when ph decrease that means acidity increase
when ph increase that means basicity increase
what apparatus is used to investigate the conductivity of solutions
What are isotopes_???
Answer:
Below!
Explanation:
Isotopes are elements with a similar chemical makeup and the same atomic number, but a different atomic mass and number of neutrons . An example of this would be carbon-12, carbon-13, and carbon-14. Three isotopes of the element carbon that have the same 6 protons but have a different neutron count. A simple way to explain isotopes would be to say that they are just different "versions" of an element.
Hope this helps ya! Best of luck <3
Determine the grams of sodium chloride produced when 10 g of sodium react with 10 grams chlorine gas according to the equation 2Na + Cl2 = 2 NaCl
Answer:
16 g
Explanation:
Step 1: Write the balanced equation
2 Na + Cl₂ ⇒ 2 NaCl
Step 2: Identify the limiting reactant
The theoretical mass ratio (TMR) of Na to Cl₂ is 46:71 = 0.65:1.
The experimental mass ratio (EMR) of Na to Cl₂ is 10:10 = 1:1.
Since EMR > TMR, Cl₂ is the limiting reactant
Step 3: Calculate the mass of NaCl produced
The theoretical mass ratio of Cl₂ to NaCl is 71:117.
10 g Cl₂ × 117 g NaCl/71 g Cl₂ = 16 g NaCl
I need help with b) c) and what is the electronic configuration of atom E
Answer:
(b) A and C belongs to same group.
(c) D is a non metal.
Explanation:
The Electronic Configuration of E is
[tex]1s {}^{2} 2s {}^{2}2p {}^{6} 3s {}^{2} 3p {}^{6} 4s {}^{2} [/tex]
Identify an element as a metal or a non-metal according to its position in the Periodic
Table
Answer:
Metals on the left of the Periodic Table.
Non-Metals on the top-right, plus Hydrogen.
Calculate the amount of mole(s) of CoF2 required to react with 12.8 moles of HCI.
CoCl2 + 2HF --> CoF2 + 2HCI
Explanation:
here's the answer to your question
What is known about a reaction with a positive enthalpy?
Answer:
"Endothermic reaction: In an endothermic reaction, the products are higher in energy than the reactants. Therefore, the change in enthalpy is positive, and heat is absorbed from the surroundings of the reaction."
Explanation:
When enthalpy is positive and delta H is greater than zero, this means that a system absorbed heat. This is called an endothermic reaction. When enthalpy is negative and delta H is less than zero, this means that a system released heat. This is called an exothermic reaction.
What does a high positive enthalpy mean?
The sign of q for an endothermic process is positive because the system is gaining heat. A chemical reaction or physical change is exothermic if heat is released by the system into the surroundings. Because the surroundings are gaining heat from the system, the temperature of the surroundings increases.
Learn more about the endothermic reaction here: brainly.com/question/6506846
#SPJ2
If 16.4 grams of calcium nitrate is heated as shown in the reaction:
2Ca(NO3)2 -> 2CaO + 4NO2 + O2.
Calculate the volume of nitrogen dioxide produced at STP.
Answer:
7.2
Explanation:
you first have to find the number of moles of nitrogen dioxide by using the number of moles for calcium nitrate and the mole to mole ratios
number of moles of calcium nitrate=mass/mm
=16.4/102
=0.16g/mol
then you use the mole to mole ratios
2 : 4
0.16: x
2x/2=0.64/2
x=0.32g/moles of nitrogen dioxide
then you use the formula for the volume
v=22.4n
=22.4×0.32
=7.2
I hope this helps
What is the concentration of a solution formed by diluting 25.0 ml of a 3.8M glucose solution to 250ml
Explanation : số mol glucose 3.8M là :
n = Cm . V = 3.8 . 25 =95
=> Cm khi pha loãng = [tex]\frac{n}{V}[/tex] = [tex]\frac{95}{250}[/tex] = 0.38M
According to molar concentration, the concentration of a solution formed by diluting 25.0 ml of a 3.8 M glucose solution to 250 ml is 0.38 M.
What is molar concentration?Molar concentration is defined as a measure by which concentration of chemical substances present in a solution are determined. It is defined in particular reference to solute concentration in a solution . Most commonly used unit for molar concentration is moles/liter.
The molar concentration depends on change in volume of the solution which is mainly due to thermal expansion. Molar concentration is calculated by the formula, molar concentration=mass/ molar mass ×1/volume of solution in liters.
In terms of moles, it's formula is given as molar concentration= number of moles /volume of solution in liters.In case of 2 solutions given it is calculated as M₁V₁=M₂V₂,on substitution, M₂=3.8×25/250=0.38 M.
Thus, the concentration of a solution formed by diluting 25.0 ml of a 3.8 M glucose solution to 250 ml is 0.38 M.
Learn more about molar concentration,here:
https://brainly.com/question/21841645
#SPJ5
Why doesn’t the KHP concentration have to be exactly 0.100M? Explain using complete sentences.
Answer:
The answer is in the explanation.
Explanation:
The KHP is an acid used as standard in titrations to find concentration of bases as NaOH.
The reaction that explain this use is:
KHP + NaOH → KNaP + H2O
where 1 mole of KHP reacts per mole of NaOH
That means, at equivalence point of a titration in which titrant is NaOH, the moles of KHP = Moles of NaOH added
With the moles of KHP = Moles of NaOH and the volume used by titrant we can find the molar concentration of NaOH.
The moles of KHP are obtained from the volume and the concentration as follows:
Volume(L)*Concentration (Molarity,M) = moles of KHP
If the concentration is more or less than 0.100M, the moles will be higher or lower. For that reason, we need to know the concentration of KHP but is not necessary to be 0.100M.
Can someone plz help me :<
Answer: cats r alliens because they r kind of like ufos they would usually wonder around rather u know it or not when they spy on us it could b with us sleep cooking anything so they r like aliens
Explanation:
All three states of matter can be ____________ or a solvent in a solution.
Question 2 Multiple Choice Worth 2 points)
(01.01 LC)
Which of the following is a characteristic of science?
O Reproducible by other scientists
The personal opinion of the scientist
Using vanable conditions for each test
O Including only the data that supports a hypothesis
Question 3 Multiple Choice Worth 2 points)
Answer:
Reproducible by other scientists
The personal opinion of the scientist
Using vanable conditions for each test
Explanation:
Which equation describes a physical change? i. H2O(s) ⟶ H2O(l) ii. Na+(aq)+Cl−(aq) +Ag+(aq)+NO3−(aq) ⟶ AgCl(s)+Na+(aq)+NO3−(aq) iii. CH3OH(g)+O2(g) ⟶ CO2(g)+H2O(g) iv. 2H2O(l) ⟶ 2H2(g)+O2(g) v. H+(aq)+OH−(aq)⟶ H2O(l)
Answer:
The answer is "Option i"
Explanation:
In this question, only option (i) is correct, and others were wrong which can be defined as follows:
In option (ii):
[tex]Na^+\ (aq)+Cl^- \ (aq) +Ag^+ \ (aq)+NO_3^- \ (aq) \to AgCl\ (s)+Na^+ \ (aq)+NO_3^-\ (aq) \\\\[/tex]
It is the complete ionic equation.
In option (iii):
[tex]CH_3OH\ (g)+O_2\ (g) \to CO_2\ (g)+H_2O\ (g)[/tex]
It is the combustion reaction but a not balanced equation.
In option (iv):
[tex]2H_2O\ (l) \to 2H_2\ (g)+O_2\ (g)[/tex]
It is the decomposition equation.
In option (v):
[tex]H^+\ (aq) +OH^-\ (aq)\to H_2O\ (l)[/tex]
It is the complete ionic equation.
Answer: Freezing point depression
Explanation:
freezing point depression is a phenomenon that describes why adding a solute or solvent results in the lowering of the freezing point of the solvent
2500m into kilometer
1 meter = 1000 km
2500 meter = 2500/1000 km
= 2.5 km
Which of the following is a common property of both strong acid and strong base?
a. They are good electrolytes
b. They are non-electrolytes
c. They are weak electrolytes
d. They are sour in test
Answer:
They are good electrolytes
why do we shake syrup medicines before drinking
Answer:
The label may instruct you to shake a liquid medicine before using so that the active ingredients are evenly distributed throughout it.
Explanation:
Answer:
maybe because if somehow the liquids get separated then shaking them up would mix them back to how they are suppose to be originally.
Explanation:
distinguish between sugar and non-sugar with examples.
Answer:
Reducing sugars are sugars where the anomeric carbon has an OH group attached that can reduce other compounds. Non-reducing sugars do not have an OH group attached to the anomeric carbon so they cannot reduce other compounds. ... Maltose and lactose are reducing sugars, while sucrose is a non-reducing sugar
Which sentence describes existing cells?
All cells, once formed, continue to live forever.
All cells come from previously existing cells.
All the cells that are on Earth have always been here.
All cells develop from the remains of other cells.
differentiate between Physical and chemical changes
Answer:
In a physical change the appearance or form of the matter changes but the kind of matter in the substance does not. However in a chemical change, the kind of matter changes and at least one new substance with new properties is formed.
I HOPE THIS WILL HELP YOU IF NOT THEN SORRY HAVE A GREAT DAY:)Describe the principle and process for the manufractured of sulphuric acid witha a well labeled diagram by contact process.
The steps involved in the manufacture of sulphuric acid by contact process:
(1) Sulphur (or iron pyrites) are burnt in air to form sulphur dioxide.
S+O2→SO24FeS2+11O2→2Fe2O3+8SO2
(2) Catalytic oxidation of sulphur dioxide to sulphur trioxide.
2SO2+O2V2O52SO3ΔrHo=−196.6kJ
The reaction is reversible and exothermic.
(3) Sulphur trioxide is dissolved in 98% sulphuric acid to form oleum (fuming sulphuric acid).
SO3+H2SO4→H2S2O7
(4) Oleum is diluted with water to form sulphuric acid of desired concentration.
H2S2O7+H2O→2H2SO4
and
Manufacture of H2SO4 by contact process involves three steps:
1. Burning of sulphur in air to generate SO2.
2. Conversion of SO2 to SO3 by oxidation with air in the presence of
how can we separate the sugar from sugar solution
Is water the only liquid? If not, name 5 more
Answer:
Is water the only liquid? If not, name 5 more
Water, ethanol, household bleach, blood, paint, milk, gasoline, mineral oil, acetone and butyl alcohol are examples of liquids. Liquids' properties allow them to flow or be poured easily into containers, lava
water is not the only liquid.
Answer:
apple juice, milk, smoothie, blood, urine
what is meant by reaction element
Answer: A reaction element are those elements that can take part in a chemical reaction.
Explanation:
An element is made up of atoms that has the same atomic number. It is the basic material of which all matter is composed of. These elements cannot be broken down further into smaller substances by any chemical reaction. Each element has a unique number of protons in its atom. For example,
--> a hydrogen atom has 1 proton,
--> a Helium atom has 2 protons,
--> a Lithium atom has 3 protons, and
--> a carbon atom has 6 protons.
A chemical reaction on the other hand involves rearrangement of the constituent atoms of reactants to create different substances as products. The bonds between atoms are either broken or created to form new molecules. There are different types of chemical reaction which includes:
--> Decomposition reaction
--> Neutralization reaction
--> single displacement reaction and
--> combustion reaction.
Question 10 of 10 A certain seed is surrounded by a sticky coating. It is fairly dense and does not float in water. How is this seed most likely spread?
A. It is dispersed by the wind, and it sprouts after it falls to the ground
B. It drops to the bottom of a body of water, where it sprouts.
C. It attaches to the fur of an animal, and it sprouts after it falls from the animal's fur.
D. Animals eat it, and it is deposited in their waste.
write an importance of endothermic reactions
Answer:
the uses of exothermic reactions are:
1) lighting of stove
2) self heating cans
3) hand warmers
4) in some case exothermic process can be used to cook food such as rice (by adding calcium oxide to water heat is evolved and it helps to cook food )
Explanation:
hope this helps you pls mark me as brainilst
True or false, The four units that must always be used when using the ideal gas are 44.0 liters
Answer:
for volume only liters can be used
Explanation:
7. What measures are applicable in the context of Nepal to push energy crisis further. Describe any three points clearly.
Answer:
which energy?........
Explanation:
..........................
........
....
The atomic mass of calcium is calculated by adding the mass (amount) of
A) Protons and Electrons
B) Protons and Neutons
C) Electrons and Neutons
D) Protons and Protons
Answer:
B. Protons and Neutrons
Answer:
Option"B" is correct.
MARK ME BRAINLISTS
