calculate the number of atoms in 1g of calciumj​

Answer:

62.5 moles of O₂.

Explanation:

We'll begin by writing the balanced equation for the reaction. This is illustrated below:

2C₈H₁₈ + 25O₂ —> 16CO₂ + 18H₂O

From the balanced equation above,

2 moles of C₈H₁₈ reacted with 25 moles of O₂.

Finally, we shall determine the number of mole of O₂ needed to react with 5 moles of C₈H₁₈. This can be obtained as shown below:

From the balanced equation above,

2 moles of C₈H₁₈ reacted with 25 moles of O₂.

Therefore, 5 moles of C₈H₁₈ will react with = (5 × 25) / 2 = 62.5 moles of O₂.

Thus, 62.5 moles of O₂ is needed for the reaction.

Answer:

of what grade it is of??

Explanation:

tell me then ill answer

Solution :

Cd(s) ---------------------->  [tex]Cd^{+2}[/tex] (aq) + 2[tex]e^-[/tex]      ,     [tex]E_0[/tex]  =   0.34 v

[tex]Cu^{+2}[/tex]  (aq)  +   2[tex]e^-[/tex]  ------------> Cu (s)             ,     [tex]E_0[/tex]  =  -0.04 v

----------------------------------------------------------------------------------------------

Cd(s)  +  [tex]Cu^{+2}[/tex]  (aq)  ------------->  [tex]Cd^{+2}[/tex] (aq)  +  Cu (s)   ,      [tex]E_0[/tex]  =  0.30 v  

The cell potential is defined as the measure of [tex]\text{ potential difference }[/tex]  between the [tex]\text{two half cells}[/tex] of an electrochemical cell.  

Answer:

36 electrons

Explanation:

But Bromine anion with a charge of -1 has one extra electron so 35 +1 = 36 electrons.

Answer:

sodium bicarbonate solution

Explanation:

here's the answer to your question

Utilizing a database search would be most effective for obtaining the data related to registered voters. The Option D.

A database search proves invaluable when seeking to retrieve specific information such as the total number of registered voters in a country. By querying the database with the appropriate parameters, you can efficiently extract accurate and up-to-date voter registration figures.

This method streamlines data collection by ensuring accuracy and reducing the potential for errors associated with manual collection processes.

Read more about database

brainly.com/question/518894

#SPJ1

Answer: The given amount of [tex]Cd(NO_3)_2.4H_2O[/tex] contains 0.430 moles of Cd, 0.860 moles of N and [tex]2.59\times 10^{23}[/tex] molecules of water.

Explanation:

The number of moles is defined as the ratio of the mass of a substance to its molar mass. The equation used is:

[tex]\text{Number of moles}=\frac{\text{Given mass}}{\text{Molar mass}}[/tex] ......(1)

Given mass of [tex]Cd(NO_3)_2.4H_2O[/tex] = 132.4 g

Molar mass of [tex]Cd(NO_3)_2.4H_2O[/tex] = 308.5 g/mol

Plugging values in equation 1:

[tex]\text{Moles of }Cd(NO_3)_2.4H_2O=\frac{132.4g}{308.5g/mol}=0.430 mol[/tex]

1 mole of [tex]Cd(NO_3)_2.4H_2O[/tex] contains 1 mole of Cd, 2 moles of nitrogen atom (N), 10 moles of oxygen atom (O) and 8 moles of hydrogen atom (H).

So, 0.430 moles of [tex]Cd(NO_3)_2.4H_2O[/tex] will contain = [tex](1\times 0.430) = 0.430mol[/tex] of Cd and [tex](2\times 0.430)=0.86mol[/tex] of N

According to the mole concept:

1 mole of a compound contains [tex]6.022\times 10^{23}[/tex] number of molecules

So, 0.430 moles of [tex]Cd(NO_3)_2.4H_2O[/tex] will contain = [tex]\frac{6.022\times 10^{23}}{1mol}\times 0.430mol=2.59\times 10^{23}[/tex] number of water molecules.

Hence, the given amount of [tex]Cd(NO_3)_2.4H_2O[/tex] contains 0.430 moles of Cd, 0.860 moles of N and [tex]2.59\times 10^{23}[/tex] molecules of water.

Answer:

A. Nucleotide

Explanation:

Nucleotides are the monomers that make up nucleic acids, such as DNA and RNA.

Answer:

Starch solution

Explanation:

Colloidal solutions show tyndall effect and starch solution is a colloidal solution.

Answer:

C6H12O6+6O2--->6CO2+6H2O

Explanation:

So I went through all the answers and could not find the right one amongst. If I'm not wrong the reaction above is the reaction for respiration. The nearest answer is D but unfortunately the first reactant isn't in accordance with that which the question has given.

Answer:

None

Explanation:

Methylene is an organic compound and organic compounds consist of hydrogen atoms and Carbon atoms in n this case Methylene(CH2) has one carbon and two hydrogens .

Answer: methylene doesn't contain CL(chlorine) atoms

Explanation: the chemical formulae for Methylene is CH2

which means it contains only carbon and hydrogen atoms which is 1(one) carbon 2(two)hydrogen atoms

HOPE THIS HELPS!!

Answer:

2

5

3

Which of the following statements best explains the trends in boiling points?

A. The atomic size increases down the group, and this decreases the strength of the intermolecular forces.

                                           A is incorrect

B. The total number of electrons decreases down the group, and this decreases the strength of the intermolecular forces.

                                            B is incorrect

C. The total number of electrons increases down the group, and this increases the strength of the intermolecular forces.

                                             C is correct

D. The chances of forming a permanent dipole increases down the group, and this increases the strength of the intermolecular forces.

                                              D is incorrect

The boiling point increase down a group because the total number of electrons increases down the group, and this increases the strength of the intermolecular forces. Hence option C is correct.

Boiling point of a substance is the temperature at which the substance changes from its liquid state to vapour state. Boiling point of a molecule or compounds depends on the bond type, molecular weight, temperature and pressure.

For ionic compounds, boiling point will be higher since ionic bonds are stronger than covalent compounds. There is a periodic trend for the physical properties such as boiling point for elements in periodic table.

Down a group, the number of electrons increases and the atomic size also as well as the ionic character increases down a group . These two facts leads to higher intermolecular attraction, thus more temperature have to applied to weaken the bonds.

Higher temperature to be applied means the boiling point of the substance is higher. Therefore, boiling point down a group increases because of the higher intermolecular attraction as said in option C.

To find more about boiling point, refer the link below:

https://brainly.com/question/2153588

#SPJ1

Answer:

thats pink floyds album cover LOL

but the answer is to prism

hope this helps :)

Answer:

The composition of air can be determined by an experiment which includes passing a known volume of air, measured at a known temperature and pressure, over sufficient amount heated copper granules/powder, and measuring the volume gas remaining after the gas cools down to the temperature at which the first measurement was taken

Oxygen reacts with copper according to the following chemical reaction

2Cu (s) + O₂ (g) → 2CuO (s)

Cupper does not react with the other constituents of air

Whereby the initial volume of air was 100 cm³, we have;

Percentage of oxygen in air = 100 - The final volume reading of the container initially holding the air

When done using am appropriate experimental setup, the percentage of gases remaining equals 79% to 80%, therefore, the percentage composition of oxygen in air is between 20 and 21 percent

Explanation:

Answer:

This is true.

Explanation:

R should be 0.0821

Good luck!

Explanation:

Your search - What is the answer to 9.7300x10^2+9.8700x 10^3 1.0843x 10^ in scientific notation - did not match any documents.

Suggestions:

Make sure that all words are spelled correctly.

Try different keywords.

Try more general keywords.

Try fewer keywords.

Answer:

a. 1 x 10^-35

Explanation:

The correct compound given is: [tex]\mathsf{Cu_3(AsO_4)}_2[/tex]

To predict the approximate Ksp value of the given compound, we will need to express the oxidation-reduction half-reaction of the compound and its dissociation, then, we will use the Nernst equation to determine the approximate Ksp value.

To start with the reduction half-reaction:

[tex]\mathsf{Cu_3(AsO_4)_{2}(s) + 6e^- \to 2As O_{4}^{3-}_{(aq)}+3Cu(s) }[/tex]

The oxidation half-reaction is:

[tex]\mathsf{3Cu(s) \to 3CU^{2+}_{(aq)} + 6e^-}[/tex]

The overall cell reaction now is:

[tex]\mathsf{Cu_3(AsO_4)_{2}(s) \to 3Cu^+ (aq) + 2As O_{4}^{3-}_{(aq)} }[/tex]

From the reduction half-reduction, the number of moles of electrons (n) transferred is 6 moles.

By applying the Nernst equation:

[tex]\mathsf{E_{cell} = E^0_{cell} -\dfrac{0.0591V}{n}log [Cu^{2+}]^3[AsO_4^{3-}]^2 }[/tex]

At standard conditions;

The standard cell potential [tex]\mathsf{E^0_{cell} = -0.342 \ V}[/tex]

and [tex]\mathsf{E_{cell} = 0 \ V}[/tex] since it is at equilibrium.

∴

[tex]\mathsf{0 = -0.342 -\dfrac{0.0591V}{6}log [Cu^{2+}]^3[AsO_4^{3-}]^2 } \\ \\ \\ \mathsf{0.342 = -\dfrac{0.0591V}{6}log [Cu^{2+}]^3[AsO_4^{3-}]^2 }[/tex]

[tex]\mathsf{log [Cu^{2+}]^3[AsO_4^{3-}]^2 = \dfrac{-(0.342)*6}{0.0591 }}[/tex]

[tex]\mathsf{log [Cu^{2+}]^3[AsO_4^{3-}]^2 = -34.7}[/tex]

[tex]\mathsf{log [Cu^{2+}]^3[AsO_4^{3-}]^2 \simeq -35}[/tex]

[tex]\mathsf{[Cu^{2+}]^3[AsO_4^{3-}]^2 = 10^{-35}}[/tex]

[tex]\mathbf{K_{sp} = [Cu^{2+}]^3[AsO_4^{3-}]^2 = 1\times 10^{-35}}[/tex]

Answer:

Not all plants do need soil to grow

Explanation:

Not all plants need soil to grow. Some just do better in soil compared to other growing mediums. What plants need are minerals and nutrients, such as nitrogen, potassium, and phosphorous. Soil is an effective way of delivering those nutrients cost-effectively. You can also use alternative delivery systems like hydroponics, aeroponics, and aquaponics to achieve the desired effect. However, these are only suitable for growing shallow-rooted plants. Plants with deep roots will always need soil, as will larger plants with spreading roots.

Explanation:

a unit of mass used to express atomic and molecular weights, equal to one twelfth of the mass of an atom of carbon-12.

Answer:

Atomic Mass Unit is also called Dalton. It is used to express atomic and molecular weight. It is defined as 1/12 of the mass of an unbound neutral atom of carbon.

Answer:

Some examples of solutions are salt water, rubbing alcohol, and sugar dissolved in water. ... In our example of salt water, the solute is the salt. Solvent: this is the substance that makes up the majority of the solution. This is the part where the solute is dissolved.

Explanation:

I hope they should be right answer

Answer:

the group with helium at the top

Explanation:

I just took it

Answer:

Plastic pollution are harmful on land because;

The scientific question related to the game of basketball is option D: "Do teams that practice more win more games?"

This question is scientific because it explores a cause-and-effect relationship between practice and game outcomes. It can be investigated through empirical observation and data analysis.

To answer this question, researchers could collect data on the practice hours of different basketball teams and compare them to their corresponding game performance. Statistical analysis could be used to determine if there is a correlation between practice time and winning percentage or other performance metrics.

By examining a large sample of teams over an extended period, researchers could draw conclusions about the impact of practice on game outcomes. This scientific inquiry would contribute to the understanding of the factors that influence team success in basketball and could potentially inform training strategies and coaching techniques.

For more question on basketball

https://brainly.com/question/29505871

#SPJ8

Answer:

Answer: Atoms of chlorine (CI) and magnesium (Mg)

Answer: Atoms of chlorine (CI) and magnesium (Mg)is your answer

Answer:

Soda all start with watered down corn syrup. To get the carbonation companies have different ways of doing this all of which are very different. The last step is to add artificial and natural flavors like lemon and lime, this is also the step in which sugar and preservatives are added.

Explanation:

I hope this answer your question, srry I couldn't go into detail.