The graph below shows the percentage of unstable nuclei remaining of a radioactive isotope.
Initially, there was 44g of the radioactive substance. How much of the substance is thereafter 60 minutes?

Answer:

Soluble - salt

Insoluble - sand and stapler pins

Explanation:

The salt is soluble because it is an ionic solid which ready dissolves in water to form a solution.

The sand is insoluble because, it is a non-metallic solid which does not readily dissolve in water while, the stapler pin is insoluble because it is a metallic solid which does not readily dissolve in water.

Answer:

-It holds people's belongings tight to Earth's surface

-it helps cool Earth's surface

- it keeps the solar wind from reaching earth

Answer:

mark me as the brainliest plss

Answer:

All options presented were applied to the answer.

Explanation:

The sample response presented in the question above, refers to a closed system where two molecules after colliding satisfy the conservation of momentum law, which can also be called the conservation law of linear momentum. This law states that in a closed system the initial state of the components must be maintained and remain the same until the final state, that is, the two molecules maintain their ideal momentum before and after the collision. This means that if they had 1.5 kg • m/s before the collision, this value must be maintained after the collision. All these concepts are presented in the sample response.

Answer:

What did you include in your response? Check all that apply. The law of conservation of momentum is satisfied. The momentum before the collision is 1.5 kg • m/s. The momentum after the collision is 1.5 kg • m/s. The momentum before and after the collision is the same.

Explanation:

The sample response presented in the question above, refers to a closed system where two molecules after colliding satisfy the conservation of momentum law, which can also be called the conservation law of linear momentum. This law states that in a closed system the initial state of the components must be maintained and remain the same until the final state, that is, the two molecules maintain their ideal momentum before and after the collision. This means that if they had 1.5 kg • m/s before the collision, this value must be maintained after the collision. All these concepts are presented in the sample response.

Answer:

Force = mass x acceleration

Explanation:

According to the Newton's second law, the net force acting on the object is proportional to the rate of change of momentum of the body.

So, Force is given by

F = m a

where, F is the force, m is the mass and a is the acceleration.

when the mass is more, the acceleration is less as the force applied by the truck is same.

Answer:

1.

a. T

b. F

c. T

d. F

e. T

2. Liquid, gas, solid

3. Water

4.

a. Solid

b. Gas

c. Water

5.

a. Add heat

b. Remove heat

c. Add heat

BLUEBLACK COLOR IS FORMED WHEN STARCH AND IODINE IS MIXED .

Answer:

Option D. ²³⁹₉₃Np

Explanation:

Let the unknown be ʸₓA.

Thus, the equation becomes:

²³⁹₉₂U —> ⁰₋₁e + ʸₓA

Next, we shall determine the x, y and A. This can be obtained as follow:

92 = –1 + x

Collect like terms

92 + 1 = x

93 = x

x = 93

239 = 0 + y

239 = y

y = 239

ʸₓA => ²³⁹₉₃A => ²³⁹₉₃Np

Thus, the complete equation is:

²³⁹₉₂U —> ⁰₋₁e + ²³⁹₉₃Np

Answer:

Our atmosphere is a mixture of gases that surround Earth. It is kept in place by the pull of Earth's gravity. If Earth was a much smaller planet, like Mercury or Pluto, its gravity would be to weak to hold a large atmosphere

Explanation:

Answer:

Primera Ley de Newton, también llamado Ley de la Inercia de Newton.

Explanation:

Este concepto es la Primera Ley de Newton o Ley de la Inercia de Newton, la cual dice textualmente que todo cuerpo al cual no se aplica ninguna fuerza externa neta no nula sobre sí se encuentra en reposo o desplazándose a velocidad constante.

Entiéndase a la inercia como la tendencia de un cuerpo a oponerse al cambio en su estado de movimiento.

Answer:

Before the collision:

m v1 = .5 kg * 15 m/s = 7.5 kg-m/s

Incidentally, after the collision

(M + m) v2 = 7.5

v2 = 7.5 / (1 + .5) = 5 m/s

Explanation:

4) The net torque on the on the meter stick is equal to zero in order to have no rotation.

[tex]\tau_{1} = \tau_{2}[/tex]

[tex]F_{1}d_{1} = F_{2}d_{2}[/tex]

[tex](8 \:N)(0.3\: m) = F_{2}(0.1 \:m)[/tex]

[tex]F_{2} = \frac{(8 \:N)(0.3 \:m)}{(0.1 \:m)} = 24 \:N[/tex]

5) We are going the same equations in #4 here.

[tex]F_{1}d_{1} = F_{2}d_{2}[/tex]

[tex](500 \:N)(2.4 \:m) = F_{2}(3.0 \:m)[/tex]

[tex]F_{2} = \frac{(500 \:N)(2.4 \:m)}{(3.0 \:m)} = 400 \:N[/tex]

Answer:

24 m/s²

Explanation:

The given parameters are;

The initial acceleration of the object, a = 16 m/s²

Let 'm' represent the initial mass of the object

The initial force acting on the object, F = m × a

∴ F = 16 × m = 16·m

When the mass is doubled, we have;

The new mass of the object, m₂ = 2 × m = 2·m

When the net force acting on the object triples, we have;

The new net force acting on the object, F₂ = 3 × F = 3 × 16·m = 48·m

From F = m × a, we have;

a = F/m

∴ The new acceleration of the object, a₂ = F₂/m₂

From which, by plugging in the values, we have;

a₂ = 48·m/(2·m) = 24

The new acceleration of the object, a₂ = 24 m/s².

Answer:

4.5V

Explanation:

In a arrangement of cells, the cells could be joined end to end(series) or to a common junction (parallel).

When cells are joined in series, the total emf of the cell is the sum of the individual emf of all the cells.

Hence;

Total emf = 1.5V + 1.5V + 1.5 V = 4.5 Volts

Aslaam 3lekm m3akm yaseen my 8nat alninkm

Answer: D

Explanation:

Answer:

Explanation:

Use the one-dimensional equation

[tex]v_f=v_0+at[/tex] which says that the final velocity of an object is equal to the object's initial velocity plus its acceleration times time. We are looking for time. That means the equation looks like this:

0 = 30 + (-4)t and

-30 = -4t so

t = 7.5 sec

The time taken for the car to stop if its acceleration is -4.0 m/s² is           7.5 seconds.

According to equation of motion, three motion equations commonly referred to as the rules of constant acceleration, exist for a uniform acceleration.

To derive the components such as displacement(s), velocity(initial =u and final = v), time(t), and acceleration(a), these equations are utilized.

The equations can be,

As we have to Calculate the time :

The formula for the motion equation is

v = u - at

v - final velocity

u - initial velocity

a - acceleration

t - time

Here, v = 0 ,

u = 30 m/s

a = -4 m/s²

So substituting in, v = u - at

⇒0 = 30 - 4t

⇒4t = 30

⇒t = 30/4

t = 7.5 seconds

Therefore, the required time calculated is 7.5 seconds.

Learn more about the equation of motion,

https://brainly.com/question/13514745

#SPJ2

Answer:

Explanation:

i. Accuracy in measurement is a term that is used to describe the closeness of a measured value to its actual value. It relates the actual value to the measured values.

Therefore in the given question, Amy's measurement of the salt's mass is accurate because her final value is close to all the measured values.

ii. Precision in measurement is a term that is used to describe the closeness of different measured values to each other. It relates the keenness in the measured values.

Thus, Amy's measurements of the salt's mass is precise because the values of the masses are close to one another.

Answer:

A quantity which does not depend on direction is called a scalar quantity. Vector quantities have two characteristics, a magnitude and a direction. Scalar quantities have only a magnitude. When comparing two vector quantities of the same type, you have to compare both the magnitude and the direction.

I rarely share my notes. But these are my last year notes, so I can share with you. Click on the photo to view the answer.

Answer: The area of brick in contact with the floor is 1539 [tex]cm^{3}[/tex].

Explanation:

Given: Length = 19 cm

Width = 9 cm

Height = 9 cm

As the brick is rectangular in shape. Hence, its area will be calculated as follows.

[tex]Area = length \times width \times height[/tex]

Substitute the values into above formula as follows.

[tex]Area = length \times width \times height\\= 19 cm \times 9 cm \times 9 cm\\= 1539 cm^{3}[/tex]

Thus, we can conclude that area of brick in contact with the floor is 1539 [tex]cm^{3}[/tex].

Answer:

the force is very strong between

Answer:

Newton’s first law of motion states that there must be a cause—which is a net external force—for there to be any change in velocity, either a change in magnitude or direction. An object sliding across a table or floor slows down due to the net force of friction acting on the object.

Explanation:

Answer:

Explanation:

Heredity is defined as the passage of genetic instructions from one generation to the next.

Answer:

True

Explanation:

Minerals can be defined as any form of naturally occurring, inorganic solid substance characterized by a crystal structure. Also, minerals are homogeneous in nature with a defined chemical composition and characterized by a crystal structure comprising of ions, atoms, or molecules in an orderly arrangement.

Generally, molecules attach on the inside of a mineral to give it shape. Therefore, the molecule of a mineral is a crystal three-dimensional regular structure (arrangement) of chemical particles that are bonded together and determines its shape.

Furthermore, the chemical composition (property) of a mineral reflect the presence and arrangement of atoms in each.

Due to the fact that these molecules are structurally arranged (ordered) and are repeated by different symmetrical and translational operations, they determine the shape of minerals. Some examples of minerals are iron, copper, aluminum, tin, coal, quartz, feldspar, mica, etc.

Additionally, inorganic-crystalline solid substances which are found naturally within earth are referred to as minerals.

In conclusion, a mineral in the earth's crust exists naturally in form of solid elements or compounds.

2.75 m/s. Hope this helps.

Answer:

The conservation of energy is a principle where according to which the energy of interacting bodies or particles in a closed system remains constant.

Explanation:

Answer:

a principle stating that energy cannot be created or destroyed, but can be altered from one form to another.

Answer:

An ionic compound is named first by its cation and then by its anion. The cation has the same name as its element.

Answer:

0.87

Explanation:

Given :

Mass of bottle = 29.2 g

Mass when filled with diesel = 116.2 g

Mass when filled with water = 129.2 g

The mass of water = (Mass when filled with water - mass of bottle)

Mass of water = 129.2 - 29.2 = 100 g

Mass of diesel = (Mass when filled with diesel - mass of bottle)

Mass of diesel = 116.2 - 29.2 = 87

Relative density of diesel = mass of diesel / mass of equal volume of water

Relative density = 87 / 100 = 0.87