*mass

80cal/g*50.0g + 1.00cal/g°C*50.0g*(100°C-0°C) + 540cal/g*50g

3.60x10⁵cal

Explanation:

Using the HFusion we can find the heat needed to convert the ice to liquid water.

With specific heat capacity we can find the heat needed to increase the temperature of water from 0 to 100°C.

With HVap we can find the heat to convert the liquid water into steam.

The equations are:

Computing the values:

36000cal =

Hola aquí va la respuesta!

Se fomentó la inmigración europea porque la economía no era buena y vinieron a Paraguay para mejorar su situación.

Hola aquí va la respuesta!

Se fomentó la inmigración europea porque la economía no era buena y vinieron a Paraguay para mejorar su situación.

Answer: The correct answer is heat will flow from the boiling water into the frozen metal.

Explanation:

According to the law of conservation of energy, energy cannot be destroyed nor created but it can be transformed from 1 form to another form.

There are 3 processes of heat transfer:

The heat moves from a hot surface to a cold surface to maintain equilibrium.

We are given:

A metal is placed in a freezer (cold object) and another metal is placed in an oven (hot object) and then both the metals are placed in boiling water.

Initially, the heat will flow from the boiling water (hot object) into the frozen metal (cold object) to maintain equilibrium

Hence, the correct answer is heat will flow from the boiling water into the frozen metal.

Answer:

B

Explanation:

)When iron rusts in air, iron(III) oxide is produced. How many moles of oxygen will react

with 2.4 mol of iron ?

B)1.8 mol

Answer:

Tetrahedral, sp3, p

Explanation:

C has 4 bonds and hence its tetrahedral shape with 109.5 degrees. since there are 4 bonds, it is sp3

Answer:

A carbon atom that is surrounded by four hydrogen atoms has a

✔ tetrahedral

molecular geometry.

This geometry results from the arrangement of the

✔ four sp3

hybrid orbitals around the carbon atom.

They are formed when the s-orbital and

✔ three p

-orbitals mix, or hybridize.

Explanation:

Explanation:

A substance burning in the presence of oxygen and leads to the formation of heat and light is called combustion.

Some important points about combustion are as follows: