Which of the following shows a valid combustion reaction?

2Al + 2O2 → 2AlO + O2
C2H4 + 3O2 → 2CO2 + 2H2O
2CH4 + O2 → 2CO + 4H2
Ca + O2 → CaOH

Answer:

The reaction quotient!

Explanation:

hope this helped :D

Answer:

you did not give the specific heat like formula like it takes 1kj to raise 28grams of water by 10 grams

The energy of the photon with a frequency of 9.50×10¹³ Hz is 6.29×10¯²⁰ J

From the question given above, the following data were obtained:

Frequency (f) = 9.50×10¹³ Hz

Planck's constant (h) = 6.626×10¯³⁴ Js

The energy of the photon can be obtained as follow:

E = hf

E = 6.626×10¯³⁴ × 9.50×10¹³

Therefore, the energy of the photon is 6.29×10¯²⁰ J

Learn more: https://brainly.com/question/7957705

Explanation:

after learning more about the position and would

Actuating mechanism is the dry-chemical fixed application method which

introduces a concentration of agent into a closed area.

The actuating mechanism is commonly used in piping systems and

involves the transport of a control member in automatic or remote control

systems.

The closed system makes manual navigation very difficult which is why the

actuating mechanism in automatic systems are usually used to make it less

tedious and accurate.

Read more on https://brainly.com/question/19914723

Answer:

the difference is  the presence of a carbon atom

Explanation:

Answer:

Mg (NO3)2

24 + 2×(14+ 3×16)

24+2×(14+48)

24+2×(62)

24+ 124

=148g

In this exercise we want to calculate the amount of moles, so this is going to be:

[tex](4.6)(10^{-3}) \ mols \ CO_2[/tex]

Knowing that Henry's law is given by:

[tex]C = KHP[/tex]

Where constants are given by:

Before we can find the concentration of CO2 (and hence the moles of CO2), we first need to find its partial pressure.  We look up the vapor pressure of water at 25º and find it to be 0.03 atm.  Since the total pressure is equal to 0.1 atm, this mean the partial pressure of:

[tex]CO_2 = 0.1 \ atm - 0.03 \ atm = 0.07 \ atm[/tex]

Now using Henry's law, we find the concentration:

[tex]C = (0.033)*( 0.07) = (2.31)*(10^{-3})[/tex]

Converting to moles of CO2, we have:

[tex](2.31)*(10^{-3})*( 2) = (4.6)*(10^{-3})[/tex]

See more about concentration at https://brainly.com/question/3045247

Answer:

First shell is lower

Explanation:

The electron has to absorb energy to excite and go to higher energy levels/ shells and should release energy to go to lower energy levels/ shells. This means higher the shell , more energy is required and vice versa

Answer:

b

Explanation:

Answer:

Freeze wedging is caused by the repeated freeze-thaw. Frost wedging occurs as the result of 9% expansion of water when it is converted to ice. Cracks filled with water are forced further apart when it freezes.

Explanation:

The burning of fossil fuels contributes to the addition of greenhouse gases to the atmosphere. These gases trap thermal energy in the Earth's atmosphere.

The materials which contain hydrocarbons which are generated from the remains of decay of plants and animals that are buried underground for many years are called fossil fuels.

The burning of fossil fuels can affect the environment, climatic conditions and human health. The burning of fossil fuels produces large amount of green house gases like CO₂, CH₄, etc. The increase in the amount of green house gases increases the heat and temperature of the earth's surface which leads to global warming.

The increase of temperature due to global warming can cause rise in the sea level, the glaciers of the earth will melt and coastal areas will be submerged under water due to this.

The burning of fossil fuels also releases toxic gases like SO₂, NO₂ which can cause acid rain and the emission these gases causes air pollution.

Thus the burning of fossil fuels has adverse effects.

To know more about fossil fuels, visit;

https://brainly.com/question/29770775

#SPJ6

Answer:

c the answer is c that is the answer

Answer:

Pretend you are a TV producer. Think of ideas for new TV shows. Your objective is to create ideas that will be successful, regardless of whether this is quality programming or not. Think of an idea of a copy. Explain the basics of what this show will be like and what show it is copying. Explain why you feel this show will be popular. Think of an idea of a spin-off. Explain the basics of what this show will be like and what show it is spinning off from. Explain why you feel this show will be popular. Think of an idea for a TV show that falls into one of the genre categories listed in the genre chart. Describe the basics of the show and how it falls under the genre’s expectations for characters, plots, and aesthetics. Explain why you feel this show will be popular.

Answer:

Q = mcT ...you can either substitute the molar heat capacity of water in the place of c or the specific heat capacity of water.

Explanation:

Answer:

Similar: both processes of cell division; both processes take place in the nucleus of the cell

Different: mitosis divides into 2, meiosis divides into 4; one is the division of body cells and the other is of specifically sex cells

Explanation:

https://byjus.com/biology/mitosis-and-meiosis/

^ this has more info!

Answer:

being cation it migerates to cathode to be reduced to elemental magnesium

Explanation:

Mg+2. +2e -----------Mg

Answer: Place a piece of white paper under the analyte flask throughout the titration

Explanation:

The end point of titration can be made easy by the use of indicators. But we have to be keenly observe for each drop from the burette because, the colour change will be sudden for a drop.

Titration is an analytical technique used to determine the unknown concentration using a standard reagent of known concentration. The standard reagent of known concentration is called titrant and the  one to be determined is called analyte.

Usually analyte is taken in a conical flask and titrant in a burette. The end point of titration is the point at which the reaction is completed in perfect stoichiometry.

In acid-base titrations, the indicators used having different colors in different pH. Hence, the indicator in the analyte will change in color when the acidity of the medium changes. We have to observe keenly for the color change because it happens for any drop.

The adding of titrant from the burette must be dropwise and thus we can get a time to notice the sudden colour change of indicator.

To get more about titration indicators, refer the link below:

https://brainly.com/question/27419598

#SPJ5

Por definición de enlace iónico, covalente y regla del octeto, la relación existente entre la teoría del octeto de Lewis con los enlaces iónicos y  covalentes es que dichos enlaces se producen con el objetivo de completar la última capa de electrones y adquirir estabilidad.

Por un lado, se produce un enlace iónico entre átomos metálicos y no metálicos, donde los electrones se transfieren completamente de un átomo a otro. Durante este proceso, un átomo pierde electrones y otro los gana, formando iones. Por lo general, el metal cede sus electrones formando un catión al elemento no metálico, que forma un anión.

Por otro lado, el enlace covalente es el enlace químico entre átomos donde los electrones se comparten, formando una molécula. Se establecen enlaces covalentes entre elementos no metálicos. El par de electrones compartidos es común a los dos átomos y los mantiene unidos.

En ambos casos se cumple con la regla del octeto, que establece que los átomos de los elementos se enlazan unos a otros en el intento de completar su capa de valencia con ocho electrones. Es decir que los átomos van a tender a ceder o compartir electrones para completar ocho electrones en la capa de valencia mediante un enlace iónico, covalente o metálico.

En otras palabras, el objetivo es tener la configuración electrónica del gas noble más cercano, teniendo así la última capa de electrones completa y adquiriendo estabilidad.

En resumen, la relación existente entre la teoría del octeto de Lewis con los enlaces iónicos y  covalentes es que dichos enlaces se producen con el objetivo de completar la última capa de electrones y adquirir estabilidad.

Aprende más:

Answer:

Explanation:

The new pressure can be found by using the formula for Boyle's law which is

[tex]P_2 = \frac{P_1V_1}{V_2} \\[/tex]

where

P1 is the initial pressure

P2 is the final pressure

V1 is the initial volume

V2 is the final volume

From the question we have

[tex]P_2 = \frac{125\times3.50 }{2.75} = \frac{437.5}{2.75} \\ = 159.090909...[/tex]

We have the final answer as

Hope this helps you

Answer:

Calculating Atomic Mass

Change each percent abundance into decimal form by dividing by 100. Multiply this value by the atomic mass of that isotope. Add together for each isotope to get the average atomic mass.

Explanation:

have a nice day

Answer:

Test for carbon dioxide gas.

The reaction between baking soda and citric acid will form sodium ions, citric acid ions, carbon dioxide gas, and water. So all you have to do is add the gas produced (by gas displacement method or something) and test whether the gas is carbon dioxide, with lime water or other methods like hydrogencarbonate indicator. Hope this helped!

Explanation:

Answer:

depends on amount, but the reaction's endothermic (meaning its cold, absorbs heat from surroundings)

I hope it helps.

The frequency of the infrared wave at the given speed and wavelength is [tex]5.5 \times 10^{13} \ Hz[/tex].

The given parameters;

The frequency of the infrared wave is calculated by using wave equation as shown below;

v = fλ

where;

[tex]f = \frac{v}{\lambda} \\\\f = \frac{3\times 10^8}{5.5 \times 10^{-6}} \\\\f = 5.5 \times 10^{13} \ Hz[/tex]

Thus, the frequency of the infrared wave at the given speed and wavelength is [tex]5.5 \times 10^{13} \ Hz[/tex].

Learn more here:https://brainly.com/question/18477700

Answer:

see answer

Explanation:

DO the postulates of Daltons atomic theory explain the law of conservation of mass and the law of constant composition.

1. Everything is composed of atoms, which are the indivisible building blocks of matter and cannot be destroyed or divided any further.

2. All atoms of a single pure element are the same in size and mass

3. Atoms of different elements vary from each other in size and mass.

4. Compounds are produced through different simple whole-number combinations of atoms to produce molecules.  

5. Anywhere a compound exists, it will have the same atoms in the same ratio.

6. A chemical reaction between compounds is a re-arrangement of atoms

The law of conservation of mass is shown in 2, 4. and 5.

The law of constant co,position is shown in 2, 4, 5, and 6

When tiny droplets of one liquid are finely dispersed within another liquid it is called emulsion.

Emulsion can be defined as the process by which two liquids that are not miscible come together to form a mixture.

The emulsion mixture usually consists of an oil phase and a water phase.

The oil phase appears as droplets when dispersed (mixed with) the water phase.

The uses of emulsion include:

Learn more here:

https://brainly.com/question/17288119

Answer:

Nuclear fusion of hydrogen to form helium occurs naturally in the sun and other stars. It takes place only at extremely high temperatures. That's because a great deal of energy is needed to overcome the force of repulsion between the positively charged nuclei.

Explanation:

hope it helps

Answer:

mark me brainlest

Explanation:

Electronegativity values generally increase from left to right across the periodic table. Electronegativities generally decrease from top to bottom of a group. The highest electronegativity value is for fluorine.

Answer:

       "Electronegativity increases as you move from left to right across a period because the number of charges on the nucleus increases." (sstudy30 on Quizlet)

Explanation:

    It explains itself haha!

Have a nice day!

    I hope this is what you are looking for, but if not - comment! I will edit and update my answer accordingly. (ノ^∇^)

- Heather

When a substance dissolves, it looks like it disappears. But in fact it has just mixed with the water to make a transparent (see-through) liquid called a solution. A solution has two parts. The solute is the solid that gets dissolved.

Answer:

it really depends what they are

Explanation:

Mr. garcia uses magnets to hold a poster on a steel filing cabinet because a main component of steel is iron.

The chemical element iron has the atomic number 26 and the symbol Fe. It is a metal that is found in group 8 of a periodic table and the first transition series. It makes up a large portion of the planet's outer or inner core and is the most prevalent element on Earth by mass, just ahead of oxygen.

It is the fourth most prevalent element in the crust of the Earth, having been mostly deposited by meteorites inside its metallic state, along with its ores. Iron ores must be processed in kilns or furnaces that may reach 5000 °C (2,730 °F) and higher, which is approximately 500 °C (932 °F) greater than the temperature needed to smelt copper. Mr. garcia uses magnets to hold a poster on a steel filing cabinet because a main component of steel is iron.

Therefore, mr. garcia uses magnets to hold a poster on a steel filing cabinet because a main component of steel is iron.

To know more about iron, here:

https://brainly.com/question/3299672

#SPJ7