Consider reaction AgCIO3(aq)+Mgl2(aq)

Answer:

because atoms is just a chemical ahahahah

Explanation:

hope it helps ☺️

Dalton's hypothesis of atomic theory was given by John Dalton. The atoms of one element are the same as another and are not part of Dalton. Thus, option E is correct.

Dalton gave the atomic theory where atoms are the fundamental unit of the element of the periodic table. More than one element and atoms combine to form molecules and compounds.

The property of the atoms to get rearranged is the basis of the chemical reaction that results in the formation of the new product. This resulted in the formulation of chemical combinations. The atoms of the given element are said to be the same like the potassium contains the same atom.

The atoms of one element cannot be the same as another atom, like the atom of sodium and chloride are not the same. They are different in physical and chemical properties.

These atoms follow the law of conservation of mass. The atoms are composed of sub-atomic particles that have been constituted of neutrons, electrons, and protons.

Therefore, in option E. the atoms of two elements can never be the same.

Learn more about Dalton's theory, here:

https://brainly.com/question/15507302

#SPJ2

Answer:

Percentage of carbon:

[tex] { \tt{ = \frac{24}{30} \times 100\%}} \\ = 80\%[/tex]

Percentage of hydrogen:

[tex]{ \tt{ = \frac{6}{30} \times 100\%} } \\ = 20\%[/tex]

Answer:

See explanation

Explanation:

All molecules possess the London dispersion forces. However London dispersion forces is the only kind of intermolecular interaction that exists in nonpolar substances.

So, the only kind of intermolecular interaction that exists in dimethyl ether is London dispersion forces.

As for ethyl alcohol, the molecule is polar due to the presence of polar O-H bond. In addition to London dispersion forces, dipole-dipole interactions and specifically hydrogen bonding also occurs between the molecules.

Because ethyl alcohol is polar, it is more soluble in water than dimethyl ether.

Answer:

The answer is "It takes 1,70 mol of ethanol".

Explanation:

To make acetic acid, we must first write the balanced reaction that occurs of ethanol with oxygen

The response is balanced:

[tex]CH_3CH_2OH+O_2\to CH_3COOH+H_2O[/tex]

1 mol of ethanol creates 1 mol of According the equilibrium Ethanol moles, therefore, required 1.70 mol of water = 1.70 mol

Answer:

The less electronegative atom

Explanation:

Water contains polar bonds. Water is made up of oxygen and hydrogen. Oxygen is more electronegative then hydrogen so it is partial negative (because electron spend more time around oxygen in the polar bond), whereas, hydrogen has a  partial positive charge as it is less electronegative (electrons spend less time around hydrogen in this polar bond).

Answer: At equilibrium, the partial pressure of [tex]PCl_{3}[/tex] is 0.0330 atm.

Explanation:

The partial pressure of [tex]PCl_{3}[/tex] is equal to the partial pressure of [tex]Cl_{2}[/tex]. Hence, let us assume that x quantity of [tex]PCl_{5}[/tex] is decomposed and gives x quantity of [tex]PCl_{3}[/tex] and x quantity of [tex]Cl_{2}[/tex].

Therefore, at equilibrium the species along with their partial pressures are as follows.

                         [tex]PCl_{5}(g) \rightarrow PCl_{3}(g) + Cl_{2}(g)\\[/tex]

At equilibrium:  0.123-x          x              x

Now, expression for [tex]K_{p}[/tex] of this reaction is as follows.

[tex]K_{p} = \frac{[PCl_{3}][Cl_{2}]}{[PCl_{5}]}\\0.0121 = \frac{x \times x}{(0.123 - x)}\\x = 0.0330[/tex]

Thus, we can conclude that at equilibrium, the partial pressure of [tex]PCl_{3}[/tex] is 0.0330 atm.

The direction of heat flow is increased which means blocks temperature is higher and hotter than it was before

Answer:

it might reach to 4g per L

Sodium metal reacts rapidly with water to form a solution of sodium hydroxide (NaOH) and hydrogen gas (H2). This reaction is exothermic.

Equation:

2Na + 2H²0 --------}- 2NaOH + H²

Answer:

BF3

Explanation:

The octet rule describes atoms' preference and affinity for having eight (8) electrons in their valence shell. Whenever an atom is encircled by eight(8) electrons, it forms a stable configuration. This octet can be composed of its' own electrons as well as some shared electrons. In the periodic table, only the s-block and p-block electrons are considered for the octet rule.

However, out of the given option, only BF3 does not comply with the octet rule: This is because the Bromine contains 2 lone pairs of electrons and 3 other shared bonded pairs of electrons with Flourine making a total of 10 electrons in the valence shell and which does not conform with the octet rule.

Answer:

jjjjjjjjj

Explanation:

hhhhhhhhhhh

Answer:

True I think

hope this helps

Answer:

true

Explanation:

because it reacts with the water molecules by giving a proton to them

Answer:

D: Increasing temperature

Explanation:

From collision theory, we know that the more the increase in collisions, the faster the rate of the chemical reaction.

Now, the amount of solid solute in a solvent will change with a corresponding change in temperature. What we mean is that, the higher the temperature increases, the higher the number of collisions between the solvent molecules as well as leading to an increase in the solute particles which will mean an increase in the amount of the solid solute dissolved. The correct answer is option D.

Answer:

Increasing temperature.

Explanation:

Answer: A molecule contains hydrogen bonding if it contains hydrogen covalently bonded to (fluorine, oxygen, or nitrogen)

Explanation:

A hydrogen bond is a strong dipole-dipole attraction which occurs between

--> the hydrogen atom attached to a strongly electronegative atom, and

--> another strongly electronegative atom with a lone pair of electrons.

When an electronegative atom such as fluorine, oxygen or Nitrogen is bonded to hydrogen, a dipole develops causing the hydrogen to be partially negative. The electrostatic attraction between the partially positive hydrogen atom in one molecule and the partially negative atom of the more electronegative element in another molecule gives rise to the strong dipole-dipole attraction called hydrogen bonding.

Hydrogen fluoride, water and ammonia contain the three most electronegative elements, fluorine, oxygen and nitrogen respectively, linked directly to hydrogen. In addition, lone pairs of electrons are present in the fluorine, oxygen and nitrogen atoms of the three hydrides, making hydrogen bonds to form easily between them. These compounds which exhibits hydrogen bonding always have higher melting and boiling points.

Answer:

Balance the following reactions and identify the species that have been oxidized and the species that have been reduced.

CL2 +I- -------------> I2 +CL-

WO2 + H2 ---------------> W + H2O

CA + H2O -----------------> H2 + CA(OH)2

AL+ O2 --------------------> AL2O3

Explanation:

Oxidation is the process where an atom loses electrons.

During oxidation, the oxidation number of the atom increases.

Reduction is the process where an atom gains electrons.

During reduction, the oxidation number of the atom decreases.

The balanced chemical equations for the given reactions are shown below:

[tex]Cl_2 +2I^- -> I_2 + 2Cl^-[/tex]

Iodine undergoes oxidation and chlorine undergoes reduction.

[tex]WO_2 +2 H_2 -> W+ 2 H_2O\\[/tex]

In this reaction, W (tungsten) undergoes reduction and hydrogen undergoes oxidation.

[tex]Ca+2 H_2O ->H_2+Ca(OH)_2\\[/tex]

Ca undergoes oxidation and hydrogen undergoes reduction.

[tex]4Al+3O_2->2Al_2O_3\\[/tex]

Al undergoes oxidation and oxygen undergoes reduction.

Answer:

0.1775 M

Explanation:

The reaction that takes place is:

Where HA is the unknown weak acid.

At the equivalence point all HA moles are converted by NaOH. First we calculate how many NaOH moles reacted, using the given concentration and volume:

That means that in 4.00 mL of the weak acid solution, there were 0.71 weak acid mmoles. With that in mind we can now calculate the concentration:

Answer:

Melting-point apparatus

Answer:

the molar mass of the element

Answer:

This is an oxidation-reduction (redox) reaction:

2 Ni0 - 4 e- → 2 NiII

(oxidation)

2 O0 + 4 e- → 2 O-II

(reduction)

Ni is a reducing agent, O2 is an oxidizing agent.

Answer:

The correct answer is Option c (0.163 g).

Explanation:

Given:

Heat energy,

Q = 0.21 J

Specific heat,

c = 4.184 J/g°c

Change in temperature,

ΔT = 0.308°C

As we know,

⇒ [tex]Q=mc \Delta T[/tex]

By substituting the values, we get

 [tex]0.21=m\times 4.184\times 0.308[/tex]

     [tex]m=\frac{0.21}{0.308\times 4.184}[/tex]

         [tex]=\frac{0.21}{1.28867}[/tex]

         [tex]=0.163 \ g[/tex]

0.152 moles

The mass of the oxygen gas produced = 4.87 g

Also, The molar mass of oxygen gas,  =  = 32 g/mol

The formula for the calculation of moles is shown below:

moles = [tex]\frac{Mass-taken}{Molar-mass}[/tex] *

Thus,

moles = [tex]\frac{4.87g}{32g/mol }[/tex]

Both given values and the answer is in 3 significant digits.

brainlist pls?

*i put a dash between mass and taken as formulas do no spaces

Answer:

b. glass and charcoal

Explanation:

Step 1: Given data

Step 2: Determine which material will float in molten lead

Density is an intrinsic property of matter. Less dense materials float in more dense materials. The materials whose density is lower than that of lead and will therefore float on it are glass and charcoal.

Answer:

2.9 × 10²⁴ atoms Cu; 3.3 × 10²¹ atoms C; 1.44 × 10²⁵ atoms Hg; 9.63 × 10²² atoms Na

Explanation:

To convert moles to atoms, we need a conversion factor: Avogadro's number. There are 6.02 × 10²³ atoms in 1 mole of atoms.

4.9 mol Cu × 6.02 × 10²³ atoms Cu/1 mol Cu = 2.9 × 10²⁴ atoms Cu

5.4 × 10⁻³ mol C × 6.02 × 10²³ atoms C/1 mol C = 3.3 × 10²¹ atoms C

24.0 mol Hg × 6.02 × 10²³ atoms Hg/1 mol Hg = 1.44 × 10²⁵ atoms Hg

0.160 mol Na × 6.02 × 10²³ atoms Na/1 mol Na = 9.63 × 10²² atoms Na

The equation for the energy required to melt 2 kg of gold is 3440 kJ.

Energy is the ability to do work or cause change. It is an essential part of everyday life and is present in many forms, such as thermal energy, electrical energy, chemical energy, and mechanical energy. Energy can be converted from one form to another in order to do work.

The equation for calculating the energy required to melt a certain mass of material is Q = m x Lf, where Q is the energy required (in joules), m is the mass of the material (in kilograms), and Lf is the latent heat of fusion (in joules per kilogram).
Using the table below, we can see that the latent heat of fusion for gold is 1760 kJ/kg. Therefore, the equation for the energy required to melt 2 kg of gold is: Q = 2 kg x 1760 kJ/kg = 3440 kJ.

To learn more about energy
https://brainly.com/question/19666326
#SPJ1

hope it helps to everyone

Answer:

zero

Explanation:

I I think one should be so accurate with measurements and experiments

Answer:

For 1: The product is phosphoric acid and the solution is acidic in nature.

For 2: The product is sodium hydroxide and the solution is basic in nature.

For 3: The product is nitric acid and the solution is acidic in nature.

Explanation:

For the given options:

(1): When diphosphorus pentoxide reacts with water, it leads to the formation of phosphoric acid, which makes the solution acidic in nature.

The chemical equation for the reaction follows:

[tex]P_4O_{10}+6H_2O(l)\rightarrow 4H_3PO_4(aq)[/tex]

(2): When disodium oxide reacts with water, it leads to the formation of sodium hydroxide, which makes the solution basic in nature.

The chemical equation for the reaction follows:

[tex]Na_2O+H_2O(l)\rightarrow 2NaOH(aq)[/tex]

(3): When dinitrogen pentoxide reacts with water, it leads to the formation of nitric acid, which makes the solution acidic in nature.

The chemical equation for the reaction follows:

[tex]3N_2O_5+3H_2O(l)\rightarrow 6HNO_3(aq)[/tex]

Answer:

a. The student performed the splint test incorrectly. He should of observed a popping sound when the splint was placed in the test tube.

Explanation:

It is given that a student performed an experiment where he dropped a nickel metal in to HCl solution. He observed the reaction and performed a splint test in the test tube that is filled with a gas which is formed while Nickle is dropped into the solution of HCl.

But the experiment that the student performed was incorrect. He must have observed the popping sound when the splint was placed in the test tube.

When the splint was added to the gas splint flared up. The hydrogen gas pops out when exposed to the flame.

[tex]$Ni + HCl(aq) = NiCl + H_2$[/tex]

Thus the correct option is (a).

Answer:

answer = 22.5m

Explanation:

using

[tex]s = \frac{ {v}^{2} - {4}^{2} }{2a} [/tex]

s= (0²-21²)/2(-9.8)

s= -441/19.6

s= 22.5m

do consider marking as Brainliest if this helped!!