Answer:
See explanation
Explanation:
When dealing with the Electromagnetic Spectrum, one should remember the acronym ROYGBIV. This will apply to visible spectrum but the non-visible spectra can de logically deduced from the sequence. That is ...
R-Red > O-Orange > Y-Yellow > G-Green > B-Blue > I-Indigo > V-Violet
In relation to the three wave properties; wavelength (λ), frequency (ν) & energy (ΔE) ...
Wavelengths => Long λ Short λ
Frequency => Low ν High ν
Energy => Low ΔE High ΔE
Note that all 'L's' are on the 'Left'
On Left => Long wavelengths, Low frequency & Low energy; the 'opposites' are on 'the other end of the list'.
Therefore for other wavelengths outside the visible spectrum set up as follows, start with visible spectrum in the middle and insert the invisible spectra of interest.
Long λ <= Visible (R.0.Y.G.B.I.V.) => Short λ
λ (cm): 10¹ 10⁻² 10⁻³ (10⁻⁵- 10⁻⁶) 10⁻⁷ 10⁻⁹ (10⁻¹¹ - 10⁻¹³)
[radio > microwave > IR > visible > UV > X-Rays > Gamma]
Hope this helps :-)
9. a) Name salt that can be prepared by precipitation
I think its the substances that sublimes
PLS HELP WILL GIVE BRAINLIEST
it is a simple chemistry question
i thought F has 9 electrons, so why does this structure show 8 electrons.
Answer:
The IUPAC structure only shows bond pairs and lone pairs. In the flouromethane structure above, there is only one bond pair and three lone pairs of electrons. Therefore there is one electron remaining, but since it doesn't not make up a pair, it is ignored in the structure but theoretically it is present.
[tex].[/tex]
Answer:
therefore there is one electron remaining , but since it doesn't make up a pair . It is ignored in the structure but theoretically it is present .
What is known about a reaction with a negative enthalpy?
A. The reaction is endothermic,
B. The reaction is spontaneous,
C. The reaction is exothermic,
D. The reverse reaction is favored,
Considering the definition of enthalpy of reaction, the correct answer is option C. a reaction with a negative enthalpy indicates that the reaction is exothermic.
Definition of enthalpy of reactionThe enthalpy of a chemical reaction as the heat absorbed or released when chemicals are transformed into a chemical reaction and it occurs at constant pressure.
The enthalpy is an extensive property, that is, it depends on the amount of matter present.
Finally, it must be taken into account that:
A reaction is called exothermic if its enthalpy of reaction is negative (that is, if the system gives up heat).A reaction is called endothermic if its enthalpy of reaction is positive (that is, if the system absorbs heat).SummaryIn summary, a reaction with a negative enthalpy indicates that the reaction is exothermic.
Learn more about enthalpy of reaction:
brainly.com/question/20367803
brainly.com/question/24118258
#SPJ1
Energy in the amount of 420 J is added to a 35 g sample of water at a temperature of 10°C. What is the final temperature of the water?
The final temperature of the water, T2 = 38.57°C
Temperature can be defined as a measure of the degree of hotness or coldness of a physical object (body). Thus, it is measured with a thermometer and its units are degree Celsius (°C), Fahrenheit (°F) and Kelvin (°K).
A calorie refers to the amount of heat required to raise the temperature of a gram of water by one (1) degree Celsius (1°C).
Given the following data:
Quantity of energy = 420JMass = 35 gramsInitial temperature, T1 = 10°CThe specific heat capacity of water is 4.2 J/g°C.
To find the final temperature of the water (T2):
Mathematically, the quantity of energy (heat capacity) is given by the formula;
[tex]Q = mcdt[/tex]
Where;
Q represents the heat capacity or quantity of heat.M represents the mass of an object.C represents the specific heat capacity of water.dt represents the change in temperature.Substituting the values into the formula, we have;
[tex]420 = 3.5 \; * \; 4.2 \; * \; dt[/tex]
[tex]420 = 14.7 \; * \; dt\\\\dt = \frac{420}{14.7}[/tex]
Change in temperature, dt = 28.57°C
Next, we would solve for the final temperature by using this formula;
[tex]dt = T2 - T1[/tex]
[tex]28.57 = T_{2} - 10\\\\T_{2} = 28.57 \; + \; 10\\\\T_{2} = 38.57[/tex]
Final temperature, T2 = 38.57°C
Therefore, the final temperature of the water, T2 is equal to 38.57°C
For more information visit: https://brainly.com/question/22736508
what is the requirements to obtain citizenship?
please answer it correctly
Answer:
Age. ...
Residency. ...
Residence and Physical Presence.
Good Moral Character.
Attachment to the Constitution.
Language.
U.S. Government and History Knowledge.
Oath of Allegiance.
These are some requirements for obtaining citizenship .
precautive measures taken when using pooter
I guess ensuring that you don't suck the insects or specimen collected by ensuring there is a net in the pooter
Plz help me with this question
Drawing of water molecular formulas
1.Draw molecular structure of water
Answer:
Here is your answer. I hope it will help you .The atomic number of silicon (Si) is 14. What's the electron configuration for silicon? Question 1 options:
A) [Ar] 3p5
B) [He] 1s2 2p6
C) [Ne] 3s2 3p2
D) [He] 2s2 3p2
Answer:
D.[Ne] 3S2 3P2
Explanation:
The electron configuration for silicon is [Ne] 3s² 3p². Hence Option (C) is correct.
What is elctronic configuration ?Electronic configuration, also called electronic structure or electron configuration, the arrangement of electrons in orbitals around an atomic nucleus.
The electron configuration of an element describes how electrons are distributed in its atomic orbitals.
Electron configurations of atoms follow a standard notation in which all electron-containing atomic subshells (with the number of electrons they hold written in superscript) are placed in a sequence.
Silicon belongs to group 14th and 3rd period.Therefore, The electron configuration for silicon is [Ne] 3s² 3p². Hence Option (C) is correct.
Learn more about Electronic configuration here ;
https://brainly.com/question/14283892
#SPJ2
Is backbonding is possible in BF4- ? If no then why?
Answer:
No, because Flourine can only form 1 bond, thus backbonding is not obtainable
Patience, a popular card game in Mendeleev's time, is also known as Go Fish.
A. True
B. False
Answer:
B. False
Explanation:
step by step explanation
Answer:
False
Explanation:
the smell spreads immediately after you burn agarbatti in this example what is your condition about intermolecular force
Answer:
The aroma of agarbatti spreads quickly once you burn it because the particles in the agarbatti move endlessly in all directions. Both, the air and aroma, have large intermolecular forces which is why the molecules of air scatter immediately once agarbatti is burned.
is (H) a positive or negative value
Answer:
A chemical reaction that has a positive ΔH is said to be endothermic , while a chemical reaction that has a negative ΔH is said to be exothermic . What does it mean if the ΔH of a process is positive? It means that the system in which the chemical reaction is occurring is gaining energy.
The lattice energy for an ionic compound cannot be measured directly but can be calculated from the Born-_____ cycle, using a series of individual steps for which all enthalpies are known except for the lattice energy. This method is an application of Hess's law which, states that the overall energy change for a process is given by the _____ of the enthalpy changes for the individual steps.
Answer:
first is HABER
second is SUM
Explanation:
pls mark brainliest
question 8 chemistry help
Answer:
Sorry,I can't do this because i don't know this questions answer.
why can't sodium salt be prepared by double decomposition
Sodium salt might not be prepared by double decomposition because the method is used in preparing insoluble salts.
What is Double decomposition method?Double decomposition method serves as the method that is used in preparing compounds which entails reaction between two soluble compounds and after reaction soluble and insoluble products are produced.
Therefore, since most of the sodium salt are soluble salt , Double decomposition cannot be used to prepare them.
Learn more about Double decompositionat: https://brainly.com/question/27883280
#SPJ6
5. What change would increase the amount of gas able to be dissolved in a given amount of liquid water? (2 points)
Increasing temperature
a
Increasing pressure
Increasing surface area
O
Increasing rate of stirring
answer : increasing pressure
the amount of gas that can be dissolved in liquid water increase with the increase in pressure
Answer:
increasing pressure
Explanation:
Which of the following is the best definition of a physical property?
A. Tearing paper in half.
B. Something that can be observed or measured while changing the identity of the substance.
C. The ability of something to undergo a change or reaction.
D. Something that can be observed or measured without changing the identity of the substance.
Answer:
D.Something that can be observed or measured without changing the identity of the substance.
which statement is generally true about CaCaI2 ?
Explanation:
"Its bonds are formed by large differences in electronegativity" is the statement among the choices given in the question that is generally true about CaCl2.
what are your thoughts on Galileo's idea about motion? i need the answer pls
Answer:
Galileo believed that a projectile is a combination of uniform motion in the horizontal direction and uniformly accelerated motion in the vertical direction. If it is not impeded, it will continue to move even without an applied force
What is the molarity of 2 moles of a compound dissolved in 4 L of water?
A. 2 M
B. 0.5 M
C. 4M
D. 1 M
Answer:
[tex]\boxed {\boxed {\sf B. \ 0.5 \ M}}[/tex]
Explanation:
Molarity is a measure of concentration in moles per liter. The formula for calculating molarity is:
[tex]molarity= \frac{moles \ of \ solute}{ liters \ of \ solution}[/tex]
There are 2 moles of a compound or the solute. There are 4 liters of water or the solution.
moles of solute= 2 mol liters of solution = 4 LSubstitute the values into the formula.
[tex]molarity = \frac{ 2 \ mol}{ 4 \ L}[/tex]
Divide.
[tex]molarity= 0.5 \ mol /L[/tex]
1 mole per liter is equal to 1 Molar, so the solution's molarity of 0.5 mol/L is equal to 0.5 M.
[tex]molarity = 0.5 \ M[/tex]
The molarity of the solution is 0.5 Molar and choice B is correct.
what is meant by reactive elements
Answer; relative elements are most reactive elements and compounds may ignite spontaneously or explosively. They generally burn in water as well as the oxygen in the air
Explanation:
Answer:
Reactive elements are the elements which are ready to gain electrons because they have incompletely filled outermost shell.
Hope its helpful!
Please mark me as brainlist.
what is the formula of water
Answer:
The formula of water is H20
career in chemistry list ten
Explanation:
Chemistry Teacher.
Chemical Engineer.
Forensic Scientist.
Geochemist.
Biochemists
Pharmacologist
Analytical Chemist
Envionmental chemist
Water Chemist
Catalysis
What is Spontaneous ion
Why are the highest oxidation state of the transition metal stabilised in the oxide and fluoride compond?
Answer:
Following are the solution to the given question:
Explanation:
Its maximum oxidation zone is exceptionally stable and has the greatest ability to charge density, while fluoride and oxide ions are the largest particles with the largest durability of charge.
Or it might be assumed as oxygen and fluorine are the system particle atoms that have the highest electron number of metals.
which of the following statements is true about alkali?
A) bases that soluble in water
B) shows a pH value less than 7
C) Ionises in water to form hydroxonium ions
D) Reacts with carbonate salt to release carbon dioxide gas
Answer:
it should be letter c
Explanation:
I hope this help
Substances that contain a transition metal can be oxidizing. The greater the number of oxidation of this metal, the greater the oxidizing character of the substance. In an industrial process in which the use of an oxidizing agent is necessary, only five substances are available: CaO, FeO, Cu₂O, Cr₂O₃ and KMnO₄.
The substance that should be used in this process, as it has a greater oxidizing character, is:
a) Cr₂O₃
b) Cu₂O
c) CaO
d) FeO
e) KMnO₄
Describe how methane is
formed in terms of chemical bonding
Blood test can be used to check a person's blood glucose and hormone levels. The tabular column given below shows the result of two blood tests carried out on three people to check their blood glucose levels. Person 1 is healthy.
A:- Compare the glucose levels of person 1 with the glucose levels of person 2 after fasting for 12 hours.
B:- Compare the glucose levels of person 3 with the glucose levels of person 1, 2 hours after drinking 75g glucose.
C:- Person 3 cannot be produce the hormone that control blood glucose levels. State the hormone that person 3 cannot produce.
( THE ORDER OF THE PHOTO IS:- person 1, and person 2, and person 3)
Pls it is urgent
Answer:
Explanation:
1) person 2 had a slightly higher blood glucose level than person 1 after fasting 12 hrs (0.2mmols)
2) person 3 has a much higher blood glucose level than person 1 after taking glucose (5.6mmols)
3) insulin
in order to decrease the freezing point of 500. g of water to 1.00° c how many grams of ethylene glycol (C2H602)must be added (KF=1.86°C kg solvent)
Answer:
if wrong sorry ok????
