Need help with this

Answer:

Down is the recipe for momo..

Explanation:

recipe..

. Sieve the wheat flour carefully to remove lumps.

. Add water and knead the flour well to prepare a dough

. Remove the skin of the boiled potato ,cut into small pieces

. Heat the cooking oil in frying pan, and fry the pieces of onions cabbage green chili tomato pea etc.

. Prepare a mix veg stuffing by mixing potato other vegetables , green coriander and salt.

. Prepare a small balls of dough and roll it out of belna.

. Put 10 gm of mix vegetables stuff in the center of rolled dough and close it from all the sides to make a small ball.

. steam the momo for 10-15 minutes. After that it will be ready to serve.

. A sauce or pickle is usually eaten with momo.

Answer:

Explanation:

Sieve the wheat flour carefully to remove lumps.

Answer:

sodium bicarbonate solution

Answer:

thats pink floyds album cover LOL

but the answer is to prism

hope this helps :)

Answer:

Explanation:

0.180 moles of Ba(OH)2 are present.

Answer:

[tex]\boxed {\boxed {\sf 0.123 \ mol \ Ba(OH)_2}}[/tex]

Explanation:

Molarity is a measure of concentration in moles per liter. It is calculated using the following formula:

[tex]molarity= \frac{moles \ of \ solute}{liters \ of \ solution}[/tex]

The molarity of the solution is 0.600 M Ba(OH)₂. 1 molar (M) is also equal to 1 mole per liter, so the molarity is 0.600 moles of Ba(OH)₂ per liter.

The volume of the solution is 205 milliliters, however, we need to convert the volume to liters. Remember that 1 liter contains 1000 milliliters.

Now we know the molarity and volume, but the moles are still unknown.

Substitute these values into the formula.

[tex]0.600 \ mol \ Ba(OH)_2 /L = \frac{x}{0.205 \ L}[/tex]

We are solving for x or the moles of solute, so we must isolate the variable. It is being divided by 0.205 liters. The inverse of division is multiplication. Multiply both sides by 0.205 L.

[tex]0.205 \ L *0.600 \ mol \ Ba(OH)_2 /L = \frac{x}{0.205 \ L} * 0.205 \ L[/tex]

[tex]0.205 \ L *0.600 \ mol \ Ba(OH)_2 /L =x[/tex]

The units of liters cancel.

[tex]0.205 *0.600 \ mol \ Ba(OH)_2 =x[/tex]

[tex]0.123 \ mol \ Ba (OH)_2 = x[/tex]

The original measurements had at least 3 significant figures. Our answer currently has 3 sig figs, so we don't need to round.

There are 0.123 moles of barium hydroxide.

Answer:

electric balance, goggles, beaker

Explanation:

I did it and got it right

Answer:

3Fe(s)+2O2(g)---->Fe3O4

this way you will have 3irons on both sides and 4 oxygens.

I hope this helps

▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓

[tex]\boxed{\pmb{\red{\sf{3Fe(s) + 2O_{2}(g)\dashrightarrow Fe_{3}O_{4}(s)}}}}[/tex]

▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓▓

Answer:

None

Explanation:

Methylene is an organic compound and organic compounds consist of hydrogen atoms and Carbon atoms in n this case Methylene(CH2) has one carbon and two hydrogens .

Answer: methylene doesn't contain CL(chlorine) atoms

Explanation: the chemical formulae for Methylene is CH2

which means it contains only carbon and hydrogen atoms which is 1(one) carbon 2(two)hydrogen atoms

HOPE THIS HELPS!!

Utilizing a database search would be most effective for obtaining the data related to registered voters. The Option D.

A database search proves invaluable when seeking to retrieve specific information such as the total number of registered voters in a country. By querying the database with the appropriate parameters, you can efficiently extract accurate and up-to-date voter registration figures.

This method streamlines data collection by ensuring accuracy and reducing the potential for errors associated with manual collection processes.

Read more about database

brainly.com/question/518894

#SPJ1

Answer:

2

5

3

which experiment please involve a clip

Answer:

electrons are knocked off atoms, causing electricity to flow.

Explanation:

Answer:

C6H12O6+6O2--->6CO2+6H2O

Explanation:

So I went through all the answers and could not find the right one amongst. If I'm not wrong the reaction above is the reaction for respiration. The nearest answer is D but unfortunately the first reactant isn't in accordance with that which the question has given.

Answer:

sublimation. During this process, naphthalene being sublime changes into vapours leaving behind impurities. Vapour can be cooled by condensation. This process is very helpful in separating a volatile solid from a non-volatile solid.

Answer:

C

Explanation:

I believe the answer is C.

Answer:

17

Explanation:

i need points

Answer:

the anode material is graphite(replaceable graphite rods).

The oxygen gas burns away the anode as Carbon dioxide therefore the anode must be replaced continuously.

Answer:

Soda all start with watered down corn syrup. To get the carbonation companies have different ways of doing this all of which are very different. The last step is to add artificial and natural flavors like lemon and lime, this is also the step in which sugar and preservatives are added.

Explanation:

I hope this answer your question, srry I couldn't go into detail.

Answer: An exothermic reaction is a "reaction for which the overall standard enthalpy change ΔH⚬ is negative." Exothermic reactions usually release heat and entail the replacement of weak bonds with stronger ones.  

Exothermic reactions are important to forensic sciences and particularly to fire and explosion investigation. When a chemical reaction requires heat (rather than producing it) and results in cooling down the surroundings, it is conversely called endothermic.

Example-  

Respiration is a series of exothermic reactions that occur in the mitochondria of living cells in order to release energy from food molecules. This energy can then be used to produce heat, for movement, growth, reproduction and active uptake.

Hope it helps

Since perchloric acid is a strong acid, it will dissociate completely, along with water. The products will be Perchlorate ions and Hydronium ions after the Perchloric acid gave away its proton and water, acting as a base, accepted that abandoned proton.

Answer:

Hydrogen bromide, anhydrous appears as a colorless gas with a pungent irritating odor. Corrosive. Heavier than air. Prolonged exposure to fire or intense heat may result in the violent rupture and rocketing of the container. Long-term exposure to low concentrations or short-term exposure to high concentrations can result in adverse health effects from inhalation. Used to make other chemicals and as a catalyst in the manufacture of chemicals. Rate of onset: Immediate Persistence: Minutes to hours Odor threshold: 2 ppm Source/use/other hazard: Chemical manufacturing industry; very corrosive.

Explanation:

HBr

Answer: Fe hóa trị II trong các hợp chất: FeSO4, Fe(OH)2

Fe hóa trị III trong các hợp chất: Fe2(SO4)3, Fe(OH)3

Explanation:

El genotipo es el conjunto de información genética en un organismo, y se encuentra codificado en el ADN en su secuencia de bases. Dicha información se expresa mediante síntesis de proteínas.

1.  Los genes son unidades de herencia​ pues almacenan la información genética. El conjunto de genes de una especie se denomina genoma. Cada gen ocupa en el cromosoma una determinada posición, denominada locus. Para cada locus hay dos tipos o formas de genes, llamados alelos. Los mismos pueden ser iguales (siendo el organismo homocigota para ese locus) o distintos (heterocigota). Entonces, la respuesta es "b: Verdadero"

2. Los alelos dominantes, se representan con letras mayúsculas mientras que los alelos recesivos se representan con letras minúsculas. Ejemplo, el alelo que codifica para el color de ojos marrones puede ser dominante (se puede representar con la letra A, por ejemplo), mientras que el alelo que codifica para ojos verdes puede ser recesivo (a). Un individuo cuyo genotipo es Aa, tendrá ojos marrones ya que el alelo dominante enmascara los efectos del alelo recesivo. Un individuo AA también tendrá ojos marrones pues es el único alelo presente. Sin embargo, un individuo aa tendrá ojos verdes ya que tiene ambos alelos recesivos que se expresan. Entonces, la respuesta es "a: Falso"

3. Un cuadro de Punnett es un diagrama utilizado para determinar la probabilidad de obtener descendencia con un determinado fenotipo (características visibles) y genotipo (conjunto de genes). Permite utilizar genotipos maternos y paternos con sus alelos dominantes y recesivos , para cruzarlos y realizar el análisis. Entonces, la respuesta es "b: Verdadero"

4. Mendel realizó un experimento para estudiar los genes de la planta de guisantes. Cruzó una plantas de dos variedades distintas (gigantes y enanas), espolvoreando el polen de una sobre el pistilo de otra. Observó que en la primera generación de descendencia, habían todas plantas gigantes y no de tamaño "intermedio" Luego de esto, entendió que había una característica dominante para el tamaño gigante de una planta, y una recesivo para el tamaño enano. Pero previamente a todo esto, no conocía la dominancia ni el genotipo de los progenitores. Entonces, la respuesta es "a: Falso"

5. Una mutación es una alteración azarosa o por acción de un mutágeno en el ADN, ya sea en su secuencia de bases o en su organización. Esto hace que se produzca una variación en las características del organismo, que puede o no transmitirse a una descendencia. Una mutación genética hereditaria ocurre en las gametas femeninas (óvulo) y/o masculinas (espermatozoide). Cuando ocurre la fertilización, se crea un cigoto que dará lugar a un nuevo organismo que portará la mutación. Entonces, la respuesta es "b: Verdadero"

1. Cruce entre Aa x Aa

siendo A: verde, a: rojo

Cada genotipo, en este caso ambos Aa, representa los genes de un organismo. Sin embargo, en el cuadro de Punnett, se utilizan las gametas producidas por los mismos organismos. Cada gameta solo posee un alelo de cada gen, ya que son haploides. Entonces los organismos con genotipo Aa, pueden producir gametas A o a. (Ver archivo adjunto)

Como se puede ver en el cuadro, hay un 25% de probabilidades de obtener descendencia con genotipo AA (verde), 25% para aa (rojo) y 50% para Aa (verde). Lo mismo se puede expresar como 2:1:1 (de un total de 4, 2 son Aa, 1 es AA y 1 es aa). Recordando que el alelo A es dominante sobre a, la frecuencia fenotípica será de 75% verde y 25% rojo, lo que se puede expresar como 3:1 (de un total de 4, 3 son verdes y 1 es rojo).

Para concluir, recordemos que los genes codifican para las características visibles (fenotipo), y el conjunto de genes forma el genotipo. Para cada gen, hay dos alelos que ocupan un determinado locus o posición en el cromosoma y los mismos pueden ser dominantes o recesivos. Para estudiar esto, se pueden utilizar cuadros de Punnett en donde se cruzan organismos maternos y paternos, conociendo sus genes para así determinar el posible genotipo y fenotipo de la descendencia que puedan tener. Aunque hay que considerar que puede ocurrir una mutación en sus gametas, que se herede y afecte los genes y las características visibles.

Aprende mas sobre este tema aquí: https://brainly.com/question/22852761

Answer:

111. C .  M2O3

112. A. 5

Answer:

The first step in the Scientific Method is to make objective observations. These observations are based on specific events that have already happened and can be verified by others as true or false. Step 2. Form a hypothesis.

Answer:

False

Explanation:

The first step of the scientific method is to make an observation.

Answer:

36 electrons

Explanation:

But Bromine anion with a charge of -1 has one extra electron so 35 +1 = 36 electrons.

Answer:

b. stainless steel

Explanation:

b) stainless steel is not good condoctor of heat

Answer:

A

Explanation:

Because of the cathode