The sky is blue because: Select one: a. the index of refraction for air is slightly larger for blue than for red b. atomic hydrogen is blue c. air molecules tend to polarize light along a horizontal axis d. oxygen and nitrogen molecules are small compared to the wavelengths of visible light e. oxygen molecules have a lower energy ground state than nitrogen molecules

Answer:

The spring constant is approximately 2.84 N/m

Explanation:

The height of the building, h = 828 m

The mass of the billionaire that has an office on the top floor, m = 120 kg

Gravitational potential energy, P.E. = m·g·h

Where;

g = The acceleration due to gravity ≈ 9.81 m/s²

The gravitational potential energy of the billionaire at the top floor is therefore;

P.E. of billionaire at top floor = 120 kg × 9.81 m/s² × 828 m  = 974,721.6 J

The elastic potential energy of the spring, [tex]P.E._{spring}[/tex] is given as follows;

[tex]P.E._{spring} = \dfrac{1}{2} \cdot k \cdot h^2[/tex]

Where;

k = The spring constant of the spring in N/m

h = The extension of the spring = The height of the building = 828 m

Given that the energy of the spring is conserved, we have;

[tex]P.E._{spring}[/tex] = P.E. of billionaire = 974,721.6 J

Plugging in the values gives;

[tex]P.E._{spring} = 974,721.6 \ J = \dfrac{1}{2} \times k \times (828 \ m)^2[/tex]

Therefore;

2*974,721.6/(828^2)

[tex]k = \dfrac{2 \times 974,721.6 \ J}{(828 \ m)^2} \approx 2.84 \ N/m[/tex]

The spring constant, k ≈ 2.84 N/m.

Explanation:

The answer is Electrons move between objects.

Answer:

Correct option is C it decreases by a factor of 2

Answer: A - it increases by a factor of 4

Explanation:

Ohm's law is V = IR where V = potential difference, I = current, and R = resistance. Assuming that resistance stays constant (since the question mentioned no change in resistance), we only need to look at "V" and "I" in the equation V = IR.

"V" and "I" are directly proportional. In other words, whatever change happens to "V" will also occur to "I". Since "V" increases by a factor of 4, then "I" will also increase by a factor of 4.

You could also approach this problem by plugging in a change of 4 for the potential difference in the equation: V = I*R.

If we plug in 4V for V, we now have:

4V = I*R

Since the left side increases by a factor of 4, then the right side (only looking at current in this case) will also need to increase by a factor of 4 in order to have the right side stay equal to the left. Therefore, current will also increase by a factor of 4.

Answer:

a. X: Slower in gases than liquids Y: Faster in solids than gases Z: Velocity depends on medium.

Explanation:

Speed of sound is fastest in solids. Sound waves travel more quickly in solid, than of liquid and gases. Sound waves travel most slowest in gases. Speed of sound varies significantly and it depends upon medium it is travelling through.  In more rigid medium sounds velocity will be faster.

Answer:

cant see picture

Explanation:

Answer:

please add picture so i can help you

Explanation:

we call it as well as 100 . so easey

Answer:

10 squared

Explanation:

10 squared

In Depth:

Let have a square that has a side length of 10.

A square four sides are equal and if we find the area of a squared, our formula is

[tex] {s}^{2} [/tex]

Our in this instance,

[tex] {10}^{2} [/tex]

or we call it

[tex]10 \: \: squared[/tex]

Answer:

The time required is 0.45 s.

Explanation:

Height, h = 1 m

initial velocity, u = m/s

Let the time is t.

Use second equation of motion

[tex]h = u t + 0.5 at^2\\\\1 = 0 +0.5 \times 9.8 \times t^2\\\\t = 0.45 s[/tex]

At the ball's highest point, it has no vertical velocity, so the 6 m/s is purely horizontal. A projectile's horizontal velocity does not change, which means the ball was initially thrown with speed v such that

v cos(53°) = 6 m/s   ==>   v = (6 m/s) sec(53°) ≈ 9.97 m/s

The player shoots the ball from a height of 2.0 m, so that the ball's horizontal and vertical positions, respectively x and y, at time t are

x = (9.97 m/s) cos(53°) t = (6 m/s) t

y = 2.0 m + (9.97 m/s) sin(53°) t - 1/2 gt ²

Find the times t for which the ball reaches a height of 3.00 m:

3.00 m = 2.0 m + (9.97 m/s) sin(53°) t - 1/2 gt ²

==>   t ≈ 0.137 s   or   t ≈ 1.49 s

The second time is the one we care about, because it's the one for which the ball would be falling into the basket.

Now find the distance x traveled by the ball after this time:

x = (6 m/s) (1.49 s) ≈ 8.93 m

Answer:

False.

Explanation:

Tensile strength should remain constant, regardless of thickness. For larger cross sections, it can slightly increase because the atoms in the center become more constricted and therefore less responsive to the applied stress.

Answer:

Tensile strength should remain constant, regardless of thickness. For larger cross sections, it can slightly increase because the atoms in the center become more constricted and therefore less responsive to the applied stress.FALSE

Answer:

c

Explanation:

Answer:

sodium

Explanation:

it is highly reactive metal.

Answer:

aluminium

Explanation:

In a period , as we go from left to right in a periodic table, atomic number increases .

Differentiating electrons enters into same shell hence the effective nuclear charge decreases .

Hence atomic radius decreases along period.

Conculsion:

Aluminium is the element which has greater atomic radius and sulphur has smaller atomic radius.

Answer:

An artificial satellites revolves around the earth under the influence of its gravitational force. So it does not require any energy to revolve around energy.

or maybe god:)))(

Answer:

The diagram assigned B

explanation:

Check the direction of the two vectors, their resultant must be in the same direction.

Answer:

This difference is kept to a minimum because the resistance in transformers is a few tens of ohms and the resistance of modern voltmeters is of the order of MΩ.

Explanation:

A voltmeter is built by a galvanometer and a resistance in series, this set is connected in parallel to the resistance where the voltage is to be measured, therefore the voltage is divided between the voltmeter and the element to be measured, consequently the measured voltage It is less than the calculated one, since for them the resistance of the voltmeter is assumed infinite.

This difference is kept to a minimum because the resistance in transformers is a few tens of ohms and the resistance of modern voltmeters is of the order of MΩ.

Answer:

You need time buddy

Explanation:Exactly honest

Explanation:

→ Volume of cone = πr² × h/3

Here,

→ Volume of cone = π(13)² × 27/3 cm³

→ Volume of cone = 169π × 9 cm³

→ Volume of cone = 1521π cm³

→ Volume of cone = 1521 × 22/7 cm³

→ Volume of cone = 33462/7 cm³

→ Volume of cone = 4780.28 cm³

Answer:

4,778.4 is correct

Explanation:

Answer:

a) i) x = 0.25 m, ii) x = 0.10 m, iii)  x = 0.050 m

b) i)  x = 0.40 m

Explanation:

a) For this exercise we use the rotational equilibrium equation, where we assume that the anticlockwise rotations are positive.

1) L = 2W  

we set our reference system in the center of the bar where the fulcrum is

              ∑τ = 0

              W 0.50 - L x = 0

              x = 0.50 W / L

we substitute the value

              x = 0.50 W / 2W

              x = 0.25 m

ii) L = 5W

we calculate

              x = 0.50 W / 5W

              x = 0.10 m

iii) L = 10 W

               x = 0.50 W / 10W

              x = 0.050 m

b) a new weight is placed at x₂ = 30 cm on the left side

              W 0.50 + W 0.30 - L x = 0

              x = (0.50 + 0.30) W / L

              x = 0.80 W / L

we calculate

i)  L = 2W

                x = 0.80 w / 2w

                x = 0.40 m

Answer:

yes Compression and rarefaction are commonly used with longitudinal waves. And Crests and trough are commonly used with transverse waves!

Explanation:

Answer:

A certain source of 12V with an internal resistance 1colomb is connected to 5colomb external resistance what is the current

Answer:

2000g

Explanation:

volume=mass/density

=2000/2.5

=800cm³

mass=density×volume

=800×2.5

=2000g

Answer:

The brightness of a light depends on the amplitude of the light wave, which is the extent the waves moves from their equilibrium position. The brightness is also related to the amount of light that is emitted or reflected by an object

Therefore, compared to dim light, light that look bright have a higher amplitude and emit or reflect more light energy (photons)

Explanation:

The solubility of the sample will decrease

Answer:

1. 7.5 m

2. towards west side

explanation:

I hope it will help you

Answer:

Explanation:

1. Free fall implies an object falling under the gravitational influence only. During the flight, no other force acts on it except the gravitational pull.

2. Acceleration due to gravity is the earth's natural force of pull on all objects on its surface, close to its surface, or in the region where the force can be felt. This force pulls object to the surface of the earth.

3. Escape velocity is the required minimum velocity for an object to leave the gravitational influence of the earth. It has a constant value which can be determined by;

Escape velocity = [tex]\sqrt{2gR}[/tex]

where g is the gravitation force of the earth and R is the radius of the earth.

4. Centripetal force is the force of pull that is required to keep a rotation object in its curved path.

Answer: If we leave liquid butane in a bowl on a table in a room where the temperature is [tex]24^{o}C[/tex], butane will evaporate.

Explanation:

A temperature at which the the liquid and gaseous phase of a substance of a substance are present in equilibrium with each other is called boiling point.

For example, the boiling point of butane is -1.5 degree Celsius.

This means that at a temperature above -1.5 degree Celsius, butane will exist is gaseous state. That is, at a temperature of 24 degree Celsius butane will evaporate.

Thus, we can conclude that if we leave liquid butane in a bowl on a table in a room where the temperature is [tex]24^{o}C[/tex], butane will evaporate.

Answer:

(a) 37.5 kg

(b) 4

Explanation:

Force, F = 150 N

kinetic friction coefficient = 0.15

(a) acceleration, a = 2.53 m/s^2

According to the newton's second law

Net force = mass x acceleration

F - friction force = m a

150 - 0.15 x m g = m a

150 = m (2.53 + 0.15 x 9.8)

m = 37.5 kg

(b) As the block moves with the constant speed so the applied force becomes the friction force.

[tex]F = \mu m g \\\\150 = \mu\times 37.5\\\\\mu = 4[/tex]

Answer:

television,radios, microwave ovens, telephone system and computer