Answer:
Acceleration is the rate of change of velocity with time.its system international unit is meters per second square.
I hope this helps
Logam P dan Q sejenis. Logam P yang memiliki panjang 1 meter dipanaskan hingga mengalami kenaikan suhu 12ºC, akibatnya logam bertambah panjang 0,2 cm. Logam Q juga dipanaskan hingga mengalami kenaikan suhu 10°C dan panjangnya bertambah 0,1 cm. Tentukanlah panjang mula-mula logam Q!
Answer:
I don't know ???
sorry
Electricity flows from
positive to positive
negative to positive
negative to negative
positive to negative
Answer:
is it from positive to negative am I right tell me if I am wrong
Answer:
positive to negative
The flow of electric current is similar to the flow of water which is from higher level to lower level.
The electric current flow from higher potential region(positive* low concentration of electron) to lower potential region(negative*high concentration of electron)
Which statement best describes the arrangement of electrons in an atom of fluorine (F)?
(1 point) giving brainliest for sure
There are two electrons in the first energy level and seven electrons in the second energy level.
There are two electrons in the first energy level and five electrons in the second energy level.
There are five electrons in the first energy level and two electrons in the second energy level.
There are seven electrons in the first energy level and two electrons in the second energy level.
Flourine is an element which has 9 electrons. The first energy level can only hold upto 2 electrons so therefore two electrons of the fluorine element will be in the first orbital.
In the second orbital there will be seven electrons. The configuration will be as 1s2, 2s2 , 2p5 .
The first orbital has capacity of two electrons and then the remaining two electrons will be in higher second energy level.
The further 5 electrons will be in lower second energy level which is denoted by p.
Learn more at https://brainly.com/question/24373325
Answer:
#1. 5
#2.They have valence electrons in the same energy level.
#3. Helium atoms have 2 valence electrons, while atoms of the other elements in the group all have 8 valence electrons.
#4. cesium (Cs)
#5. There are two electrons in the first energy level and seven electrons in the second energy level.
Explanation:
Q- Wheel of a running vehicle has which energy?
(a) Vibrational Kinetic energy
(b) Translational Kinetic energy
(c) Rotational Kinetic energy
(d) All of the above
Answer:
Rotational kinetic energy
Explanation:
It is caused by circular motion.
How can a simulation study be used to learn about a planet we have never visited?
In a simulation study you imitate some conditions and characteristics of the real planet. The simulation can be used as a substitute for real data collected on the planet.
Simulation studies can be used for planets we have already visited.
In a simulation study you imitate as many conditions and characteristics as possible of the real thing, in this case the planet you have not visited. By simulating as many conditions as possible you can visualize what the planet might be like and learn things about it without actually visiting it.
Simulation studies cannot be used to learn about a planet we have never visited because we do not know anything about the planet.
A simulation study that is used to learn about a planet by simulating as many conditions as possible, you can visualize what the planet might be like and learn things about it without actually visiting it. The correct option is c.
What is simulation?A simulation is a method of simulating a process or change in the actual world to forecast future events or to explain past events and their causes. These days, simulations are frequently carried out using computers. Scientists use simulations to find answers and to test complicated systems.
A fire drill is used in this instance to get everyone ready for an impending event. In fire drills, the fire alarm is sounded even when there isn't actually a fire.
Therefore, the correct option is c.
To learn more about simulation, refer to the link:
https://brainly.com/question/16359096
#SPJ2
Ag,Au and Cu are called coinage metals why plzzzz hurry its urgent plzzz
Answer:
This is because these metals are used for minting (making) coins.
Answer:
It is bcz it is used for making coins
Those of you who have recently finished high school physics-did you struggle? If you did, where did you most struggle in? Was it the tests? Or a specific topic?
Thank you!
Answer:
I'm over halfway through it so don't have a complete answer but i think you just need to keep ontop of everything and write down all the key equations on flashcards or something and aim to learn them at the beginning of each topic. i found the longer questions hard so recommend practising those
Explanation:
3. Calculate the wavelength of wave that has a frequency of 4.75 x 1012Hz.
a. 1.43 x 1021 m
b. 6.31 x 105 m
1.58 x 104 m
d. 6.31 x 105 m
please help
C.
We know
[tex]\boxed{\sf \lambda=\dfrac{C}{V}}[/tex]
[tex]\\ \sf\longmapsto \lambda=\dfrac{3\times 10^8ms^{-1}}{4.75\times 10^{12}s^{-1}}[/tex]
[tex]\\ \sf\longmapsto \lambda=0.631\times 10^{-4}m[/tex]
[tex]\\ \sf\longmapsto \lambda=6.31\times 10^{-5}m[/tex]
What unit is used to measure the period of a wave?
A. Seconds
B. Meters
C. Hertz
D. Meters/second
Answer:
D. Meters/Seconds
Explanation:
The time period of a wave is measured in seconds.
A typical wave involves both time and distance. Consider a sound wave, which is basically a periodic modulation of the local air pressure. We "hear" the sound because our ears respond to the variations of pressure.
The most common metric of a sound wave is frequency. This is the rate at which the change in pressure occurs, and is measured in cycles per second, formally known as "hertz". The period is the inverse of frequency andl has the units of seconds per cycle, commonly stated simply as seconds.
Describe manipulated Variable
Rearrange this equation so it equals d
v=dt
Answer:
Below
Explanation:
To solve for d rearrange the formula v = (d)(t) to:
d = v / t
I'm not to sure if you are using different variables but usually in physics the formula for velocity is v = d / t not v = dt
If you wanted to solve for displacement you would do:
d = (v)(t)
Hope this helps!
what is field selection process
It is a process of offering jobs to desired candidates and offering jobs to the desired applicant.
If the velocity of a motorcycle increases from 30 mis too 50m/s in 10 seconds what will be the acceleration of motorcycle?
Answer:
2 m/s^2
Explanation:
a = ∆v / ∆t
a = (50 - 30) / 10
a = 20 / 10
a = 2 m/s^2
acceleration = u-v/t
50-30/10
=2m/s
its important please answer
Answer: Well we see that v= u- ft/m
lets say that ft= feet and m= mass
so you divide those and subtract u
leaving you with the value of v which is 13
Which of the following sentences is incorrect about pressure?
i) Pressure depends upon the amount of force applied.
ii) Pressure depends on the area upon which is the force is applied.
iii) Pressure is a vector quantity.
iv) The force acting per unit area is called pressure
Answer:
iii) pressure is a vector quantity.
can anyone please help me
Answer:its most likely c
Explanation:
A motorcycle is moving at a constant velocity of 15 meters/second. Then it starts to accelerate and reaches a velocity of 24 meters/second in 3 seconds. What’s the acceleration of the motorcycle over this time? Use .
A.
9 m/s2
B.
8 m/s2
C.
6 m/s2
D.
5 m/s2
E.
3 m/s2
option E
3m/s square
hope it helped u
The plane of a5cm*8cm rectangular loop of wire is parallel to a 0.19T magnetic field the loop carries a current of 6.2 A. What torque acts on aloop? What is the magnetic moment of the loop?
Answer:
Torque; τ = 4.712 × 10^(-3) J
Magnetic moment; M = 0.0248 J/T
Explanation:
Torque is gotten from the formula;
τ = BIA
Where;
B is magnetic field
I is current
A is area
We are given;
B = 0.19T
I = 6.2A
Rectangle dimensions = 5cm by 8cm = 0.05m by 0.08m
Thus;
Area; A = 0.05m × 0.08m = 0.004 m²
Thus;
τ = 0.19 × 6.2 × 0.004
τ = 4.712 × 10^(-3) J
Formula for the magnetic moment is given by;
M = IA
M = 6.2 × 0.004
M = 0.0248 J/T
What is the symbol SI unit of time?
Answer:
second is the SI unit of time
Two difference between thrust and upthrust .
Upthrust is the upward force exerted by fluids on the surface of an object immersed in fluids. Thrust:- It is the force acting perpendicular to the surface. Upthrust:- It is the upward force exerted by the fluid on the surface of an object immersed in liquid.
I hope it's help you
If the final velocity is 0. third equation of motion will be
Answer:
vf²=vi²+2a∆x
Explanation:
The third equation of motion gives the final velocity of an object under uniform acceleration given the distance traveled and an initial velocity: v 2 = v 0 2 + 2 a d . v^2=v_0^2+2ad. v2=v02+2ad. The graph of the motion of the object.
20. A semiconductor is a
A) crystalline solid that conducts current under any condition
B) metallic solid that conducts current under any condition
C) metallic solid that conducts current under certain conditions
D) crystalline solid that conducts current under certain conditions
Answer:
D) crystalline solid that conducts current under certain conditions
Explanation:
A semiconductor is any crystalline solid material whose electrical conductivity is intermediary between that of insulators and conductors. That is, a semiconductor does not conduct like a conductor but does more than an insulator.
Based on this, a semiconductor is said to only conduct electricity under certain conditions as opposed to conductors that do so under any condition. Example of semiconductors are silicon, carbon, antimony, arsenic etc.
define 1 second time
Answer:
define 1 second time
One second is the time that elapses during 9,192,631,770 (9.192631770 x 10 9 ) cycles of the radiation produced by the transition between two levels of the cesium 133 atom. ... One second is equal to 1/86,400 of a mean solar day.
Answer:
One part of 86400 part of a day is called one second time.
✌✌✌✌
how do you think the weight and the lift should not be one of the same magnitude
because weight disappear and doesn't show the actual weight in the lift
There is the more role of the moon than the sun to occur tides in the oceans,why?
Answer:
The ocean tides on earth are caused by both the moon's gravity and the sun's gravity. ... Even though the sun is much more massive and therefore has stronger overall gravity than the moon, the moon is closer to the earth so that its gravitational gradient is stronger than that of the sun.
The moon plays a larger role than the sun in causing tides in the oceans because it is much closer to Earth and has a stronger gravitational pull on our planet. The gravitational force between two objects is directly proportional to their masses and inversely proportional to the square of the distance between them.
Although the sun is much larger than the moon, its gravitational pull on Earth is much weaker because it is much farther away. The moon, on the other hand, is much smaller than the sun, but it is much closer to Earth and exerts a stronger gravitational force on our planet. This gravitational force causes the water in the oceans to bulge towards the moon, causing high tides.
In addition to the gravitational force, the shape of the ocean basins, the rotation of the Earth, and the positions of the sun and moon also play a role in causing tides. However, the moon's gravitational force is the primary factor that causes tides in the oceans.
By how many times will the kinetic energy of a body increase if its speed is tripled? Show by calculation .
Answer:
9 lần
Explanation:
Answer:
Kinetic energy (k.e) varies directly as v² from the formula
K.E=(mv²/2)
if v=3 then K.e =v²=(3)²=9
pete walks at a rate of 4.0 miles per hour for 30 minutes. How far did he walk?
what is the speed of a car that travels 150m in 120 s
Answer:
1.25 m/s
Explanation:
divide 120 by 120 to get one second and then divide 1t0 by 120 to get the number
V Page 1. What is the acceleration due to gravity at poles in m/s2.if it is 9.78 at the equation ->
Answer:
Chk photo
Explanation:
1. Find the temperature when the degrees of the Celsius scale will be one fifth of the corresponding degrees of the Fahrenheit scale
2. How much heat is necessary to warm 500g of water from 20°C to 65°C?
Answer:
F = 9/5 C + 32 conversion from C to F
F = 9/5 * F/5 + 32
25 F = 9 F + 800
16 F = 800
F = 50
Check:
C = 5/9 ( F - 32) = 5/9 (50 - 32) = 10 as requested
Q = c m change in temp
Q = 1 cal/gm-deg C * 500 gm * 45 deg C = 22,500 calories
50 Fahrenheit heat required.
How much heat required?Heat transfer is a discipline of thermal engineering that concerns the generation, use, conversion, and exchange of thermal energy between physical systems.
F = 9/5 C + 32 conversion from C to F
F = 9/5 * F/5 + 32
25 F = 9 F + 800
16 F = 800
F = 50
The answer is 50 Fahrenheit.
Learn more about heat transfer
https://brainly.com/question15086449
#SPJ2
