No,the poping of microvave is not same there time is different
A pumpkin is launched in the air and travels at a horizontal velocity of 25 meters per second for 5 seconds. How far does it travel horizontally?
Answer:
30.3 meters, 172 degrees
Explanation:
To insure the most accurate solution, this problem is best solved using a calculator and trigonometric principles. The first step is to determine the sum of all the horizontal (east-west) displacements and the sum of all the vertical (north-south) displacements.
Horizontal: 2.0 meters, West + 31.0 meters, West + 3.0 meters, East = 30.0 meters, West
Vertical: 12.0 meters, North + 8.0 meters, South = 4.0 meters, North
The series of five displacements is equivalent to two displacements of 30 meters, West and 4 meters, North. The resultant of these two displacements can be found using the Pythagorean theorem (for the magnitude) and the tangent function (for the direction). A non-scaled sketch is useful for visualizing the situation.
Applying the Pythagorean theorem leads to the magnitude of the resultant (R).
R2 = (30.0 m)2 + (4.0 m)2 = 916 m2
R = Sqrt(916 m2)
R = 30.3 meters
The angle theta in the diagram above can be found using the tangent function.
tangent(theta) = opposite/adjacent = (4.0 m) / (30.0 m)
tangent(theta) = 0.1333
theta = invtan(0.1333)
theta = 7.59 degrees
This angle theta is the angle between west and the resultant. Directions of vectors are expressed as the counterclockwise angle of rotation relative to east. So the direction is 7.59 degrees short of 180 degrees. That is, the direction is ~172 degrees.
2.(01.01 LC)
Which of the following is true for gravitational force? (3 points)
Decreases with increase in mass
Increases with increase in mass
Increases with increase in distance
Decreases with decrease in distance
Answer:
Increases with increase in mass
Explanation:
gravity is proportional to mass and inversely proportional to the square of the distance between them
F = GMm/d²
5) You pull a 10.0 kg wagon along a flat road. You exert a force of 80.0 N at an angle of 30.0 degrees above the horizontal while you move the wagon 10.0 m forward. The coefficient of friction between the wagon and road is 0.500. Calculate the work down by you and the work done by friction.
Consult the attached free body diagram. The only forces doing work on the wagon are the frictional force opposing the wagon's motion and the horizontal component of the applied force.
By Newton's second law, the net vertical force is
• ∑ F [v] = n + (80.0 N) sin(30.0°) - mg = 0
where a is the acceleration of the wagon.
Solve for n (the magnitude of the normal force) :
n = (10.0 kg) g - (80.0 N) sin(30.0°) = 58.0 N
Then
f = 0.500 (58.0 N) = 29.0 N
Meanwhile, the horizontal component of the applied force has magnitude
(80.0 N) cos(30.0°) ≈ 69.3 N
Now calculate the work done by either force.
• friction: -(29.0 N) (10.0 m) = -290. J
• pull: (69.3 N) (10.0 m) = 693 J
What are the two factors that affect the frictional force between objects
What is First Aid.
I mark u brainliest answer
Answer:
First aid refers to the emergency or immediate care you should provide when a person is injured or ill until full medical treatment is available.
Explanation:
A solid sphere starts from rest and rolls down a slope that is 6.4 m long. If its speed at the bottom of the slope is 5.3 m/s, what is the angle of the slope
From the relationship between acceleration a and g on an inclined plane, the angle of the slope is 13 degrees
Given that a solid sphere starts from rest and rolls down a slope that is 6.4 m long. The speed at the bottom of the slope is 5.3 m/s, the distance travelled is 6.4 m. That is,
Initial velocity U = 0 ( since it starts from rest)
Final velocity V = 5.3 m/s
distance S = 6.4 m
Let us first calculate its acceleration by using third equation of motion.
[tex]V^{2}[/tex] = [tex]U^{2}[/tex] + 2aS
[tex]5.3^{2}[/tex] = 0 + 2 x 6.4a
28.09 = 12.8a
a = 28.09 / 12.8
a = 2.2 m / [tex]s^{2}[/tex]
To calculate the angle of the slope, let us use the relationship between acceleration a and g on an inclined plane.
acceleration a = gsin∅
substitute all the relevant parameters
2.2 = 9.8 sin∅
sin∅ = 2.2/9.8
sin∅ = 0.224
∅ = [tex]Sin^{-1}[/tex](0.224)
∅ = 12.97 degrees
∅ = 13 degrees (approximately)
Therefore, the angle of the slope is 13 degrees
Learn more about inclined plane here: https://brainly.com/question/25845680
Calculate the torque produced by a 50.0 N perpendicular force at the end of a 0.300 m long wrench.
Answer:
Torque = 50N x 0.3m = 15Nm
Explanation:
Torque = Force x length of lever arm. To obtain the torque simply multiply the two given values.
What is the effect of erosion?
A. New land forms at the mouth of a river.
B. New land forms at the top of a mountain.
C. A mountain forms.
D. A fossil is created.
PLEASE HELP ME GET THIS RIGHT
Explanation:
I'm not sure, but I would go for the more than A since its orbital speed is at its fastest and the sweep occurs in about the same period of days.
HIHIHHHHHHHHIHIHIIHIHHHHIHIHIHIHIHIHIHIHIHIHIHIHIHIIH
Answer:
Ok thanks for the points though
Explanation:
Please write a paragraph explaining the bible verse below in your own words.
Exodus 16:19-20
Answer:
Moses had told them to not keep the food till morning but some kept some anyways because they probably thought they were going to starve or not have food the next morning but what I think it means is that you have to trust in God that he will provide for you and so when the people kept the food cuz he thought they were probably going to start of the next day it got maggots
Which light is most sensitive to the eyes?
Answer:
Our eyes are most sensitive to the wavelengths corresponding to the yellow and green colors of the spectrum. Flashy signs and some fire engines are painted in a yellowish-green color to attract our attention.
 A wooden box with a mass of 10.0 kg rest on a ramp that is incline at an angle of 25° to the horizontal. A rope attached to the box runs parallel to the ramp and then passes over a frictionless bully. A bucket with a mass of M hangs at the end of the rope. The coefficient of static friction between the ramp in the box is 0.50. The coefficient of Connecticut friction between the ramp in the box is 0.35.
Suppose the box remains at rest relative to the ramp. What is the maximum magnitude of the friction force exerted on the box by the ramp?
The maximum magnitude of the friction force exerted on the box by the ramp is 44.41 N.
The given parameters;
Mass of the box, m = 10 kgInclination of the ramp, θ = 25⁰Coefficient of static friction, μ = 0.5 Coefficient of kinetic friction, μk = 0.35The normal force on the wooden box is calculated as follows;
[tex]F_n = mg \times cos(\theta)\\\\F_n = 10 \times 9.8 \times cos(25)\\\\F_n = 88.8 2 \ N[/tex]
The maximum magnitude of the friction force exerted on the box by the ramp is calculated as follows;
[tex]F_f = \mu \times F_n\\\\F_f = 0.5 \times 88.82 \\\\F_f = 44.41 \ N[/tex]
Learn more about static frictional forces here: https://brainly.com/question/4515354
The force of earth’s gravity is 10N downward. What us the acceleration of a 15kg backpack if lifted with a a 15N force?
Answer:
F-F(gr) = ma
a= {F-F(gr)}/m =
=(15-10)/15=0.33 m/s² (upward)
If work stays the same and the distance is increased, then less force is needed to do the work.
True
False
Answer:
False
Explanation:
This is because the work is the same so the force won't change
what were your preparetion before going the different physical fitness test?
Answer:
Avoid heavy strenuous exercise for the 24 hours prior to testing. Do not exercise at all on the day of testing to ensure you are well rested. Wear appropriate clothing for the conditions (e.g. shorts/track pants and t-shirt/singlet/sports top) and non-slip athletic footwear with laces securely fastened
