If the flour mixture is then taken and put into the oven for about 20 minutes, it turns into something very tasty. What kind of change has happened now?

Answer:

Greatly affect.

Explanation:

This level of fishing will greatly affect the populations of the other fish in the simulated reef because overfishing disturbs the equilibrium in the marine ecosystem. One fish is a food of another fish or the big fish act as a controller which controls the population of other small fishes and in that way the ecosystem is present in equilibrium state so overfishing will greatly affect the marine ecosystem.

Answer:

0.028 mole of ammonium phosphate, (NH₄)₃PO₄.

Explanation:

We'll begin by writing the balanced equation for the reaction. This is illustrated below:

H₃PO₄ + 3NH₃ —> (NH₄)₃PO₄

From the balanced equation above,

3 moles of NH₃ reacted to produce 1 mole of (NH₄)₃PO₄.

Finally, we shall determine the number of mole of (NH₄)₃PO₄ produced by the reaction of 0.085 mole of ammonia, NH₃. This can be obtained as follow:

From the balanced equation above,

3 moles of NH₃ reacted to produce 1 mole of (NH₄)₃PO₄.

Therefore, 0.085 mole of NH₃ will react to produce = (0.085 × 1)/3 = 0.028 mole of (NH₄)₃PO₄.

Thus, 0.028 mole of ammonium phosphate, (NH₄)₃PO₄ were obtained from the reaction.

Answer:

116.78 grams.

Explanation:

1 mol of Strontium (Sr) = 87.62 grams

1.38 mol of Strontium = x

Cross Multiply

1 * x = 1.38 * 87.62

x = 116.78  grams

An SDOF system is one whose motion is governed by a single, second-order differential equation. Only two variables, position and velocity are needed to describe the trajectory of the system. Many structures can be idealized as single degree-of-freedom systems.

The LDAP Data Interchange Format is a standard plain text data interchange format for representing LDAP directory content and update requests. LDIF conveys directory content as a set of records, one record for each object.

Answer:

This creates destructive interference.

Explanation:

When the two ends meet they will cancel each other out.

Both students are shaking the rope in the upward direction. Hence their crest will meet up and form the constructive  interference pattern. The intensity of the increases.

When two waves moves in phase, their crest or troughs add up and the amplitude of the wave increases. This phenomenon is called constructive interference.

If the two waves are passing out of phase to each other then they undergo destructive interference. The amplitude of the destructive interference pattern reduces from their initial values.

Here, both students are shaking the rope in the upward direction. Thus, they are in moving in phase. Hence their crest will meet up and form the constructive  interference pattern. The intensity of the increases.

Find more on interference?

https://brainly.com/question/16098226

#SPJ5

Answer:

Carbon and oxygen are chemically bonded in it.

Explanation:

The other answer choices do not apply for compounds, but rather for mixtures instead.

Answer:

The soil has a percentage of water by mass of 27.8 %.

Explanation:

Keeping in mind that

we can calculate the mass of water:

We can then calculate the mass percentage of water in the soil:

Answer:

Q =  57934.8 J

Explanation:

Given data:

Mass of water = 180.0 g

Initial temperature = 19°C

Fina temperature = 96°C

Specific heat capacity of water = 4.18 J/g.°C

Heat absorbed = ?

Solution:

Formula:

Q = m.c. ΔT

Q = amount of heat absorbed or released

m = mass of given substance

c = specific heat capacity of substance

ΔT = change in temperature

ΔT = 96°C - 19°C

ΔT = 77°C

Q = 180.0 g×4.18 J/g.°C×77°C

Q =  57934.8 J

Answer:

Black

Explanation:

Answer:

the answer is

-there is the same number of each type of atom on the right side of the equation as the left.

Explanation:

i have study island too :')

Answer:

 (C) Mass of KCl(s), mass of H20, initial temperature of the water, and final temperature of the solution

Explanation:

molar enthalpy of solution of KCl(s) is heat evolved or absorbed when one mole of KCl is dissolved in water to make pure solution . The heat evolved or absorbed can be calculated by the following relation.

Q = msΔt where m is mass of solution or water , s is specific heat and Δt is change in temperature of water .

So data required is mass of water or solution , initial and final temperature of solution , specific heat of water is known .

Now to know molar heat , we require mass of solute or KCl dissolved to know heat heat absorbed or evolved by dissolution of one mole of solute .

The correct option is option C.

To determine the molar enthalpy of the solution of [tex]Kcl(s)[/tex] is pure [tex]H_2O(l)[/tex]

We need to know that the,

Learn More:https://brainly.com/question/25758173

Answer:

The 3R rule states that cracks tend to form at a (n) right angle on the opposite side from the point of impact.

Explanation:

its dry i think

Explanation:

it might be dry

Answer: 1.67

D=M/V

(D=57.4/34.3)= 1.67

Answer:

Test it with a blue light that is 45 cm away.

Explanation:

Answer:

0.229 cm³.

Explanation:

The following data were obtained from the question:

Volume (in in³) = 0.014 in³

Volume (in cm³) =?

1 in = 2.54 cm

Next, we shall determine a conversion scale to convert from in³ to cm³. This can be obtained as follow:

1 in = 2.54 cm

Therefore,

1 in³ = 2.54³ cm³

1 in³ = 16.387 cm³

Finally, we shall convert 0.014 in³ to cm³. This can be obtained as follow:

1 in³ = 16.387 cm³

Therefore,

0.014 in³ = 0.014 in³ × 16.387 cm³ / 1 in³

0.014 in³ = 0.229 cm³

Thus, 0.014 in³ is equivalent to 0.229 cm³.

Answer:

Via covalent bonds

Explanation:

Atoms in molecules are bonded together via covalent bonds. Covalent bonds are bonds that are formed by sharing of the valence electrons between two atoms.

The atoms can be of the same kind or of different kinds.

Explanation:

Molar mass of AlCl3 = 133.34g/mol

Moles of AlCl3 used

= 20.0g / (133.34g/mol) = 0.150mol

Mole Ratio of AlCl3 to Cl2 = 2 : 3,

Moles of Cl2 produced

= 0.150mol * (3/2) = 0.225mol

We know that 1 mole of any gas has

6.023 * 10²³ molecules.

Hence, number of molecules in Cl2

= 0.225mol * (6.023 * 10²³/mol)

= 1.35 * 10²³ molecules. (C)

Answer:

i think its oxide not too sure

Answer:  

 Its should be ammonium chloride.

A picture to help you with another question like this

Answer:

b

Explanation:

Answer:

0.48g

Explanation:

Given parameters:

Mass of zinc  = 15g

Unknown:

Mass of hydrogen gas = ?

Solution:

To solve this problem, we need to state the balanced reaction expression first;

          Zn   +   2HCl   →   ZnCl₂    +   H₂

Find the number of moles of Zn;

    Number of moles  = [tex]\frac{mass}{molar mass}[/tex]    = [tex]\frac{15}{63.4}[/tex]    = 0.24mol

From the balanced reaction expression;

             1 mole of Zn will produce 1 mole of H₂  

            0.24mole of Zn will produce 0.24mole of hydrogen gas

Mass of hydrogen gas  = number of moles x molar mass

                                      = 0.24 x (2 x 1)

                                      = 0.48g

The  uncertainties  of  the  delta  measurements  and  the  uncertainty  of  the  atomic  weight  derivedfrom  the  best  measurement  of  isotopic  abundances  constrain  the  number  of  significant  figures  in  theatomic-weight values of the upper and lower bounds. For carbon, the fifth digit after the decimal pointis uncertain because of the uncertainty value of 0.000 027. Therefore, the number of significant digitsin the atomic-weight value is reduced to four figures after the decimal point. The Commission may rec-ommend  additional  conservatism  and  reduce  the  number  of  significant  figures  further.  For  the  lowerbound of carbon, 12.009 635 is truncated to 12.0096. For an upper bound, the trailing digit is increasedto ensure the atomic-weight interval encompasses the atomic-weight values of all normal materials. Inthe case of carbon, the upper bound is adjusted from 12.011 532 to 12.0116 to express four digits afterthe decimal point. The lower and upper bounds are evaluated so that the number of significant digits ineach  is  identical.  If  a  value  ends  with  a  zero,  it  may  need  to  be  included  in  the  value  to  express  therequired number of digits. The following are examples of lower and upper atomic-weight bounds foroxygen that could be published by the Commission in its various tables.

---------------------------

Extracted from" Atomic weights of the elements 2009 (IUPAC Technical Report)"

Answer:

h3po2

Explanation:

Answer:

i think it is H3PO4

Explanation:

Answer:

d. 10 million years

Explanation:

These are the options for the question

Choose one answer.

a. 2.5 million years

b. 5 million years

c. 15 million years

d. 10 million years

✓half-life of the radioactive substance= 5 million years

✓ Then for every 5 million years, original radioactive given (100%) percentage is reduced by factor of 1/2.

✓ 1st 5 million year; After the first 5 million years, the original radioactive is reduced as;

(100%) × 1/2 = 50% remains

✓2nd 5 million year: At 10 millions year, the 50% remaining radioactive is reduced by factor of 1/2

(50%) × 1/2 = 25% remains

Hence, at At 10 millions years 25% of the original radioactive atoms remain

.

Answer:

10 million years

Answer:

O Each orbit has a specific energy level.

Explanation:

Neils Bohr put forward his own model of the atom based on the quantum mechanics originally developed by Planck.

He assumed the Rutherford's model and suggested that the extranuclear part consists of electrons in specific spherical orbits around the nucleus.

The orbits/energy level are the permissible through which the electrons can move through.

His concept is based the concept that the electron can move round the nucleus in certain permissible orbitss

Answer:

An ionic bond is the electrostatic force that holds ions together when they form bonds

Explanation:

An ionic bond is formed when a metal looses electron(s) to a non metal leading to the formation of a positive ion and a negative ion.

An ionic compound is actually an ion pair, the ions are held together by strong electrostatic forces.

This strong electrostatic force that holds the ion pair together in ionic compounds is what we commonly call the IONIC BOND.  

Answer:

An ionic bond is the electrostatic force that holds ions together when they form bonds

Explanation:

I took this test and it was the correct answer :)

Answer:

Liquid

Explanation:

Answer:

1.17 M

Explanation:

Step 1: Write the balanced equation

N₂ + 3 H₂ ⇒ 2 NH₃

Step 2: Calculate the rate of disappearance of H₂

We will use the following expression.

rH₂ = - Δ[H₂]/t = - (0.25 M - 0.50 M)/44 s = 0.0057 M/s

Step 3: Calculate the rate of disappearance of N₂

The molar ratio of N₂ to H₂ is 1:3.

0.0057 mol H₂/L.s × 1 mol N₂/3 mol H₂ = 0.0019 mol N₂/L.s

Step 4: Calculate the final concentration of N₂

We will use the following expression.

[N₂] = [N₂]₀ - rN₂ × t

[N₂] = 1.25 mol/L - 0.0019 mol/L.s × 44 s

[N₂] = 1.17 M

Answer:

A 400,000 kg object and a 100,000,000kg object

Explanation:

The objects with the most mass between them will have the greatest gravitational attraction.

This is why the last option is the right choice.

The reason for this is based on the Newton's law of universal gravitation which states that:

 "the gravitational force of attraction between two bodies is directly proportional to the product of their masses and inversely proportional to the square of the distance between them".

So, the more the mass, the greater the gravitational attraction between two bodies.

Answer:

Molecules/State

Explanation:

We know from the kinetic molecular theory that matter is made up of molecules. These molecules are in constant motion at various velocities and energies.

The total thermal energy refers to the total kinetic energies of these particles. It depends on the temperature of the system, the energies of the molecules present in the material and the arrangement of the object's molecules (states of matter).

Answer:

predator

Explanation:

Wolves, arctic foxes, and snowy owls are predators in the tundra.