Answers
Related Questions
SI. unit of resistance ?
Answers
Answer:
si unit of resistance is Ohm
How can we find velocity?*
Answers
Answer: discplacement/change in time = average velocity.
Explanation:
There is a formula for velocity which is given above
Which statement accurately compares the trends in atomic number and atomic mass in the periodic table?
O The atomic number increases from left to right, while the atomic mass increases from right to left.
O The atomic mass increases from left to right, while the atomic number increases from right to left.
O Both the atomic mass and the atomic number increase from left to right.
O Both the atomic mass and the atomic number increase from right to left.
Answers
Answer:
C.
That is your answer
In an open circuit ____________.
Question 34 options:
a light bulb would produce light
current will flow
current will not flow
more than one resistor is in the circuit
a resistor controls the flow of current
Answers
Answer:
The current will not flow
Explanation:
An open circuit is a circuit that is not complete it has an opening Therfor the current can not flow.
A 1000 kg car’s velocity increases from 5 m/s to 10 m/s. What is the change to the car’s kinetic energy? Show your work.
Answers
Answer:
k. e. = 1/2 mv^2
1/2 * 1000 * (5)^2
1/2 * 1000 * 25
12500 joules
k. e. = 1/2 mv^2
1/2 * 1000 * (10)^2
1/2 * 1000 * 100
50000
change in k. e. = final - initial
50000 - 12500
= 37500 joules
hope it helps you
What is everything in our physical environment made of? *
A matter
B solids
C gases
Answers
Answer: matter
Explanation:
An LED light bulb is favored over an incandescent light bulb because it is more , what?
Answers
An LED light bulb is favoured because it is more bright.
An LED light is favored over an incandescent light bulb because it is more bright than the incandescent bulb.
What is an LED bulb?An LED is a light emitting diode. It is used widely for the production of light because it shows some advantages which include:
Many traditional lighting systems like the incandescent bulbs turn more than 90% of the energy which they use to heat, allocating only about 10% of energy to actual light production. LEDs emit almost no heat energy, and most of the light energy they emit is within the visible spectrum.
LEDs use much less energy than that of incandescent bulbs because the diode light is much more efficient, power-wise, than the filament light. LED bulbs use more than 75% less energy than those of incandescent lighting.
Learn more about LED bulb here:
https://brainly.com/question/30272515
#SPJ6
what reactions do catalytic converters catalyze
Answers
I am giving 18 points. Please try and don’t just do it for the points.
They won’t let me shown the very last picture, it looks like the normal L shape that is in every picture, and just one straight line. L—
Like that.
Which of the following graphs below represents the motion of an object at variable speeds? (3 points)
Distance
(miles)
Time
(hours)
Distance
(miles)
Time
(hours)
Answers
Answer:Distance.
Explanation:
A 58 kg skier starts at rest from a 24.0 m high hill. They travel to the bottom and then up a second hill to a height of 19.0 m. How much kinetic energy do they have at the top of the second hill?
Answers
Answer:
10.791 kJ
Explanation:
Given that,
Mass of the skier, m = 58 kg
Initial position, h₁ = 24 m
Final position, h₂ = 19 m
We need to find the kinetic energy do they have at the top of the second hill.
Using the conservation of energy for both positions.
[tex]v_1=\sqrt{2gh_1} \\\\=\sqrt{2\times 9.8\times 24} \\\\=21.68\ m/s[/tex]
And
[tex]v_2=\sqrt{2gh_2} \\\\=\sqrt{2\times 9.8\times 19} \\\\=19.29\ m/s[/tex]
Kinetic energy :
[tex]K=\dfrac{1}{2}mv_2^2\\\\K=\dfrac{1}{2}\times 58\times 19.29^2\\\\=10791.01 J\\\\=10.791\ kJ[/tex]
So, the kinetic energy they have at the top of the second hill is 10.791 kJ.
Evelyn is making a model of Earth to show how the physical layers correspond to the compositional layers. Which of the following should Evelyn show in her model?
The physical layers exactly match the compositional layers.-A
The crust is the only compositional layer not included in the physical layers. -B
The physical layers of the inner core and outer core form a single compositional layer. -C
The physical layer of the asthenosphere includes the compositional layer of the crust.-D
on a test need it asap.
I'll report u if u don't give the answer and just want the points.
Answers
Answer:
B
Explanation:
In your own words explain how acceleration differs from uniform motion.
Answers
Explanation:
acceleration is the Changing of throut per unit time ....
and in uniform motion .....
in that the speed of an object is uniform means same
Which statement describes the relationship between bond strength and the
melting and boiling points of a substance?
A. Substances held together by hydrogen bonding have lower melting
and boiling points than those held together by Van der Waals
forces.
B. Substances held together by ionic bonding have higher melting
and boiling points than those held together by hydrogen bonding.
C. Substances held together by Van der Waals forces have higher
melting and boiling points than those held together by ionic
bonding
O D. Substances held together by ionic bonding have lower melting and
boiling points than those held together by hydrogen bonding.
SUB
Answers
Answer: Wrong
Explanation:
The statement that accurately describes the relationship between bond strength and the melting and boiling points of a substance is; "substances held together by ionic bonding have higher melting and boiling points than those held together by hydrogen bonding."
Intermolecular forces refers to forces of attraction that holds molecules together in a particular state of matter. The nature and magnitude of intermolecular forces impacts on the magnitude of the melting and boiling points of substances.
Substances held together by ionic bonding have higher melting and boiling points than those held together by hydrogen bonding. The bonds between ionic substances can only be broken at very high temperature.
Learn more: https://brainly.com/question/865531
What does anaerobic mean?
A. Short bursts of energy
B. Without oxygen
C. Intense physical output
D. With oxygen
Answers
Answer:
without oxygen because
Answer:
Without oxygen
Explanation:
What is the main difference between speed and velocity?
Answers
Answer:
Speed is the time rate at which an object is moving along a path, while velocity is the rate and direction of an object's movement.
Answer:
Speed is the time rate at which an object is moving along a path, while velocity is the rate and direction of an object's movement.
Explanation:
A wire of resistance R is cut into ten equal parts which are then connected in parallel. The equivalent resistance of the combination is
Answers
Answer:
The equivalent resistance of the combination is R/100
Explanation:
Parallel Connection of Resistances
If resistances R1, R2, R3,...., Rn are connected in parallel, the equivalent resistance is calculated as follows:
[tex]\displaystyle \frac{1}{R_e}=\frac{1}{R_1}+\frac{1}{R_2}+\frac{1}{R_3}+...+\frac{1}{R_n}[/tex]
The electric resistance of a wire is directly proportional to its length. If a wire of resistance R is cut into 10 equal parts, then each part has a resistance of R/10.
It's known the 10 parts or resistance R/10 were connected in parallel, thus the electric resistance is:
[tex]\displaystyle \frac{1}{R_e}=\frac{1}{R/10}+\frac{1}{R/10}+\frac{1}{R/10}+...+\frac{1}{R/10}[/tex]
Note the sum consists of 10 equal terms. Operating on each term:
[tex]\displaystyle \frac{1}{R_e}=\frac{10}{R}+\frac{10}{R}+\frac{10}{R}+...+\frac{10}{R}[/tex]
The sum of 10 identical fractions yields 10 times each fraction:
[tex]\displaystyle \frac{1}{R_e}=10\frac{10}{R}=\frac{100}{R}[/tex]
Solving for Re needs to take the reciprocal of both sides of the equation:
[tex]R_e=R/100[/tex]
The equivalent resistance of the combination is R/100
What are natives from Cambodia called
Answers
Answer:
Khmer people make up 90% of the Cambodian population, followed by Vietnamese (5%), with the balance being Chinese, Cham (mostly a muslim people) and indigenous ethnic groups sometimes called Khmer Loeu
Explanation:
Answer:
Khmer
Explanation:
What is the Sl unit for momentum?
O kg• m
O kg
O kg• m
O kg
2
m
Answers
Explanation:
The S. I. unit of momentum is Kg. m/sechope it helps you
magnetic field strength decrease when what is increases
Answers
How do I find the change in velocity of a hockey puck?
Mass=0.1697 kg btw
Answers
Answer:The foot exerts a force on the ball during a well-defined
duration t (time extent of the contact)
Explanation:
what english word does the following- the first two signify a male, the 1st 3 letters support a female, the first four support a great signifiles a woman. What is the english word?
Answers
Answer:
lol i know - i was rushing -_-
he= male
her=female
One word with both is heroin but Im not 100% sure
Describe how elements are different from atoms
Answers
Answer:
An atom is the part of an element. A particular element is composed of only one type of atom. Atoms are further composed of subatomic particles called electrons, protons and neutrons. Elements can combine with each other to form molecules via chemical reaction.
An element is a substance in which all of the atoms have the same atomic (proton) number. It is also defined as a substance which cannot be broken down by chemical means.
How much gravitational potential energy does a 1.0 kg hammer have on a shelf 1.5 m above the ground?
Answers
Answer:
14.7 J
Explanation:
PE=MGH
PE= 1.0 x 9.8 x 1.5 = 14.7 J
YALL PLS HELP ME! CAN YOU GUYS CHECK MY ANSWERS?
Answers
Answer:
1. Newton's First Law of Motion
2.Newton's Third Law of Motion
3.Newton's Third Law of Motion
4.Newton's Second Law of Motion
5.Newton's Third Law of Motion
6.Newton's Second Law of Motion
7.Newton's First Law of Motion
Explanation:
Newton's First Law of Motion states that an object remain at rest or moving with a uniform velocity unless an external force acts on it. This is the law of inertia
Newton's Second Law of Motion states that the force of an objects is the product of mass and acceleration.
Newton's Third Law of Motion states that when two objects interact, a pair of forces act on the objects, and they are equal and act in opposite directions.
The electric field between two parallel plates has a magnitude of 180 N/C. The two plates are 2.5 cm apart. Recall that the magnitude of the charge on an electron is 1.602 × 10-19 C.
How much work is done to move an electron from the positive plate to the negative plate?
4.0 × 10-21 J
7.2 × 10-19 J
4.5 J
7200 J
Answers
Answer:
b
Explanation:
The amount of work done to move an electron from the positive plate to the negative plate is : 7.2 * [tex]10^{-19}[/tex] J
Step 1: Given data
magnitude of two parallel plate ( E ) = 180 N/C
Distance between plates ( d ) = 2.5 cm
magnitude of charge on electron ( e ) = [tex]1.602 * 10^{-19}[/tex] C
Step 2 : determine the work done
Work done = qV = еEd
= [tex]1.602 * 10^{-19}[/tex] * 180 * 2.5
= 720 * [tex]10^{-22}[/tex] J ≈ 7.2 * [tex]10^{-19}[/tex] J
Hence the amount of work done to move an electron from the positive plate to the negative plate = 7.2 * [tex]10^{-19}[/tex] J
learn more about electric field : https://brainly.com/question/11509296
Who would like to be my girlfiend ?
Answers
nobody this is a app to help others
Answer:
I bet my great grandmother would
What element has conductivity,shiney luster,magnitic
-science
Answers
Answer:
The answer to this question is given below in this explanation section.
Explanation:
"What element has conductivity,shiney luster,magnetic
-science"
silicon has a shiny luster,But it is brittle and conducts electricity poorly.Some metalloids change their characteristics when they react with different elements.Luster conductivity and malleability are physical properties can be observed be observed without attempting to change the identity of the substance.The term physical property is an observable characteristics of a substance. in this case the luster conductivity and malleability of metals are the properties, which can be observed by our senses.It differs from chemical properties which can only be observed when the substance change its chemical identity.
Metal are solid at room temperature with the exception of mercury which is liquid at room temperature.Luster metal have the quality of reflection light from its surface and can be polished e.g gold,silver and copper.
What is one of the forms of a gene called?
allele
dominant
heterozygous
recessive
Answers
Answer:
Explanation:
.
Answer:
alleles
my answee need to be at least 20 characters long :(
Given the impulse acting on an object and the impact time which equation can be used to calculate the force applied to an object
Answers
Answer is D
Ndmdjdndbdjdkskd
The impulse acting on an object and the impact time, the equation F= I / Δt can be used to calculate the force applied to an object, therefore the correct answer is D.
What is impulse?The product of the average applied force and the time for which it is exerted is known as an impulse.
the mathematical relation for impulse is
Impulse = F * Δt
where F represents the force applied and Δt represents the time for which the force is applied
Thus, the correct equation that can be used to calculate the force applied to an object is F = I /Δt and the correct option is D.
Learn more about impulse, here
https://brainly.com/question/16980676
#SPJ2
Which of these force&mass pairs will result in the largest acceleration? *
50 N and 5 kg
60 N and 3 kg
30 N and 1 kg
25 N and 100 kg
10 N and 8 kg
Answers
Answer:
30N and 1 kg has largest acceleration
hope it helps you