Determine the enthalpy for the reaction A+B --> C If we know the following:
A+E --> C+D; delta H = -200 kJ
D+B --> E; delta H = -100 kJ

Answer:

I hope that's what u were lookong for :))

Explanation:

Answer:

0.241 M

Explanation:

We'll begin by writing the balanced equation for the reaction. This is given below:

HBr + NaOH —> NaBr + H₂O

From the balanced equation above,

The mole ratio of acid, HBr (nₐ) = 1

The mole ratio of base, NaOH (n₆) = 1

Finally, we shall determine the concentration of the NaOH solution. This can be obtained as follow:

Volume of base, NaOH (V₆) = 20 mL

Volume of acid, HBr (Vₐ) = 24.1 mL

Concentration of acid, HBr (Cₐ) = 0.2 M

Concentration of base, NaOH (C₆) =?

CₐVₐ / C₆V₆ = nₐ/n₆

0.2 × 24.1 / C₆ × 20 = 1/1

4.82 / C₆ × 20 = 1

Cross multiply

C₆ × 20 = 4.82

Divide both side by 20

C₆ = 4.82 / 20

C₆ = 0.241 M

Therefore, the concentration of the NaOH solution is 0.241 M

Answer:

179.5 feet

Explanation:

54.718 m converted to 179.5 feet.

Answer:

b is your answer...........

Answer:

i think its C polymer hope it helps

Answer:

The combination of ions most likely to produce a precipitate is a group of answer choices:

lead nitrate soluble in water

Mg2+ and C2H3O2-.

Fe3+ and OH-.

Li+ and PO43-.

Pb2+ and NO3-.

NH4+ and SO42-.

Explanation:

Among the given options,

magnesium acetate, lithium phosphate, lead nitrate, ammonium sulfate are soluble in water.

The only one which is insoluble in water is [tex]Fe^3+[/tex] and [tex]OH^-[/tex] combination.

[tex]Fe(OH)_3[/tex] is insoluble in water. It forms a precipitate.

Explanation:

If the iceberg is near the lake and the water molecules melt, then the molecules will slide down. The iceberg could be melting for many reasons - it can be purposely destroyed, the sun could be melting it, or it might naturally fall in. So, this is the answer to your question. Hope it helps!

Answer:

To determine the number of atoms of Boron that are present within 3.61 grams of Boron Trifluoride, it would be best to convert the grams to moles of the compound and then after that use the Avogadro's number to determine the number of molecules and then use the 1 to 3 ratio to determine the total number of Boron atoms.

Answer:

true

false

false

true

false

true

true

false

false

true

true

Answer:

1) The percentage of oxygen in dry air is _______

C. 21

2) The composition of the Earth’s earliest atmosphere was different to that of the present atmosphere. Which of these gases was present in large amounts in the Earth’s earliest atmosphere?

B. CARBON DIOXIDE

Hope it helps

have a nice day

Answer: The percentage of oxygen in dry air is .  21

Explanation:  Ammonia gases was present in large amounts  in the easth7s earliest atmosphere

Hope it will help you

Answer:

Im pretty sure its true

Explanation:

Answer:

answer is true .

Explanation:

this may help you

Answer:

Diatomic molecules contain two atoms that are chemically bonded. If the two atoms are identical, as in, for example, the oxygen molecule (O2), they compose a homonuclear diatomic molecule, while if the atoms are different, as in the carbon monoxide molecule (CO), they make up…

Explanation:

yei hoo arko aaxaina ...

Answer:

Chemistry plays an important and useful role towards the development and growth of a number of industries. This includes industries like glass, cement, paper, textile, leather, dye etc. We also see huge applications of chemistry in industries like paints, pigments, petroleum, sugar, plastics, Pharmaceuticals.

Answer:g

Explanation:

Answer:

How many distinct monochlorinated products can result when methylcyclohexane is subjected to free radical chlorination under UV light.

Explanation:

Consider 1-methylcyclohexane:

Its structure is shown below:

It has primary [tex]1^o[/tex], secondary [tex]2^o[/tex]and tertiary [tex]3^o[/tex] carbons as shown in the image.

So, the following mono chlorinated product will be formed.

Answer:

Swimming pool is an example of solution

Explanation:

It has water (solvent) and dissolve ion (solute)

Answer:

it is a solution

Explanation:

the combining of (water and Cl and other pool chemicals) make it a solution.

Answer:

18.5g Na2CO3

Explanation:

Chromium (III) chloride, CrCl3, reacts with Na2CO3 as follows:

2CrCl3 + 3Na2CO3 → Cr2(CO3)3(s) + 6NaCl

Where 2 moles of CrCl3 react with 3 moles of Na2CO3 to produce 1 mole of Cr2(CO3)3 -The precipitate-

To solve this question we need to find the moles of CrCl3 added. With the chemical equation we can find the moles of Na2CO3 and its mass as follows:

Moles CrCl3:

520mL = 0.520L * (0.224mol/L) = 0.116 moles CrCl3

Moles Na2CO3:

0.116 moles CrCl3 * (3 mol Na2CO3 / 2mol CrCl3) = 0.175 moles Na2CO3

Mass Na2CO3 -Molar mass: 105.99g/mol-

0.175 moles Na2CO3 * (105.99g/mol) = 18.5g Na2CO3

Answer: The heat energy produced is 53831.25KJ

Explanation:

METHANE is the main component of natural gas. It can undergo combustion reaction in air with a bright blue flame to produce carbondioxide and water. The heat of reaction (enthalpy) is negative because heat is absorbed during the chemical reaction. To calculate the heat energy produced by the combustion of one kilogram (1 kg) of methane the following steps are taken:

Molecular mass of methane =16 gm/mol.

So moles of 1 kg methane =

Given mass of methane ÷ molecular weight of methane

But the given mass = 1kg = 1000g

Therefore,

moles of 1000g methane = 1000÷16

= 62.5 moles

Hence, energy evolved = (moles of methane) × (heat of combustion)

Therefore,

heat energy produced= 62.5 × (-861.3kj)

= -53831.25kj

​

The heat energy produced by the combustion of one kilogram of methane is –53831.25 KJ

We'll begin by calculating the number of mole in 1 Kg of CH₄

Mass of CH₄ = 1 kg = 1000 g

Molar mass of CH₄ = 12 + (4×1) = 16 g/mol

Mole = mass /molar mass

Mole of CH₄ = 1000 / 16

CH₄ + 2O₂ —> CO₂ + 2H₂O ΔH = –861.3 KJ

From the balanced equation above,

1 mole of CH₄ reacted to produce –861.3 KJ.

Therefore,

62.5 moles of CH₄ will react to produce = 62.5 × –861.3 = –53831.25 KJ

Thus, –53831.25 KJ of heat energy is produced.

Complete Question is located in the attached photo

Learn more: https://brainly.com/question/13671340

Answer:

b

Explanation:

Molecular formula of Decanoic Acid is  C₁₀H₂₀O₂ therefore Option A is the right answer.

Decanoic Acid is a C10 , straight chain , saturated fatty acid . Its general formula is C₁₀H₂₀O₂ .

In the first option we can see a straight chain , saturated fatty acid and the molecular formula is also same as decanoic acid .

In second option the molecular formula is C₉H₁₈O₂ which is not same as Decanoic Acid.

Hence option A is the right answer.

To know more about Decanoic Acid;

https://brainly.com/question/8729762

#SPJ2

Cu(s) + Ni(NO3)2(aq) ⇒Ni(s) + Cu(NO3)2(aq)

The answer is option B.

Electrochemical or hobby series when the electrodes (metals and non-metals) in touch with their ions are organized on the idea of the values of their preferred discount potentials or standard oxidation potentials, the resulting series is called the electrochemical.

The electrochemical series is built up by means of arranging various redox equilibria so as of their fashionable electrode potentials (redox potentials). The maximum poor E° values are placed at the pinnacle of the electrochemical series, and the maximum wonderful at the lowest.

Learn more about chemical equation  here:-https://brainly.com/question/11231920

#SPJ2

Answer:

the process by which green plants and some other organisms use sunlight to synthesize nutrients from carbon dioxide and water. Photosynthesis in plants generally involves the green pigment chlorophyll and generates oxygen as a by-product.

Answer:

the process by which green plants and some other organisms use sunlight to synthesize nutrients from carbon dioxide and water. Photosynthesis in plants generally involves the green pigment chlorophyll and generates oxygen as a by-product.

Explanation:

2C +O2 = 2CO

this will be the answer

Answer: The mass of ammonia is 124457.96 g which can be produced from reacting a 450 L sample of nitrogen gas at a temperature of 450 K and a pressure of 300 atm.

Explanation:

Given: Volume = 450 L

Temperature = 450 K

Pressure = 300 atm

The reaction equation is as follows.

[tex]N_{2} + 3H_{2} \rightarrow 2NH_{3}[/tex]

Here, 1 mole of nitrogen reacts to give 2 moles of ammonia.

From the given data, moles of nitrogen are calculated as follows.

PV = nRT

where,

P = pressure

V = volume

n = no. of moles

R = gas constant = 0.0821 L atm/mol K

T = temperature

Substitute the values into the above formula as follows.

[tex]PV = nRT\\300 atm \times 450 L = n \times 0.0821 L atm/mol K \times 450 K\\n = \frac{300 atm \times 450 L}{0.0821 L atm/mol K \times 450 K}\\= \frac{135000}{36.945}\\= 3654.08 mol[/tex]

For 3654.08 moles of nitrogen, the moles of ammonia produced is as follows.

[tex]2 \times 3654.08 mol\\= 7308.16 mol[/tex]

Therefore, mass of ammonia (molar mass = 17.03 g/mol) is calculated as follows.

[tex]Moles = \frac{mass}{molarmass}\\7308.16 mol = \frac{mass}{17.03 g/mol}\\mass = 124457.96 g[/tex]

Thus, we can conclude that the mass of ammonia is 124457.96 g which can be produced from reacting a 450 L sample of nitrogen gas at a temperature of 450 K and a pressure of 300 atm.

Answer:

When gases in containers are heated, their molecules increase in average speed. This means that they exert a greater force when they collide with the container walls, and also collide with the walls more frequently. The gas is therefore under greater pressure when its temperature is higher.

Answer:

Los dos óxidos que forma el cobre son óxido de cobre (I) y óxido de cobre (II) (Cu₂O y CuO, respectivamente).

Explanation:

El cobre posee dos estados de oxidación más comunes, los cuales son +1 y +2.

En contacto con aire el cobre se puede oxidar para dar lugar al óxido cuproso u óxido de cobre (I):

4Cu + O₂ → 2Cu₂O

Dicha oxidación también puede dar lugar a la formación del óxido cúprico u óxido de cobre (II):

2Cu + O₂ → 2CuO

La formación del óxido cúprico se favorece a temperaturas mayores a la del ambiente (por encima de los 300 °C).

Por lo tanto, los dos óxidos que forma el cobre son óxido de cobre (I) y óxido de cobre (II) (Cu₂O y CuO, respectivamente).  

Espero que te sea de utlidad!