CAN SOMEONE PLS HELP ME ILL GIVE YOU BRAINLIEST

A 7000 N braking force is used to slow a car down. The car was traveling at 25 m/s before the
brakes were applied and was traveling at 5 m/s after 6 seconds. What is the mass of the car?

Answer: D

Explanation:

An elastic collision is a collision in which there is no net loss in kinetic energy in the system as a result of the collision. Both momentum and kinetic energy are conserved quantities in elastic collisions. Suppose two similar trolleys are traveling toward each other with equal speed.

Answer:

8.829 Joules

Explanation:

The potential energy of an object, is the energy it posses (the energy stored within the object) by virtue of its relative elevation or height, position, state, or arrangement

The potential energy of an object raised to a given height, P.E. = m·g·h

Where;

m = The mass of the object

g = The acceleration due to gravity, a constant ≈ 9.81 m/s²

h = The present height of the object

For the potato sack having a mass, m = 2 kg, and raised to a height, h = 450 cm = 0.45 m, we have;

The potential energy given to the potato sack, by raising its height, P.E. is given as follows;

P.E. = 2 kg × 9.81 m/s² × 0.45 m = 8.829 Joules

The potential energy given to the potato sack, P.E. = 8.829 Joules

Answer:

flowers

Explanation:

i'm really not sure but i have this gut feeling its flowers

Answer:

1. The reason why nichrome wire is used in a heater is due to the properties of nichrome which makes it a material of choice for heating application including;

i) The cost of manufacture of nichrome is low

ii) Nichrome has both high mechanical and creep strength, and therefore is suitable for installation and use in a wide setting

iii) Nichrome has a high resistance to electron flow, making it a good electrical heating element

iv) Nichrome has a high resistance to oxidation, such that it can be reused several times as a heater

v) The high ductility of nichrome allows it to be stretched and drawn around different vessels with contents to which heat is to be supplied

2. Copper wire is not used in heaters because according to Joule's law, the heat produced from the flow of electric current, 'I', through a material having a resistance, 'R', for a time, 't', is proportional to I²·R·t, and copper has a very low resistance, 'R', to the flow of electric current, and therefore, will not produce sufficient heat required at a given current level

Explanation:

Answer: Artificial Selection

Explanation: Artificial Selection is described as the identification of desirable traits in both plants and animals, then enhance them, so that those traits can be manifested in future generations.

This is the scope behind cross breeding of plants and animals and this have largely been used in agricultural sector to improve input (such as disease-resistant seeds) and other biotechnological settings.

Darwin's described artificial selection as the human form of natural selection.

Answer:

Since it us the resistance that causes the power output, it might be intuitive to think that more resistance produces more power but as P=I^2 * R one actually needs high current and low resistqnce. That means 75 W has lower resistance and higher current.

Now you may think that making the resistance very low, one gets the most power. Not so, as the circuit has wires, power source etc. All the have their resistance. In theory one gets the maximum power over a resistor when the resistor is half of the total resistance of the circuit. This in practice would be inefficient as one would lose half of the total power elsewhere. In practice circuits have fuses that limit the current and one gets the maximum power at the current the fuse is rated to. So if there is 20 A fuse, the maximum power is 2400 W and the corresponding resistance 6 ohm.

Answer: hello your question lacks some data attached below is the missing data

answer : T - mg = ma[tex]_{c}[/tex]

Explanation:

Given that the vine has a fixed end and Tarzan's path is circular

At Tarzans lowest point the point can be expressed as shown below.

It can be expressed as : T - mg = ma[tex]_{c}[/tex]

Answer:

A. [tex]1.88\times 10^{-11}\,F[/tex].

Explanation:

By definition of Electric Capacitance, the capacitance of the system ([tex]C[/tex]), in farads, is described by the following formula:

[tex]C = \frac{q}{V}[/tex] (1)

Where:

[tex]q[/tex] - Electric charge, in coulombs.

[tex]V[/tex] - Voltage, in volts.

If we know that [tex]q = 9.4\times 10^{-10}\,C[/tex] and [tex]V = 50\,V[/tex], then the capacitance of the system is:

[tex]C = \frac{9.4\times 10^{-10}\,C}{50\,V}[/tex]

[tex]C = 1.88\times 10^{-11}\,F[/tex]

The correct answer is A.

Answer:

Size of an object, and the distance between the objects.

When the mass of an object increases the force of gravity increases as well.

Explanation:

The magnitude of this force depends upon the mass of each object and the distance between the centers of the two objects. Mathematically, we say the force of gravity depends directly upon the masses of the objects and inversely upon the distance between the objects squared.

Complete Question

A flywheel in a motor is spinning at 510 rpm when a power failure suddenly occurs. The flywheel has mass 40.0 kg and diameter 75.0 cm . The power is off for 40.0 s , and during this time the flywheel slows down uniformly due to friction in its axle bearings. During the time the power is off, the flywheel makes 210 complete revolutions. At what rate is the flywheel spinning when the power comes back on(in rpm)? How long after the beginning of the power failure would it have taken the flywheel to stop if the power had not come back on, and how many revolutions would the wheel have made during this time?

Answer:

[tex]\theta=274rev[/tex]

Explanation:

From the question we are told that:

Angular velocity [tex]\omega=510rpm[/tex]

Mass [tex]m=40.kg[/tex]

Diameter d [tex]75=>0.75m[/tex]

Off Time [tex]t=40.0s[/tex]

Oscillation at Power off [tex]N=210[/tex]

Generally the equation for Angular displacement is mathematically given by

 [tex]\theta_{\infty}=\frac{w+w_0}{t}t[/tex]

 [tex]w=\frac{2*\theta_{\infty}}{t}-w_0[/tex]

 [tex]w=\frac{28210}{40*(\frac{1}{60})}-510[/tex]

 [tex]w=120rpm[/tex]

Generally the equation for Time to come to rest is mathematically given by

 [tex]t=(\frac{\omega_0}{\omega_0-\omega})t[/tex]

 [tex]t=(\frac{510}{510-120rpm})(40.0)(\frac{1}{60})[/tex]

 [tex]t=0.87min[/tex]

Therefore Angular displacement is

 [tex]\theta =(\frac{120+510}{2})0.87[/tex]

 [tex]\theta=274rev[/tex]

Answer:

The proton has the same charge as the neutron.

Explanation:

Because the proton has a positive charge whereas the neutron has no charge  at all.

Answer:

It spreads diseases.

Explanation:

But when cooked food is kept on the place where uncooked meat or food was kept the germs spread to the cooked food also and as the cooked food cannot be washed it harms us as we directly consume it.

Answer:

Ohm's law verifies that current directly varies with voltage, when resistance increases, current current decreases.

When temperature increases, the electrons gain more average kinetic energy increases and current increases as well.

In the same situation, resistance also increases because atoms of a component vibrate at higher amplitudes about their mean positions hence reducing the free path of electrons. This increases resistance, hence ohms law violated or disobeyed.

This generates the temperature coefficient of resistance

Answer:

A

Explanation:

Answer:

Explanation:

PE = mgh where m is the mass in kg, g is the pull of gravity which is 9.8, and h is the height of the object above the point to which it could possibly fall, measured in meters. Plugging in:

PE = 10(9.8)(20) so

PE = 1960 J

This should be rounded to 1 sig fig according to the rules of sig fig and your numbers here, but I imagine you're not following them all that much. It should be 2000 J

Answer:

Increase in frequency constantly

Explanation:

This concept can be explained by Doppler shift as per which any form of disturbance spreads out spherically from its point of origin. If the source of sound wave is stationary and the receiver is also stationary, then the frequency remains the same but if the source is moving, then the disturbance caused is closer on one side and distant on the other side thereby producing shorter wavelength in direction the source is moving and longer wavelength in the opposite direction.

The magnitude of your displacement can be equal to the distance you covered, or it can be less than the distance you covered.  But it can never be greater than the distance you covered.

This is because displacement is a straight line, whereas distance can be a straight line, a squiggly line, a zig-zag line, a line with loops in it, a line with a bunch of back-and-forths in it, or any other kind of line.

The straight line is always the shortest path between two points.

Answer:

12.0 Volt

Explanation:

Step 1: Given data

Resistance of the ohmic dipole (R): 100 Ohm

Intensity of current (I): 120 mA (0.120 A)

Step 2: Calculate the voltage (V) across this chemical dipole

To calculate the voltage across the ohmic dipole, we will use Ohm's law.

I = V/R

V = I × R

V = 0.120 A × 100 Ohm = 12.0 V

The answer is B. Mono and polyunsaturated fats because the other two are really harmful and they are not healthy whatsoever.

Answer:

The ball and the wall experience the same force.

Explanation:

According to the third law of Newton, which states that "for every action, there is an equal and opposite reaction", this means that when an object 1 acts on object 2 with a certain force, object 2 also acts on object 1 with the same magnitude of force but in an opposite direction.

According to this question, a ball hits a wall with a certain force. This means that the wall will react on the ball with the same force magnitude, but in an opposite manner. Hence, the ball and the wall experience the same force.

Answer:

Thermal physics

Explanation:

Because it uses temperature

Answer:

In my opinion both are easier if you'll work hard on it...

Answer:

90 A

Explanation:

Applying,

P = VI.............. Equation 1

Where P = Power, V = Supply voltage, I = current.

Make I the subject of the equation

I = P/V.............. Equation 2

From the question,

Assuming the Voltage of the main electric supply is 120 V

Given: P = 10.8 kW = 10800 W, V = 120 V (household voltage)

Substitute these values into equation 2

I = 10800/120

I = 90 A

Answer:

The net magnetic field ta the center of square is[tex]1.36\times10^{-4} T[/tex].

Explanation:

Current, I = 12 A , side ,a = 10 cm =  0.1 m

Let the magnetic field due to the one side is B.

The magnetic field is given by

[tex]B = \frac{\mu o}{4\pi}\times \frac{I}{r}\times \left (Sin A +Sin B \right )\\\\B = 10^{-7}\times \frac{12}{0.05}\times \left ( sin 45 + sin 45 \right )\\\\B = 3.4\times 10^{-5} T[/tex]

Net magnetic field at the center of the square is

B' = 4 B

[tex]B'= 4\times 3.4\times 10^{-5}\\\\B' = 1.36\times10^{-4} T[/tex]

Answer:

The answer is C because they have to be close to be able to interact

Answer:

C. where the electric field lines are closest together 

Explanation:

Answer:

-0.75 m

Explanation:

The displacement of the girl is given by x = x₀cosωt where x₀ = maximum displacement of swing = 1.5 m, ω = angular frequency = π/3 rad/s and t = time of swing = 4 s

Substituting the values of the variables into the equation, we have

x = x₀cosωt

x = (1.5 m)cos(π/3 rad/s × 4 s)

x = (1.5 m)cos(2π/3)

x = (1.5 m)cos120°

x = 1.5 m × -0.5

x = -0.75 m

So, the girl is 0.75 m to the left of the equilibrium position 4 seconds into the motion.

Answer:

Diana and that

Explanation:

muyayyano

Answer:

Protista

Explanation:

Taxonomy can be defined as the process of naming, classification and description of living organisms such as plants and animals. Thus, the biological classification of living organisms based on similarities or characteristics such as eyes, number of legs, etc., is generally referred to as taxonomy.

Basically, taxonomy helps scientist to have a good understanding and knowledge when studying various organisms.

Furthermore, the eight (8) biological classification (taxonomy) used for grouping and organizing organisms are; kingdom, domain, phylum, family, order, class, species and genus.

An organism that has only one cell, big and has a nucleus is most likely a member of Protista. Thus, a Protista such as euglena, paramecium, amoeba, etc., have a nucleus and are unicellular.

A unicellular organism refers to a living organism that possess a single-cell while a multicellular organism has many (multiple) cells.

Answer:

ml tayo 1v1 durugin kita

Explanation:

ano takot ml 1v1