The graph below shows the solute concentration inside a paramecium over time. What is happening at the time indicated by the pointer?
Water is moving rapidly into the paramecium by osmosis.
Water is moving rapidly out of the paramecium as the contractile vacuole contracts.
The paramecium is having a meal.
Solutes from the surrounding water are diffusing through the cell membrane, causing the solute concentration inside the paramecium to rise.
Answers
The pointer indicated the point at which water is moving rapidly out of the paramecium as the contractile vacuole contracts.
The pointer specifically indicates where the water solute concentration dropped. In order for the solute concentration of the water to drop, more water would have to be added.This means that water from the paramecium moves into the surrounding water as the contractile vacuole contracts. Consequently, the solute concentration of the surrounding solution decreases. When water moves from the solution into the paramecium, the solute concentration increases and this forms a continuous cycle in the graph.More on water movement by osmosis can be found here: https://brainly.com/question/21395644?referrer=searchResults
Related Questions
A bar of copper (Copper = 0.385 J/g.°C) and a bar of aluminum (Aluminum = 0.897 J/g.°C) have the same mass. Which requires more energy to increase the temperature from 20°C to 30 °C?
Answers
Answer:
Aluminum
Explanation:
Please help. A 208 g sample of sodium-24 decays. How much of this radioactive isotope will remain after 3 half
lifes?
Answers
Answer: The information about sequential order of the event occurred in the past can be obtained by using only relative dating method.
Explanation:
Relative dating method doesn’t give information about when it happened. It provides sequential order of the events. It is the art of deciding the overall happening of past occasions (i.e., the age of an item in contrast with another), without fundamentally deciding their outright age (for example evaluated age).
In topography, shake or shallow stores, fossils and lithologies can be utilized to correspond one stratigraphic segment with another.
Which of the following shows a valid combustion reaction?
2Al + 2O2 → 2AlO + O2
C2H4 + 3O2 → 2CO2 + 2H2O
2CH4 + O2 → 2CO + 4H2
Ca + O2 → CaOH
Answers
Answer: C2H4 + 3O2 → 2CO2 + 2H2O
Explanation:
2Al + 2O2 → 2AlO + O2 Not Balanced Properly: 2Al + O2 = 2AlO
C2H4 + 3O2 → 2CO2 + 2H2O Looks Good
2CH4 + O2 → 2CO + 4H2 Not Correct: CO should be CO2
Ca + O2 → CaOH Not Balanced and No source for the H
Answer:
2H4+3O2 →2CO2+2H2
Explanation:
What is infrared energy? simplify it
Answers
Answer:
It is a type of radiant energy that's invisible to human eyes but that we can feel as heat.
fork is a metal or nonmetal ?
Answers
what is the name of the high-energy compound that cells use to fuel chemical reactions?
Answers
Answer: Adenosine triphosphate, or ATP, is the primary carrier of energy in cells. The water-mediated reaction known as hydrolysis releases energy from the chemical bonds in ATP to fuel cellular processes.
Explanation:
Why is the Milky Way considered a galaxy
Answers
Answer:
Explanation:
All the stars we see in the night sky are in our own Milky Way Galaxy. Our galaxy is called the Milky Way because it appears as a milky band of light in the sky when you see it in a really dark area.
Answer: it is
Explanation: A galaxy is a system of millions or billions of stars, together with gas and dust, held together by gravitational attraction, plus there are 100 billion planet in it.
help me please the subject is siecnce
Answers
Answer:
okay your question in science
An iron object alloyed with cobalt rusts more quickly than a pure iron object. However, an iron object alloyed with manganese rusts less quickly than a pure iron object under the same conditions. This is true because: __________
a. cobalt is a stronger reducing agent than iron
b. iron is a stronger reducing agent than manganese
c. cobalt exhibits more metallic character than either iron or manganese in the iron-manganese alloy
Answers
Rusting is an electrochemical reaction. Iron rusts faster when alloyed with cobalt than when alloyed with manganese because, in the iron-manganese alloy, manganese is rendered the anode and iron is rendered the cathode
An alloy is a combination of two metals. There are various reasons for producing alloys such as greater tensile strength, corrosion resistance and improved aesthetic appearance.
When iron is alloyed with cobalt, the iron rusts faster than pure iron because iron is rendered the anode and cobalt is rendered the cathode. When the iron is alloyed with manganese, it rusts more slowly than pure iron because in the iron-manganese alloy, manganese is rendered the anode and iron is rendered the cathode.
Missing parts;
An iron object alloyed with cobalt rusts more quickly than a pure iron object. However, an iron object alloyed with manganese rusts less quickly than a pure iron object under the same conditions. This is true because
(1) cobalt is a stronger reducing agent than iron
(2) iron is a stronger reducing agent than manganese
(3) cobalt exhibits more metallic character than either iron or manganese
(4) in the iron-manganese alloy, manganese is rendered the anode and iron is rendered the cathode
(5) in the iron-cobalt alloy, cobalt is rendered the anode and iron is rendered the cathode
Learn more: https://brainly.com/question/14281129
Choose the statement that is TRUE. Question 26 options: Outer electrons efficiently shield one another from nuclear charge. All of the answers are true Valence electrons are most difficult of all electrons to remove. Core electrons effectively shield outer electrons from nuclear charge. Core electrons are the easiest of all electrons to remove.
Answers
The statement which is true is Core electrons effectively shield outer
electrons from nuclear charge.
Core electrons are those which are in close proximity with the nucleus. The
core electrons repel the outer electrons farther away from the nucleus to
shield it from nuclear charge.
The valence electrons are usually found in the outermost part of the shell
and they are the easiest to remove due to the fact that they have to achieve
a stable octet configuration which makes them easily removed during
chemical reactions.
Read more on https://brainly.com/question/371590
Answer: core electrons effectively shield outer electrons from nuclear charge
Explanation:
An atom of sodium has 11 electrons. Make a sketch of a sodium atom, showing how many electrons it has at each energy level. Infer how reactive sodium atoms are.
SOMEONE HELP ME PLEASE :(. I DONT GET IT :(
Answers
What is the frequency of light with a wavelength of 450 nm?
Answers
Answer:
The frequency of blue light that has a wavelength of 450 nm is 6.7×1014 6.7 × 10 14 Hz.
Explanation:
BRAINLIEST?
does anyone know how to find the electron configuration of an element without using a periodic table?? group and period is already given
Answers
For example, writing the electronic configuration of Fe(28)
I recommend that you memorize the aufbau principle. Once you learn it, you don’t need anything else except the atomic number of the element to write it’s electronic configuration.
How do erosions affect land forms?
Erosion is the only cause of land form changes.
Land forms can be created by erosion.
Erosion can prevent land forms from being built.
Land forms can only be created through erosions.
Answers
Answer:
the anwser is landforms can be created by erosion
Explanation:
How does a phase change from solid to liquid occur in a substance?
A. Heat energy is released from the substance, weakening the electrical attraction between molecules.
B. Heat energy is released from the substance, strengthening the electrical attraction between molecules.
C. Heat energy is added to the substance, weakening the electrical attraction between molecules.
D. Heat energy is added to the substance, strengthening the electrical attraction between molecules.
Answers
Answer:
see below
Explanation:
1. Heat energy is added to the substance, weakening the electrical attraction between molecules.
2. Both the melting point and boiling point are lower.
3. dipole
4. Water and ethanol have different molecular structures.
5. The lone pairs of electrons in the oxygen atom causes the molecule to be bent; the oxygen atom has a partial negative charge, while the hydrogen atoms have partial positive charges.
[quizlet: captncrun]
Heat is a form factor that changes the solid from light to light to gaseous mediums. The phases take place in a cyclic manner.
The solid to liquid changes take place due to the melting or fusion, solid to gas take lace through the sublimation, liquid to gas is by vaporization, and gas to liquid is condensation. Thus the heat is added and leads to the weakening of the electrical attraction within the molecules.Hence the correct option is C.
Learn more about the phase change from solid to liquid occur in a substance
brainly.com/question/25664350.
Please help This is for my chemistry class and I need to get it done but I’m lost and need answers
Answers
Answer:
chlorine is a non metal.
sodium is a alkali metal.
helium is a noble gas.
nickel is a transition metal
Rank the following molecules (1st, 2nd, 3rd, 4th) in the order that they melt.
Sucrose
Iodine
Sodium
Paraffin
There is a picture attached
Answers
Sodium chloride has the highest melting point while iodine has the least melting point.
The melting points of solid substances depends on the nature of intermolecular forces that exists in the substance. The stronger the magnitude of intermolecular forces in a substance, the higher its melting point.
The order of melting points of the solids shown in question is as follows;
1st - Sodium chloride2nd - sucrose3rd - paraffin4th - IodineSodium chloride has the highest melting points because it is an ionic substance. Among the molecular sucrose and paraffin, sucrose has a higher melting point than sucrose because it has a greater molar mass. Iodine, a molecular substance has the least molar mass and the least melting point in the list.
Learn more: https://brainly.com/question/25777663
Help
What is the correct orientation of the bar magnet, based on the magnetic field
lines shown?
A. South pole on the top edge and north pole on the bottom edge.
B. North pole on the top edge and south pole on the bottom edge
C. South pole on the left end and north pole on the right end
D. North pole on the left end and south pole on the right end
Answers
Answer:
b
Explanation:
north is up south is bottom
Answer:
C. South pole on the left end and north pole on the right end
Explanation:
From the figure, we can conclude that the poles of the magnet are on either sides of the magnet
Therefore, options 1 and 2 are excluded
It is a convention that the magnetic field lines move out of the north pole of a magnet and into the south pole of the magnet
From the figure, we can see that the magnetic field lines are moving out from the right end and into the left end
This means that the north pole is at the right end and that the south pole is at the left one
Which ingredients are needed to transform nadp to nadph?.
Answers
Answer:
according to online:
"Hydrogen ions are transported with the electrons along the chain of reactions. In photosystem I, the electrons are energized, and the energy is stored in molecules of NADP+. During these reactions, the NADP+ molecules are reduced by the addition of electrons. A hydrogen ion is added to NADP+ to form NADPH."
Explanation:
hope this helps!! :)
how well did the landmases fit together this time
Answers
Answer:
The theory of continental drift is most associated with the scientist Alfred Wegener. In the early 20th century, Wegener published a paper explaining his theory that the continental landmasses were “drifting” across the Earth, sometimes plowing through oceans and into each other. He called this movement continental drift.
Explanation:
Electrons are shared. Is it Ionic bond, covalent bond or both?
Answers
Answer:
covalent bond
Explanation:
ionic bond is when electrons are transferred by atoms not shared
when calculating specific heat what if the change in temperature is negative?
Answers
Answer:
If AT and q are negative, then heat flows from an object into its surroundings. If a substance gains thermal energy, its temperature increases, its final temperature is higher than its initial temperature, then AT>0 and q is positive.
what type of intermolecular force causes the dissolution of nacl in water?
Answers
Answer:
ion-dipole forces
Explanation:
positive sodium ion will be attracted to the slightly negative oxygen atoms in the water molecule, while the negative chloride ion is attracted to the slightly positive hydrogen atoms.
Valence electrons are electrons in the ? of an atom.
Answers
Answer:
Valence electrons are the outermost of electrons.
Explanation:
valence electrons are the outermost electrons of an atom located in the shell/ orbit
Chemical properties of water and oxygen for class 8
Answers
What is the role of cellular respiration in organisms?
to provide energy for photosynthesis
to provide energy for breaking apart fuel molecules
to provide energy for making oxygen
to provide energy for cell activity
Answers
Answer:
C. sorry if I'm wrong ...................
Which of the following best describes the cell below
plant cell
Protist cell
Eukaryotic cell
Prokaryotic cell
Answers
Answer:
Prokaryotic cell
Explanation:
If you search it up you will see that the prokaryotic cell looks exactly alike with the picture you have posted.
whats the formula for lithium nitride
Answers
Answer:
Lithium nitride. Trilithium nitride. 26134-62-3. Lithium nitride (Li3N) Li3N.
Most elements are ____________. The _____________ elements on the left of the stair-step line on the ______________ of Elements are metals or metal-like _____________. Some of the physical properties of metals are ______________ (shininess) and ___________ density. They are also good conductors of ___________ and ______________. Metals can be hammered into __________sheets.
Answers
Answer:
metals, 88 , periodic table , luster , heat, electricity , thin, right, opposite , appearance , luster , malleable , ductile, opposite , shiny, moderately
Explanation:
metals, 88 , periodic table , luster , heat, electricity , thin, right, opposite , appearance , luster , malleable , ductile, opposite , shiny, moderately Is the answer.
(Hope this helps can I pls have brainlist (crown)☺️)
When pyridine is treated with a mixture of nitric and sulfuric acids, the major product is:.
Answers
Answer: 3-nitropyridine
Explanation:
