During homogeneous catalysis, if a catalyst is present in the liquid phase, which phase must the reactants be in?

Answer:

carbon mono oxide CO

Explanation:

as both are in 1:1 ratio so CO is formed

Answer:

C. are found in the nucleus of an atom

Explanation:

Protons and Neutrons are always located at the center of the atom also called as the nuclei of the atom and constitute nearly all the mass of the atom, while the electrons revolve around them in orbits called shells. Only protons have a positive charge and electrons have negative charges, due to which only protons and electrons attract each other, while neutrons lack charges or have 'Neutral Charges'.

Hi there! :)

[tex]\large\boxed{x = 2.49 L}[/tex]

Use the proportion for Charles' Law where:

[tex]\frac{v_{1}}{t_{1}}= \frac{v_{2}}{t_{2}}[/tex]

v1 = initial volume

t1 = initial temperature

v2 = final volume

v2 = final temperature

Substitute in the given values into the proportion:

v1 = 4.39 L

t1 = 44° C

t2 = 25°C

v2 = x L

Set up the proportion:

[tex]\frac{4.39}{44} = \frac{x}{25}[/tex]

Cross multiply:

[tex]25 * 4.39 = 44x\\\\109.75 = 44x\\\\x = 2.49 L[/tex]

Answer:

The new volume will be approximately 2.49 L.

Explanation:

We are given that a gas sample occupies 4.39 L at 44° C.

We are also given that we are going decrease the temperature to 25° C.

Charles' Law has a formula which shows the relationship between the volumes of a samples and the temperatures of the samples.

The proportion is shown as:

[tex]\displaystyle \bullet \ \ \ \frac{V_1}{T_1} = \frac{V_2}{T_2}[/tex],

where V₁ and V₂ are the initial and final volume respectively and T₁ and T₂ are the initial and final temperature respectively.

This proportion can be used to determine what our unknown is. We need to know the final volume.

[tex]\displaystyle \frac{4.39 \ \text{L}}{44 \ \text{C}} = \frac{\text{x}}{25 \ \text{C}}\\\\\\\frac{4.39}{44} = \frac{x}{25}\\\\\\4.39 \times 25 = 44 \times x\\\\\\44x = 109.75\\\\\\\frac{44x}{44}=\frac{109.75}{44}\\\\\\x = 2.49432 \approx \boxed{2.49 \ \text{L}}[/tex]

Therefore, if we reduce the temperature to 25 °C, we will be reducing the volume of the substance to 2.49 L.

Answer:

P4O10

Explanation:

Answer:

a.) 294.12 g/mol

Explanation:

1 equivalent of fatty acid reacts with 1 equivalent of NaOH.

As in the titration are required 0.0034 equivalents of NaOH, the equivalents of fatty acids = moles of fatty acids are:

0.0034 moles of fatty acids

Molar mass is defined as the ratio between mass of substance in a determined amount of moles. The mass of the fats was 1 gram, that means the molar mass is:

1g / 0.0034moles =

294.12g/mol

Right option is:

The characteristic that could distinguish a crystalline solid from an amorphous solid is option b. The way it breaks.

Crystalline solids contained edges and faces, that should be diffracted x-rays, and have sharp melting points.

While on the other hand, amorphous solids should contain irregular does not provide well-resolved x-ray diffraction patterns.

hence, the option b is correct.

And, the rest of the options are wrong.

Learn more about solid here: https://brainly.com/question/17435895

Answer:

Because there's nothing in space for sound to travel trough

Answer:

bottom right corner with arrows going up

Answer: The empirical formula is [tex]NaBO_2[/tex]

Explanation:

If percentage are given then we are taking total mass is 100 grams.

So, the mass of each element is equal to the percentage given:

Mass of Na= 34.5 g

Mass of B= 16.4 g

Mass of O = 48.6 g

Step 1 : convert given masses into moles.

Moles of Na =[tex]\frac{\text{ given mass of Na}}{\text{ molar mass of Na}}= \frac{34.5g}{23g/mole}=1.5moles[/tex]

Moles of B =[tex]\frac{\text{ given mass of B}}{\text{ molar mass of B}}= \frac{16.4g}{11g/mole}=1.5moles[/tex]

Moles of O =[tex]\frac{\text{ given mass of O}}{\text{ molar mass of O}}= \frac{48.6g}{16g/mole}=3moles[/tex]

Step 2 : For the mole ratio, divide each value of moles by the smallest number of moles calculated.

For Na = [tex]\frac{1.5}{1.5}=1[/tex]

For B = [tex]\frac{1.5}{1.5}=1[/tex]

For O =[tex]\frac{3}{1.5}=2[/tex]

The ratio of Na: B: O= 1: 1: 2

Hence the empirical formula is [tex]NaBO_2[/tex]

Answer:

18.84 g of silver.

Explanation:

We'll begin by calculating the number atoms present in 5.59 g of sulphur. This can be obtained as follow:

From Avogadro's hypothesis,

1 mole of sulphur contains 6.02×10²³ atoms.

1 mole of sulphur = 32 g

Thus,

32 g of sulphur contains 6.02×10²³ atoms.

Therefore, 5.59 g of sulphur will contain = (5.59 × 6.02×10²³) / 32 = 1.05×10²³ atoms.

From the calculations made above, 5.59 g of sulphur contains 1.05×10²³ atoms.

Finally, we shall determine the mass of silver that contains 1.05×10²³ atoms.

This is illustrated below:

1 mole of silver = 6.02×10²³ atoms.

1 mole of silver = 108 g

108 g of silver contains 6.02×10²³ atoms.

Therefore, Xg of silver will contain 1.05×10²³ atoms i.e

Xg of silver = (108 × 1.05×10²³)/6.02×10²³

Xg of silver = 18.84 g

Thus, 18.84 g of silver contains the same number of atoms (i.e 1.05×10²³ atoms) as 5.59 g of sulfur

Answer:

i do k12 too!

Explanation:

lol

Answer:

What's the rest of the question

Explanation:

The [H₃0⁺] of the solution : 1.778  x 10⁻¹² M

pH is the degree of acidity of a solution that depends on the concentration of H⁺ ions. The greater the value the more acidic the solution and the smaller the pH.  

pH = - log [H⁺]  

So that the two quantities between pH and [H⁺] are inversely proportional because they are associated with negative values.  

A solution whose value is different by n has a difference in the concentration of H⁺ ion of 10ⁿ.  

pH of solution = 11.75

the [H₃0⁺] of the solution :

[tex]\tt pH=-log[H_3O^+]\\\\11.75=-log[H_3O^+]\\\\(H_3O^+]=10^{-11.75}=1.778\times 10^{-12}[/tex]

Answer:

After 3 half lives 10 g of radio active material left.

Explanation:

Given data:

Total amount of radio active material = 80 g

Amount left after 3 half lives = ?

Solution:

At time zero = 80 g

At first half life = 80 g/2 = 40 g

At 2nd half life = 40 g/2 = 20 g

At 3rd half life = 20 g/2 = 10 g

Thus, after 3 half lives 10 g of radio active material left.

Answer:

Explanation:

T

Answer:

for this one you would have to divide 19.9g by the kinetic energy 1.0 and you would get your answer.

Explanation:if you would give me brainiest that would help a lot :)

Answer:

35.453 amu.

Explanation:

From the question given above, the following data were obtained:

Isotope A (Cl–35):

Abundance (A%) = 75.77%

Mass of A = 34.969 amu

Isotope B (Cl–37):

Abundance (B%) = 24.23%

Mass of B = 36.966 amu

AVERAGE atomic mass of Cl =?

The average atomic mass of Cl can be obtained as follow:

Average = [(Mass of A × A%)/100] + [(Mass of B × B%)/100]

Average = [(34.969 × 75.77)/100] + [(36.966 × 24.23)/100]

Average = 26.496 + 8.957

Average atomic mass of Cl = 35.453 amu.

Answer:

c cells

Explanation:

learned that in 7th grade

Answer:

dunno

Explanation:

Answer:

the  molar mass of the compound is  34.0 g /mol

Explanation:

The computation of the molar mass of the compound is as follows:

As we know that

PV = nRT

n = mass ÷ MW

PV = mRT ÷ MW

It can be rearrange as

MW = mRT ÷ (PV)

MW = (0.941)(0.082)(150 + 273) ÷ (1 × 0.96)

= 33.99g/mol

= 34.0 g /mol

Hence, the  molar mass of the compound is  34.0 g /mol

Answer:

Matter is Made up of Chemical Energy..

Answer:

[tex]\huge\boxed{\sf Chemical}[/tex]

Explanation:

Matter is made up of atoms. Atoms contain chemical bonds which hold up the atoms together. These chemical bonds store chemical energy in themselves. Hence Matter is made up of chemical energy and heat energy.

Light energy have no relation with matter. Remember, Light is not a matter and matter is not light.

[tex]\rule[225]{225}{2}[/tex]

Hope this helped!

Answer:

Black plastic

Explanation:

The color black absorbs more heat than any other color.

Answer:

plastic

Explanation:

Protons,neutrons,electrons

Answer: In the case of water, we know that the O-H covalent bond is polar, due to the different electronegativities of hydrogen and oxygen. Since there are two O-H bonds in water, their bond dipoles will interact and may result in a molecular dipole which can be measured.

Explanation:

Answer:

salt (NaCl)

Explanation:

Pure substance is defined as the substance that consist of a single type of material and does not contain contaminants. A pure substance has uniform composition throughout the process.

sodium chloride (NaCl) also known as table salt is a pure substance because it has a uniform and definite composition that is  1:1 ratio of sodium and chloride ions.

Hence, the correct answer is "salt (NaCl)".

Answer:

3.68 g/cm3

Explanation:

D = M / V

350 / 95

thermal contact

When heat flows from one object or substance to another it is in contact with, the objects or substances are said to be in thermal contact. The state where objects in thermal contact with each other reach the same temperature, no heat flows between them.