A compound of a transition metal and iodine is 56.7% metal by mass.How many grams of the metal can be obtained from 630 g of this compound?

thermal contact

When heat flows from one object or substance to another it is in contact with, the objects or substances are said to be in thermal contact. The state where objects in thermal contact with each other reach the same temperature, no heat flows between them.

Answer:

The answer is c, Clouds fill with moisture and get too hravy

Answer:

0.9612 g

Explanation:

First we calculate how many moles are there in 3.00 g of CCl₃F, using its molar mass:

Now, we need to calculate how many grams of N₂O would have that same number of molecules, or in other words, the same amount of moles.

Thus we calculate how many grams would 0.0218 moles of N₂O weigh, using the molar mass of N₂O :

The  mass of dinitrogen monoxide is 0.9612 g

The number of  moles are there in 3.00 g of CCl₃F, using its molar mass:

= 3.00 g CCl₃F ÷ 137.37 g/mol

= 0.0218 mol CCl₃F

Now the mass should be

=[ 0.0218 mol N₂O ×  44.013 g/mol

= 0.9612 g N₂O

Learn more: https://brainly.com/question/5763151?referrer=searchResults

Answer:

i think the answer is c

Explanation:

collission

Answer:

C. are found in the nucleus of an atom

Explanation:

Protons and Neutrons are always located at the center of the atom also called as the nuclei of the atom and constitute nearly all the mass of the atom, while the electrons revolve around them in orbits called shells. Only protons have a positive charge and electrons have negative charges, due to which only protons and electrons attract each other, while neutrons lack charges or have 'Neutral Charges'.

Answer:

1. They will react.

2. 2HCI + Zn —> ZnCl2 + H2

Explanation:

1. From the question given above,

We can see that Zn is higher than H in the activity series.

NOTE: Elements higher (i.e at the top) in the activity series will displace those lower (i.e at the bottom) in the series. Thus, Zn is higher in the series than H. Therefore, Zn will displace H from solution. Hence, they will react.

2. The product obtained from the reaction can be seen as follow:

HCI + Zn —> ZnCl2 + H2

The above equation can be balance as follow:

There are 2 atoms of H on the right side and 1 atom on the left side. It can be balance by putting 2 in front of HCl as shown below:

2HCI + Zn —> ZnCl2 + H2

Answer:

Molarity = 0.3 M

Explanation:

Given data:

Moles of NaOH = 0.720 mol

Volume of water = 2.40 L

Molarity = ?

Solution:

Molarity is used to describe the concentration of solution. It tells how many moles are dissolve in per litter of solution.

Formula:

Molarity = number of moles of solute / L of solution

Molarity = 0.720 mol / 2.40 L

Molarity = 0.3 mol/L

Molarity = 0.3 M

Answer:

i not sure but i searched it up and it said Q=104525J

Explanation:

The characteristic that could distinguish a crystalline solid from an amorphous solid is option b. The way it breaks.

Crystalline solids contained edges and faces, that should be diffracted x-rays, and have sharp melting points.

While on the other hand, amorphous solids should contain irregular does not provide well-resolved x-ray diffraction patterns.

hence, the option b is correct.

And, the rest of the options are wrong.

Learn more about solid here: https://brainly.com/question/17435895

Answer:

the final temperature is 465.2k

Answer:

dunno

Explanation:

Answer:

A.) trans-2,3-dichloro-5-methyl-2-hexene

Explanation:

The proposed question and structure has been attached to this answer.

The cis- and trans- isomers are used to denote the alignment of the functional groups to the carbon chain side. From the diagram, we see that:

Hence the name trans-2,3-dichloro-5-methyl-2-hexene

Answer:

377mL is the volume of the solution

Explanation:

A 0.140M solution of CuNO₃ contains 0.140 moles of CuNO₃ per liter of solution. Thus, we need to convert first the mass of CuNO₃ to moles using its molar mass and, with the moles available, we can find the volume of the solution, thus:

Moles CuNO₃ -Molar mass: 125.55g/mol:

6.63g * (1mol / 125.55g) = 0.0528 moles of CuNO₃.

Volume of solution:

0.0528 moles of CuNO₃ * (1L / 0.140 moles CuNO₃) = 0.377L

0.377L * (1000mL / 1L) =

One major characteristic they have in common is they are metals.

Answer:

the Product

Explanation:

Answer:

True. Hope this helps. :)

Answer:

carbon mono oxide CO

Explanation:

as both are in 1:1 ratio so CO is formed

Answer:

PCl3 - trigonal pyramidal <109 degrees

SCl2 - bent<109 degrees

SiF4 - tetrahedral 109 degrees

Explanation:

The shape of all three molecules derive from a tetrahedral arrangement of electron pairs.

However, in PCl3 there is a lone pair of electrons on P and three bond pairs. This leads to the observance of a trigonal pyramidal geometry with bond angle <109 degrees.

In SCl2, there are four regions of electron density around S, two lone pairs and two bond pairs leading to a bent molecular geometry with bond angle <109 degrees.

In SiF4, there are four bond pairs and no lone pair. The molecular geometry is tetrahedral with a bond angle of 109 degrees.

Hi there! :)

[tex]\large\boxed{x = 2.49 L}[/tex]

Use the proportion for Charles' Law where:

[tex]\frac{v_{1}}{t_{1}}= \frac{v_{2}}{t_{2}}[/tex]

v1 = initial volume

t1 = initial temperature

v2 = final volume

v2 = final temperature

Substitute in the given values into the proportion:

v1 = 4.39 L

t1 = 44° C

t2 = 25°C

v2 = x L

Set up the proportion:

[tex]\frac{4.39}{44} = \frac{x}{25}[/tex]

Cross multiply:

[tex]25 * 4.39 = 44x\\\\109.75 = 44x\\\\x = 2.49 L[/tex]

Answer:

The new volume will be approximately 2.49 L.

Explanation:

We are given that a gas sample occupies 4.39 L at 44° C.

We are also given that we are going decrease the temperature to 25° C.

Charles' Law has a formula which shows the relationship between the volumes of a samples and the temperatures of the samples.

The proportion is shown as:

[tex]\displaystyle \bullet \ \ \ \frac{V_1}{T_1} = \frac{V_2}{T_2}[/tex],

where V₁ and V₂ are the initial and final volume respectively and T₁ and T₂ are the initial and final temperature respectively.

This proportion can be used to determine what our unknown is. We need to know the final volume.

[tex]\displaystyle \frac{4.39 \ \text{L}}{44 \ \text{C}} = \frac{\text{x}}{25 \ \text{C}}\\\\\\\frac{4.39}{44} = \frac{x}{25}\\\\\\4.39 \times 25 = 44 \times x\\\\\\44x = 109.75\\\\\\\frac{44x}{44}=\frac{109.75}{44}\\\\\\x = 2.49432 \approx \boxed{2.49 \ \text{L}}[/tex]

Therefore, if we reduce the temperature to 25 °C, we will be reducing the volume of the substance to 2.49 L.

Answer:

253.5mL of Ba(OH)₂ are required to neutralize the HCl solution

The pH at equivalence point is = 7

Explanation:

The reaction of Ba(OH)₂ with HCl is:

Ba(OH)₂ + 2HCl → BaCl₂ + 2H₂O

First, we need to find moles of HCl. With these moles and the chemical equation we can find the moles of Ba(OH)₂ and the volume required:

Moles HCl:

75.0mL = 0.075L * (0.845mol / 1L) = 0.063375moles HCl

Moles Ba(OH)₂:

0.06338moles HCl * (1mol Ba(OH)₂ / 2mol HCl) = 0.03169 moles Ba(OH)₂

Volume of the 0.125M Ba(OH)₂:

0.03169 moles Ba(OH)₂ * (1L / 0.125mol) = 0.2535L are required =

253.5mL of Ba(OH)₂ are required to neutralize the HCl solution

As the titration was of a strong acid, HCl, with a strong base, Ba(OH)₂, the pH at equivalence point is = 7

Answer:

Option C. 4.03 g

Explanation:

Firstly we analyse data.

12 % by mass, is a sort of concentration. It indicates that in 100 g of SOLUTION, we have 12 g of SOLUTE.

Density is the data that indicates grams of solution in volume of solution.

We need to determine, the volume of solution for the concentration

Density = mass / volume

1.05 g/mL = 100 g / volume

Volume =  100 g / 1.05 g/mL → 95.24 mL

Therefore our 12 g of solute are contained in 95.24 mL

Let's finish this by a rule of three.

95.24 mL contain 12 g of sucrose

Our sample of 32 mL may contain ( 32 . 12) / 95.24 = 4.03 g

Answer:

Mg and HCI

Explanation:

The combination that she uses to produce hydrogen gas is:

d. Mg and HCl(Magnesium and Hydrochloric acid)

When magnesium reacts with Hydrochloric acid, It leads to the formation of Magnesium chloride as a salt, and hydrogen gas is liberated.

[tex]Mg+2HCl--- > MgCl_2+H_2[/tex]

When a metal reacts with an acid, it leads to the liberation of hydrogen gas and the production of their respective salt.

Thus, option d is correct.

Find more information about Hydrogen gas here:

brainly.com/question/25597694

Answer:

3.68 g/cm3

Explanation:

D = M / V

350 / 95

Answer: In the case of water, we know that the O-H covalent bond is polar, due to the different electronegativities of hydrogen and oxygen. Since there are two O-H bonds in water, their bond dipoles will interact and may result in a molecular dipole which can be measured.

Explanation:

Answer:

2.41 * 10^24 atoms of carbon present in the products.

Explanation:

First, we need to find the moles of carbon in the products in order to find the number of atoms.

We see that in the chemical formula, carbon belongs to the compound known as glucose. To get the amount of moles of carbon, we need to divide my the amount of carbon within glucose (in grams) from the total amu ( or grams) of glucose to get the moles.

C6 = 72.066.

C6H12O6 = 180.156

72.066/180.156 = 0.4000199827 moles of Carbon within the Glucose compound

Now we will convert to atoms/molecules by multiplying the moles by avogadro's number..

0.4000199827 moles C * 6.022*[tex]10^{23}[/tex] = 2.408920336 *[tex]10^{24}[/tex] atoms of Carbon present in the products

*Note --> this can be estimated to 2.41 * [tex]10^{24}[/tex] atoms of Carbon

Answer:

P4O10

Explanation: