A wooden barrel full of water has a flat circular top of radius 25.0 cm with a small hole in it. A tube of height 8.00 m and inner radius 0.582 cm is suspended above the barrel with its lower end inserted snugly in the hole. Water is poured into the upper end of the tube until it is full. The density of water is 1.00 × 103 kg/m3.
What is the force with which the water in the barrel pushes up on the top of the barrel?

Answer:

Moses had told them to not keep the food till morning but some kept some anyways because they probably thought they were going to starve or not have food the next morning but what I think it means is that you have to trust in God that he will provide for you and so when the people kept the food cuz he thought they were probably going to start of the next day it got maggots

Answer:

30.3 meters, 172 degrees

Explanation:

To insure the most accurate solution, this problem is best solved using a calculator and trigonometric principles. The first step is to determine the sum of all the horizontal (east-west) displacements and the sum of all the vertical (north-south) displacements.

Horizontal: 2.0 meters, West + 31.0 meters, West + 3.0 meters, East = 30.0 meters, West

Vertical: 12.0 meters, North + 8.0 meters, South = 4.0 meters, North

The series of five displacements is equivalent to two displacements of 30 meters, West and 4 meters, North. The resultant of these two displacements can be found using the Pythagorean theorem (for the magnitude) and the tangent function (for the direction). A non-scaled sketch is useful for visualizing the situation.

Applying the Pythagorean theorem leads to the magnitude of the resultant (R).

R2 = (30.0 m)2 + (4.0 m)2 = 916 m2

R = Sqrt(916 m2)

R = 30.3 meters

The angle theta in the diagram above can be found using the tangent function.

tangent(theta) = opposite/adjacent = (4.0 m) / (30.0 m)

tangent(theta) = 0.1333

theta = invtan(0.1333)

theta = 7.59 degrees

This angle theta is the angle between west and the resultant. Directions of vectors are expressed as the counterclockwise angle of rotation relative to east. So the direction is 7.59 degrees short of 180 degrees. That is, the direction is ~172 degrees.

Answer:

Ganymede is the largest body

Explanation:

it is the satellite of jupiter

Answer:

d

Explanation:

A dreams

.......wkkwkwkwkwkwnwnsksk

Answer:

C. short term goal

Explanation:

took a midterm quiz on canvas, Hope this helps <3

Answer:

  1.5 m/s

Explanation:

Conservation of momentum means the momentum of the system before the collision is the same as after.

The before, after momentum of each ball is ...

  5 kg ball: (5 kg)(2 m/s), (5 kg)(-1 m/s)

  10 kg ball: (10 kg)(0 m/s), (10 kg)(v)

The sum of the "before" products is the same as the sum of the "after" products:

  (5 kg)(2 m/s) +0 = (5 kg)(-1 m/s) +(10 kg)v

  (10 +5) kg·m/s = (10 kg)·v . . . . . add (5 kg)(1 m/s) to both sides

  v = (15 kg·m/s)/(10 kg) = 1.5 m/s

The speed of the larger ball will be 1.5 m/s. Its direction of motion will be the opposite of that of the 5 kg ball after the collision.

Este problema está describiendo una turbina de vapor a la que entra vapor a 30 kg/s, 6.205 kPa y 811 K con una velocidad de 10 m/s y sale a 9.859 kPa, 318.8 K y con una velocidad de 200 m/s. Adicionalmente, tanto el volumen específico como la energía interna son dados para ambas corrientes.

Con lo anterior, resulta posible escribir un balance de energía para esta turbina, despreciando todo efecto por energía potencial ya que no hay diferencia significativa entre la altura de la entrada (1) y la salida (2), pues están practicamente al mismo nivel:

[tex]mh_1+\frac{1}{2} mv^2_1=mh_2+\frac{1}{2} mv^2_2+Q_2+W_2[/tex]

Aquí vemos que la incógnita es [tex]W_2[/tex] como la potencia que produce la turbina. Ahora, el primer cáculo a realizar es el de las entalpías de las corrientes de entrada y salida, dada la energía interna, presión y volumen específico:

[tex]h_1=3150.3\frac{kJ}{kg}+6205kPa*0.05789\frac{m^3}{kg} =3509.51\frac{kJ}{kg}\\\\h_2=2211.8\frac{kJ}{kg}+9.859kPa*13.36\frac{m^3}{kg} =2342.72\frac{kJ}{kg}[/tex]

Ahora, podemos reacomodar el balance de energía con el fin de resolver [tex]W_2[/tex]:

[tex]W_2=m(h_1-h_2)+\frac{1}{2} m(v^2_1-v^2_2)-Q_2[/tex]

Finalmente, reemplazamos los valores para obtener:

[tex]W_2=10\frac{kg}{s} (3509.51-2342.72)\frac{kJ}{kg} +\frac{1}{2} *10\frac{kg}{s} [(10\frac{m}{s}) ^2-(200\frac{m}{s} )^2]*\frac{1kJ}{1000J} -30\frac{kJ}{s}\\\\W_2=11438.4 kJ/s=11438.4kW[/tex]

Es de precisar que la energía cinética como 1/2 m*v² resulta en Joules, por lo que hay que convertir a kilojoules para tener unidades consistentes de kilowatts al final.

Aprende más:

No,the poping of microvave is not same there time is different

Answer:

The answer should be 3-At sunset blue light is scattered by air molecules at higher altitudes. The longer red and yellow wavelengths must travel further through the atmosphere when the Sun is near the horizon. At some point the reds and yellows finally scatter in the lower atmosphere causing the reds and yellows.

Answer:

3. At sunset blue light is scattered by air molecules at higher altitudes. The longer red and yellow wavelengths must travel further through the atmosphere when the Sun is near the horizon. At some point the reds and yellows finally scatter in the lower atmosphere causing the reds and yellows.

Answer:

Torque = 50N x 0.3m = 15Nm

Explanation:

Torque = Force x length of lever arm. To obtain the torque simply multiply the two given values.

Explanation:

I'm not sure, but I would go for the more than A since its orbital speed is at its fastest and the sweep occurs in about the same period of days.

Machine translators:

Level of accuracy can be very low.

Accuracy is also very inconsistent across different languages.

Machines can't translate context.

Mistakes are sometimes costly.

Sometimes translation simply doesn't work.

Human translators:

Turnaround time is longer.

Translators rarely work for free.

Unless you use a translation agency, with access to thousands of translators, you're limited to the languages any one translator can work with.

The maximum magnitude of the friction force exerted on the box by the ramp is 44.41 N.

The given parameters;

The normal force on the wooden box is calculated as follows;

[tex]F_n = mg \times cos(\theta)\\\\F_n = 10 \times 9.8 \times cos(25)\\\\F_n = 88.8 2 \ N[/tex]

The maximum magnitude of the friction force exerted on the box by the ramp is calculated as follows;

[tex]F_f = \mu \times F_n\\\\F_f = 0.5 \times 88.82 \\\\F_f = 44.41 \ N[/tex]

Learn more about static frictional forces here: https://brainly.com/question/4515354

Answer:

False

Explanation:

This is because the work is the same so the force won't change

Answer:

Increases with increase in mass

Explanation:

gravity is proportional to mass and inversely proportional to the square of the distance between them

F = GMm/d²

Answer:

False

Explanation:

A wave is a disturbance that transfers energy from one place to another without transferring matter.

Answer:

I'm pretty sure it true sorry if I'm wrong

Answer:

Our eyes are most sensitive to the wavelengths corresponding to the yellow and green colors of the spectrum. Flashy signs and some fire engines are painted in a yellowish-green color to attract our attention.

Answer:

First aid refers to the emergency or immediate care you should provide when a person is injured or ill until full medical treatment is available.

Explanation:

Ryder is testing the change in motion for an object that weighs 25 kg and an object that weighs 30 kg. Then, the greater change in motion is due to the greater mass of the object, and the object will have a greater change of motion. Thus, the correct option is C.

Motion is the phenomenon in which an object changes its position with respect to the time taken. Motion of an object is mathematically described in terms of the displacement covered by the object, the distance, velocity, acceleration, speed and the frame of reference to an observer and measurement of the change in the position of the body of an object relative to that particular frame with the change in time taken.

The motion of an object is proportional to the mass of the object. The mass is greater in this case, and therefore the objects will have a greater change of motion.

Therefore, the correct option is C.

Learn more about Motion here:

https://brainly.com/question/22810476

#SPJ1

Answer:

P1 = 1.3 (500 + 60) = 728 kg-m      total momentum to right at start

P2 = (v2 - 10) 60 + 500 v2

total momentum after running at -10 with respect to cart = 728 where v2 is the new speed of the cart

728 = 560 v2 - 600

v2 = 1328 / 560 = 2.37 m/s    new speed of cart

Check:

After:    p2 for cart = 500 * 2.37 = 1186

p1 for man = (2.37 - 10) * 60 = -458

P2 = p1 + p2 = 728       total momentum unchanged

Answer:

Ok thanks for the points though

Explanation:

Consult the attached free body diagram. The only forces doing work on the wagon are the frictional force opposing the wagon's motion and the horizontal component of the applied force.

By Newton's second law, the net vertical force is

• ∑ F [v] = n + (80.0 N) sin(30.0°) - mg = 0

where a is the acceleration of the wagon.

Solve for n (the magnitude of the normal force) :

n = (10.0 kg) g - (80.0 N) sin(30.0°) = 58.0 N

Then

f = 0.500 (58.0 N) = 29.0 N

Meanwhile, the horizontal component of the applied force has magnitude

(80.0 N) cos(30.0°) ≈ 69.3 N

Now calculate the work done by either force.

• friction: -(29.0 N) (10.0 m) = -290. J

• pull: (69.3 N) (10.0 m) = 693 J

Answer:

Avoid heavy strenuous exercise for the 24 hours prior to testing. Do not exercise at all on the day of testing to ensure you are well rested. Wear appropriate clothing for the conditions (e.g. shorts/track pants and t-shirt/singlet/sports top) and non-slip athletic footwear with laces securely fastened