help please I would really appreciate ​

The question is incomplete, the complete question is:

Standardization of a Borax solution (Na2B4O7). A student titrates a 20.00 mL sample of an aqueous borax solution with 1.044 M H2SO4. It takes 2.63 mL of acid to reach the equivalence point. Knowing it takes 1 H2SO4 to neutralize 2 Na2B4O7, what was the concentration of this Borax solution?

Answer: The concentration of borax solution is 0.069 M.

Explanation:

To calculate the concentration of borax solution, the formula used is:

[tex]n_1C_1V_1=n_2C_2V_2[/tex] ....(1)

where,

[tex]n_1, C_1\text{ and }V_1[/tex] are the n-factor, concentration and volume of sulfuric acid

[tex]n_2,C_2\text{ and }V_2[/tex] are the n-factor, concentration and volume of borax solution.

We are given:

[tex]n_1=1\\C_1=1.044M\\V_1=2.63mL\\n_2=2\\C_2=?M\\V_2=20mL[/tex]

Putting values in equation 1, we get:

[tex]1\times 1.044\times 2.63=2\times C_2\times 20\\\\C_2=\frac{1\times 1.044\times 2.63}{2\times 20}\\\\C_2=0.069M[/tex]

Hence, the concentration of borax solution is 0.069 M.

Answer:

PCl5 <-> PCl3 + Cl2

PCl5 decomposes into PCl3 and Cl2 according to the equation above. A pure sample of Pcl5 is placed in a rigid, evacuated 1.00 L container. The initial pressure of the PCl5 is 1.00 atm. The temperature is held constant until the PCl5 reaches equilibrium with its decomposition products. The figures below show the initial and equilibrium conditions of the system.

As the reaction progresses toward equilibrium, the rate of the forward reaction

A) increases until it becomes the same as the reverse reaction rate at equilibrium

B) stays constant before and after equilibrium is reached

C) decreases to become a constant nonzero rate at equilibrium

D) decreases to become zero at equilibrium

Explanation:

At equilibrium, both forward and backward reactions take place with constant speed.

The reaction will never cease.

Due to this reason chemical equilibrium is called dynamic in nature.

At equilibrium:

the rate of forward reaction = rate of backward reaction

As the reaction progresses toward equilibrium, the rate of the forward reaction decreases to become a constant nonzero rate at equilibrium.

Answer is option C).

When a system is in a state of chemical equilibrium, neither the reactant concentration nor the product concentration changes over time, nor does the system exhibit any further changes in its attributes. Here the correct option is C.

The system reaches a condition of chemical equilibrium when the rate of the forward reaction equals the rate of the reverse reaction. The system is considered to be in a state of dynamic equilibrium when the concentrations of the reactants and products do not change further as a result of the equal rates of the forward and reverse processes.

Equilibrium is impacted by a number of variables, including temperature, pressure, and the system's concentration. Here at equilibrium the rate of the forward reaction decreases to become a constant nonzero rate at equilibrium.

Thus the correct option is C.

To know more about chemical equilibrium, visit;

https://brainly.com/question/4289021

#SPJ6

Answer:

The offspring are all black eye colored.

Explanation:

Since we have genes BB for black eye color and genes bb for brown eye color, crossing the genes, the resulting genotypes in the offspring is Bb, Bb, Bb and Bb. We note that all the genes have the dominant B gene. Since the black eye color dominant gene is present in all the offspring, the offspring are thus all black-eye colored.

So, If you will cross a parent with black eye color (BB) and the other is

brown eye (bb), the offspring are all black eye colored.

Explanation:

A B C D isme koyi ans hain doond lo

Answer:

C. Gravity only

Explanation:

Answer:

A

Explanation:

because B is wrong as it doesn't have the same mass number. C is wrong as it has different number of neutrons. D is wrong as it has more neutrons than protons.

The addition of any non-volatile solutes will elevate the boiling point of the solution. The change in boiling point of water by the addition of 2.10 of barium chloride is 0.0028 ° C. Hence, option A is correct.

Boiling point of a substance is the temperature at which it changes from liquid to vapour where the two states are in equilibrium. Boiling point of a substance depends on the bond type, molecular mass and purity of it.

The change or elevation of boiling point of a solution can be determined from its molality m and elevation constant Kb and the Van't Hoff factor i as follows:

ΔT = i Kb m.

Molality of the solution is the no.of moles divided by the mass of solvent in kilogram. Given the mass of barium chloride is 2.10 g and its molar mass is 208.23 g . The no.of moles of solute is 2.10/208.23 g = 0.0100.

Molality of the solution can be calculated as follows:

Molality m = 0.0100 / 5.50 Kg

                 = 0.0018 mol/kg.

Now, the  ΔT s calculated from these values. Provided Kb of water is 0.51 ° C /mol and i = 3.

ΔT  = 0.0018 mol/kg × 0.51 × 3

       = 0.0028 ° C.

Therefore, water will boil at 100.0028 ° C. Hence, option A is correct.

To find more about boiling point, refer the link below:

https://brainly.com/question/28203474

#SPJ1

Answer:

2.5×10⁶ s

Explanation:

From the question given above, the following data were obtained:

Rate constant (K) = 2.8×10¯⁷ s¯¹

Half-life (t½) =?

The half-life of a first order reaction is given by:

Half-life (t½) = 0.693 / Rate constant (K)

t½ = 0.693 / K

With the above formula, we can obtain the half-life of the reaction as follow:

Rate constant (K) = 2.8×10¯⁷ s¯¹

Half-life (t½) =?

t½ = 0.693 / K

t½ = 0.693 / 2.8×10¯⁷

t½ = 2.5×10⁶ s

Therefore, the half-life of the reaction is 2.5×10⁶ s

c) Current cannot flow

Reason: Because the switch is not closed.

Answer:

current can't flow

Explanation:

by the way of explanation it is open circuit in which the current flow whereas in closed circuit the current flow.

if you like my answer please mark as brainlist.

it will be too much help for me.

Answer:

Atoms are single neutral particles. Molecules are neutral particles made of two or more atoms bonded together.

Explanation:

its on safari ??????????

Answer:

The final temperature aluminium-water system is 24° C

Explanation:

Heat energy, H = mcθ

Where m is mass of substance, c is specific heat capacity, θ is temperature difference

Using the principle, Heat lost = Heat gained

Let the final temperature of the aluminium-water system be Tfinal

Heat lost by aluminium, H₁ = -m₁c₁(Tfinal - 40)

Heat gained by water, H₂ = m₂c₂(Tfinal -21)

Heat lost by aluminium, H = -[30 × 0.21 × (Tfinal - 40)]

H₁ = -6.3Tfinal + 252

Heat gained by water, H₂ = 50 × 1.0 × (Tfinal - 21)

H₂ = 5Tfinal - 21

Equating H₁ and H₂

-6.3Tfinal + 252 = 5 Tfinal - 21

5Tfinal + 6.3Ffinal = 252 + 21

11.3 Tfinal = 273

Tfinal = 273/11.3

Tfinal = 24° C

Therefore, the final temperature aluminium-water system is 24° C

Answer:

Some of the common impacts of earthquakes include structural damage to buildings, fires, damage to bridges and highways, initiation of slope failures, liquefaction, and tsunami.

Answer:

The molecules of oxygen should be placed as reactants in the equation.

Explanation:

1:      N₂ + O₂ → 2NO

2:     2NO + O₂ → 2NO₂

complete reaction:

N₂ + 2O₂ → 2NO₂

We can not place oxygen at the side of products neither we can cancel it because, products can only be obtained at the end of the reaction but according to the equations' oxygen is not the end product of the reaction. But the addition into the reaction (Eq. 2) to make the new product.

Also, we can not cancel it because to cancel out molecules of oxygen should be present at the both sides with same amount in the stoichiometric equation.

Hence, in a balanced chemical equation, oxygen should be written as a reactant by using the correct number of moles.

Answer: true

Asexual reproduction is the process by which an organism is produced from a single parent cell. There are four major forms of asexual reproduction - budding, binary fission, regeneration and parthenogenesis. ... Regeneration is a type of asexual reproduction in which the organism is capable of regrowing certain body parts.

Explanation:

id k what u r talking abt but hope this helps

Answer:

Malleability describes the property of a metal's ability to be distorted below compression. It is a physical property of metals by which they can be hammered, shaped and rolled into a very thin sheet without rupturing. A malleable fabric could be planate by blow or rolling.

Explanation:

Ductility is the property of a solid, like a metal, to deform under a tensile stress (force). So if you pull on two ends of a metal wire or bar, and it “stretches” you have a ductile substance. Though I must caution that you don't confuse the definition of ductile to mean elastic. They are not synonyms. It is the opposite of brittle. When a ductile item breaks, it is after necking, where the diameter of the wire in question reduces as the length elongated. A brittle, or non-ductile material simple tears apart in a sharp and quick fashion with little to no visible necking taking place.

sonorous: producing sound (as when struck)

Answer:

The study of the interaction of electrical and magnetic fields, and their interaction with matter, is called Electromagnetism

Answer:

C

Explanation:

In thermodynamics, a exothermic system looses heat to the surroundings while an endothermic system absorbs heat from the surroundings.

A system is a part the universe marked off by a specified boundary. The contents of the cup constitutes the system in this case.

The region of space outside the system is called the surroundings. Hence everything outside the cup constitutes the surroundings.

Answer:

It's answer is c) exactly 37 protons

Answer:

C) ,  Exactly 37 protons.

Explanation:

Remember the electrons have a negative charge, so to make a atom with 37 electrons neutral, you will need the same amount of the opposite type. That means you need 37 protons.

Answer: The molality of [tex]NaC_2H_3O_2[/tex] solution is 0.782 m

Explanation:

Molality is defined as the amount of solute expressed in the number of moles present per kilogram of solvent. The units of molarity are mol/kg. The formula used to calculate molality:

[tex]\text{Molality of solution}=\frac{\text{Moles of solute}}{\text{Mass of solvent (in kg)}}[/tex] .....(1)

Given values:

Moles of [tex]NaC_2H_3O_2[/tex] = 0.395 mol

Mass of solvent (water) = 0.505 kg

Putting values in equation 1, we get:

[tex]\text{Molality of }NaC_2H_3O_2=\frac{0.395mol}{0.505kg}\\\\\text{Molality of }NaC_2H_3O_2=0.782m[/tex]

Hence, the molality of [tex]NaC_2H_3O_2[/tex] solution is 0.782 m

A. build proteins

Explanation:

The endoplasmic reticulum can either be smooth or rough, and in general its function is to produce proteins for the rest of the cell to function. The rough endoplasmic reticulum has on it ribosomes, which are small, round organelles whose function it is to make those proteins

Answer:

d. the solution is a acid

Answer:D The solution is an acid

Explanation:The lower the pH of a substance the stronger the acidic level.

Answer:

Weight = 500 Newton

Explanation:

Given the following data;

Acceleration due to gravity = 10N/Kg

Weight can be defined as the force acting on a body or an object as a result of gravity.

Mathematically, the weight of an object is given by the formula;

[tex] Weight = mg [/tex]

Where;

Note: In order to calculate the weight of a mass, it's required that the mass of an object or body is given.

However, in this particular question it was omitted in error and as such i would assume a value.

Substituting into the formula, we have;

[tex] Weight = 50 * 10 [/tex]

Weight = 500 Newton

Answer:

i) During washing

ii) During Measurement

Explanation:

The two possible steps are :

i) During washing : during the washing method the residue may be not completely dried out and this residue ( water) will add up to the final product ( copper yield ) and this kind of error is called human error.

ii) During measurement : If the weighing instrument is faulty there might be addition  in value of the final copper yield which will see the final yield value > 100% . this error occurs when the initial value and final value is  been weighed

Explanation:

Objectives and goals serve as a foundation for successful organizations since they establish the business's objective and aid in the identification of required measures. Goals are broad assertions of what you want to achieve, whereas goals are the precise stages or steps you need to take to get there.

Answer:

The more polar the molecules, the stronger the force. The more hydrogen in the molecule, the stronger the force.

Explanation:

I hope this helps and please ask if you need further help!

Answer:

A: Gamma

Gamma rays have enough energy to kill bacteria

Answer:

A heatwave occurs when a system of high atmospheric pressure moves into an area and lasts two or more days.

Explanation:

In such a high-pressure system, air from upper levels of our atmosphere is pulled toward the ground, where it becomes compressed and increases in temperature.

Answer:

SiH

Explanation:

The symbol for Silicon is Si, and the symbol for Hydrogen is H. There is no need for extra characters in the name.

(i) Liang - liang stoma lebih banyak di bahagian bawah daun berbanding di bahagian atas permukaan daun.

(ii) Struktur X berfungsi mangawal pembukaan dan penutupan liang stoma