The frequency of a photon of red light with wavelength 4.50 x 10−7m is 6.67 x 1014Hz.
What quantity is represented by the mass number minus the atomic number?.
Answer:
Mass = mass of nucleus
Atomic Number = number of protons (charge) of nucleus
Mass - Atomic Number = number of neutrons
Why is wrestling ring floor always softThis is physics
Answer:
So the people in the ring don't get hurt or break anything on impact once they hit the floor
help -----------------------------------------
Answer:
H,G,E,D,C,B,A,I,F
Explanation:
F is an ignious intrusion and I cross cuts H to A so it must be newer.
2. If Joe rides his bicycle in a straight line for 15 min with an average velocity of 12.5 km/h south, how far has he ridden?
Answer:
3.125 Kilometers
Explanation:
To answer this you just multiply 12.5 by .25 (since 15 minutes is a quarter of an hour) to get 3.125 kilometers ridden.
This should be pretty easy i think.
Describe the components within the system involved in the collision between pilot and landing zone.
Answer:
its a sure for not but i think its a 192583
Help me quick!!! please!!
Calculate the power of an engine which raises a mass of 1000 kg to a height of 40 m in 10 s.
Answer:
39.240 W
Explanation:
Let's start by calculating the work done by the engine. We can assume that it is the same work done by the weight of the object to bring it from 40m to the surface: as much energy it takes to bring it up, the same ammount it takes to bring it down. Said work is [tex]w= \vec F\cdot \vec{h} = mg h = 1000 \times 9.81\times 40 = 392.400 J[/tex]
At this point we can simply apply the definition of power, that is [tex]P = \frac wt[/tex], to get the power of the engine is [tex]39.240 W[/tex]
Answer:
P=39200W
Explanation:
P=(mgh)/t
P=(40×9.8×1000)/10
P=39200W
An "energy bar" contains 26 ggof carbohydrates.How much energy is this in joules?
Inertia causes bodies to slow in their motion, unless they’re pushed by a force.
Inertia resists changes to the state of motion of a body.
Inertia decelerates a body.
Inertia is due to friction.
Answer:
ill go with B
Explanation:
inertia is the ability of a body to remain at rest or in a constant speed in a constant direction when no force is acting on it
Rubies are used in electronics.
Please select the best answer from the choices provided
) Т
) F
How does the diameter of a black hole (size of the event horizon) depend on the mass inside the black hole
Answer:
The greater the mass, the greater is the diameter
Explanation:
The greater the mass, the greater is the diameter. almost all galaxies contain supermassive black holes.
please answer right please
Answer:
i think its A
Explanation:
I hope this helps :)
Prove that the two equations shown below are equivalent.
F = ma and F = p/t
Newton’s Second Law of Motion is defined as Force is equal to the rate of change of momentum. For a constant mass, force equals mass times acceleration.
[tex]\Delta p = mv - mu \\\\\implies \Delta p = m(v-u) \\\\F = \dfrac{\Delta p}{\Delta t} = \dfrac{m(v-u)}{\Delta t} = ma[/tex]
F = ma is the formula of Newton’s Second Law of Motion.
To prove Newton's second law of motion,
Given Force F = Δp/Δt
What is relation between F = ma and F = Δp/Δt?Newton’s Second Law of Motion is defined as Force is equal to the rate of change of momentum. The second law of Newton can be described as the acceleration of an object which produces a net force is directly proportional to the magnitude of the net force, in the same path i.e., direction as the net force, and inversely proportional to the mass of the object.As the acceleration has its magnitude and direction it is a vector quantity.Proof for F=ma
Let us consider an object of mass m, moving along a straight line with an initial velocity u, final velocity v and it has some particular time t and thus Momentum can be related as,
For initial velocity u, p1 = m × u
The final velocity v, p2 = m × v
The change in momentum can be expressed as
p2 – p1 = (m × v) – (m × u)
p2 – p1 = m (v – u)
Here, we know that the rate of change of momentum with respect to time is proportional to the applied force.
The applied force F,
F ∝ [m (v – u)]/t
F ∝ m × a
As acceleration (a) is the rate of change of velocity with respect to time.
F = k × m × a
F = ma
where k can be the constant.
Learn more about Newton's second law,
https://brainly.com/question/13447525
#SPJ2
Solve 100N up 90N down for net force
Answer:
10 Newtons up
Hope this helps!
Which key phrase below would imply that an object has no (0) initial velocity?
1) smoothly
2) in motion
3) backwards
4) from rest
5) uniformly
I assume number 4.
The key phrase which describes zero (0) initial velocity is from rest.
When the velocity of an object at initial time is zero (0), it implies that the change in the displacement of the object with time is zero
[tex]v= \frac{\Delta x}{\Delta t} \\\\v_0 = 0[/tex]
Generally, when an starts its motion from rest, the initial velocity of the object will be zero. As the object acquires more momentum, the velocity increases with time.
Thus, we can conclude that the key phrase which describes zero (0) initial velocity is from rest.
Learn more about initial velocity here:https://brainly.com/question/19365526
we cannot see the milky way galaxy without binocular or telescopes. true or false?
Answer:
I'm pretty sure it's false
Explanation:
.
pluto is part of the kuiper belt. what captured moon likely originated in the kuiper belt?
moon Triton, Neptune's largest moon Triton
The moon Triton is the captured moon which most likely originated in the Kuiper belt.
What is Kuiper belt?This is defined as a donut-shaped region beyond Neptune and has an extension from 30 to 50 AU or more from the Sun.
The moon Triton is the captured moon which originates from this belt thereby making it the most appropriate choice.
Read more about Kuiper belt here https://brainly.com/question/14154493
How does the radius of a string affect centripetal force.
Answer:
because a raduis is half of 25% of a cicrle.
Explanation:
Which of the following will require most developed countries to
decrease emissions of carbon dioxide and other greenhouse gases?
a. Montreal Protocol c. Emissions Reduction Act
b. Kyoto Protocol d. Reforestation Project
Answer:
Kyoto Protocol
Explanation:
I'll give brainliest
Answer: figuratively speaking both the lines for the force Q and force P is equal.
Suppose you were able to take measurements of current through the
resistor and voltage across the resistor. Your record of numerical values is written in a
tabular data below
Answer:
see attached
Explanation:
It will be easier to plot the data if you have grid lines to work with.
In the attached, we had to reverse the order of entries in the table, because the graphing program likes the independent variable listed first.
Da 6.0 kg wooden crate slides across a wooden floor
at a speed of 2.4 m/s, it it takes an applica force
of 25 N to keep it going at a steady speed. What is the
coe of kinetic friction between the floor and crate?
Answer:coe?
Explanation:
PLEASE ANSWER NEED HELP!!!!!!!! PLEASE THE CORRECT ANSWER!!!!!!
Zhiyu wants to start an exercise program. He knows that he should talk to his doctor, but he cannot get an appointment for several weeks. He does not have any health conditions. What is the BEST advice for Zhiyu?
A.
All exercise needs to be medically supervised, so he must wait.
B.
There is always a risk of injury, so he needs professional advice before he starts.
C.
He can start slowly with low impact activity like walking or light weightlifting.
D.
He should do whatever he feels like; his body will let him know if he overdoes it.
PLEASE NO LINKS OR I WILL REPORT YOU
Answer:
c
Explanation:
The product of pressure and volume of any gas equals a constant, k. What variable(s) must not change in order for the value of k to remain constant
How much would a 70 kg student weigh on Pluto? (massPluto = 1.25 x 1022 kg, radiusPluto = 1.20 x 106 m)
Answer: the weight would be 4.6 (I think i don’t know))
Explanation:
1
A pencil weighing 1N is sitting on a desk.
Write down all the forces on the desk.
a.
b.
Draw a free body diagram of the desk.
c.
Add up the forces in the x-direction (horizontal) and the y-direction (vertical)
The force diagram on the desk consists of normal reaction and weight of the pencil.
The net force on the desk in vertical direction is 1 N.
The net force on the desk in horizontal direction is 0.
The given parameters;
weight of the pencil, W = 1 NThe force diagram of the desk is sketched as follows;
↑ N
⊕
↓ W
Where;
N is the normal reaction on the deskW is the weight of the ballThe net force on the desk in vertical direction = 1 N
The net force on the desk in horizontal direction = 0
Learn more here:https://brainly.com/question/3624253
A fairly efficient steam turbine engine fired by coal is used to drive an electric generator. The generator operates between 2100°C and 385°C.
(a) Determine the maximum possible efficiency of the engine.
Answer: 72.3 %
Formula:
e = 1 - (Tc / Th) = 1 - (Qc / Qh) = ( W / Qh)
Explanation: Unsure??
(b) The engine absorbs 1.15 105 J from the hot reservoir every second. If the actual efficiency of the engine is 40.3%, determine the mechanical power the engine delivers.
Answer: 46 kW
Explanation:
Energy absorbed by the engine (J) * actual efficiency of the engine (%) = mechanical power the engine delivers (kW)
How does 1 - (385/2100) = 72.3 % ?
What do I Plug in to make e = 72.3 %
Use kelvin not celsius
C + 273 = K
This will fix my problem of the equation not making sense.
A block with a mass of 6.0 kg is
held in equilibrium on an incline
of angle θ = 30.0° by a horizontal
force, F, as shown in the figure.
Find the magnitudes of the
normal force on the block and of F. (Ignore friction.)
(a) The normal force on the block is 50.92 N.
(b) The horizontal force on block keeping it in equilibrium is 29.4 N.
The given parameters;
mass of the block, m = 6 kgangle of inclination, θ = 30.0°The normal force on the block is calculated as follows;
[tex]F_n = W \times cos(\theta)[/tex]
where;
W is the weight of the block[tex]F_n = mg \times cos(\theta)\\\\F_n = 6 \times 9.8 \times cos(30)\\\\F_n = 50 .92 \ N[/tex]
The horizontal force on block keeping it in equilibrium is calculated as follows;
[tex]F- F_x = 0\\\\F-mgsin\theta= 0\\\\F = mgsin\theta\\\\F = 6 \times 9.8 \times sin(30)\\\\F = 29.4 \ N[/tex]
Learn more here:https://brainly.com/question/24860178
If the submarine intends to submerge to a depth of 150 m, what pressure must it be designed to withstand
Explanation:
Hydrostatic pressure, P = hdg where d is density if the liquid ( water)
P= 150m × 1000kgm-3 × 10ms-2
P= 1.5 ×10^6 Pa
What is a thought experiment?
Answer:
A thought experiment is an experiment carried out only in the imagination
Explanation:
The potential energy stored in the compressed spring of a dart gun, with a spring constant of 32. 50 N/m, is 0. 640 J. Find by how much is the spring is compressed.
The spring in the dart gun is compressed by 0.16 m
From the question given above, the following data were obtained:
Spring constant (K) = 50 N/m
Potential Energy (PE) = 0.640 J
Compression (e) =?The compression experience by the spring can be obtained as follow:
PE = ½ke²
0.64 = ½ × 50 × e²
0.64 = 25 × e²
Divide both side by 25
e² = 0.64 / 25
Take the square root of both side
e = √(0.64 / 25)
e = 0.16 m
Therefore, the spring is compressed by 0.16 m
Learn more: https://brainly.com/question/14848315
