Which of the following would not be considered matter?
clouds
trees
rain
air
light

Explanation:

When chlorine bonds and becomes stable, (had a full outer electron shell), because we know that chlorine has 7 electrons in it’s outer shell, it requires 1 to gain noble gas structure. So, when if bonds with an element and then becomes stable, the gaining of an electron means it becomes a negatively charged ion. (an ion being a charged particle.)

Answer:

D

Explanation:

B is solid and liquid while D is liquid and gas

Answer:

Option ( D) is correct

The phase transition occurs at 100o C (the normal boiling point of water). Liquid water becomes water vapor or steam when it enters the gaseous phase.

Explanation:

A heating curve graphically represents the phase transitions that a substance undergoes as heat is added to it.

The liquid will begin to boil when enough heat has been absorbed by the solution that the temperature reaches the boiling point, where again, the temperature remains constant until all of the liquid has become gaseous water. At the atmospheric pressure of 1 atm, this phase transition occurs at 100o C (the normal boiling point of water). Liquid water becomes water vapor or steam when it enters the gaseous phase. Use the heat of vaporization ([latex]\Delta H_{vap}[/latex] ) to calculate how much heat was absorbed in this process: [latex]q=m\cdot C_{H_2O(g)}\cdot \Delta T[/latex], where m is the mass of the sample of water.

After all of the liquid has been converted to gas, the temperature will continue to increase as heat as added. Again, the heat added that results in a certain change temperature is given by: [latex]q=m\cdot C_{H_2O(g)}\cdot \Delta T[/latex] . Note that the specific heat capacity of gaseous water is different than that of ice or liquid water.

Answer:

A balanced chemical equation must always include coefficients on every reactant and product.

Explanation:

A balanced chemical equation does not need to include coefficients on every reactant and product.

For example, below is a balanced chemical equation in which the reactants and the products have no coefficients whatsoever:

NaOH(aq) + HCl (aq) -----> NaCl (s) + H2O (l)

Of course, a properly written chemical equation must include the states of matter of all the substances in the reaction and the number of atoms of each element must balance both in the reactant and product sides of the equation. Generally, a balanced chemical equation must obey the law of conservation of matter which opines that matter can neither be created nor destroyed but can only be converted from one form to another.

Hence, that a balanced chemical equation must always include coefficients on every reactant and product is not true.

Cu2+ is reduced to Cu.

Change in oxidation state is from +2 to 0

Answer:

the atomicity of sulphur is 8

Explanation:

hope it helps

the 1st one is balanced, the 2nd isn't (the number of Mg differs from left 1 to right 2).

The third is also not balanced, 2 F left,2*3=6 on the right

Answer:

C. Enlargement

Explanation:

Answer: It’s 4.0

Explanation: I just took the test and got it right:)

Answer:

Ba

Explanation:

Answer:

NAO SRESONDEPORR PQUEOU BUOBRRRA  IGAD THCAAUSEI

Explanation:

Answer:

1s2 2s2 2p6 3s2 3p6

Explanation:

Chlorine is a groups 17 element. The halogens for ions by accepting one electron to form univalent negative ions.

Since chlorine normally contains seventeen electrons, the chloride ion consists of eighteen electrons.

Hence the electronic configuration of chlorine ion is; 1s2 2s2 2p6 3s2 3p6.

Answer:

conjugate base

Explanation:

The following equation is given in this question:

HCI(g) + H2O(l) → H30+(aq) + Cl-(aq)

In accordance to Brønsted–Lowry acid–base theory, an acid is a substance that loses an hydrogen ion (H+) or proton in an aqueous solution. This theory further indicated that the substance formed after an acid loses its hydrogen ion is called a CONJUGATE BASE.

In the above equation, HCl is the acid because it loses H+ while the substance formed after the loss of H+, which is Cl- is a conjugate base.

Answer:

see explanation

Explanation:

Solutions are prepared from one of three solute sources ...

- solid solute from manufacturer,

-liquid solute from manufacturer,

-stock concentrate of solute for dilution to lower concentrations.

In this problem, sucrose is a stock solid with a formula mass of 342.3 grams/mol. The amount of solid needed can be determined using the formula:

mass of solute needed (grams) = (Molarity needed x Volume needed in Liters x formula weight) / (decimal fraction purity of stock solid)

Molarity needed = 0.3M

Volume needed = 500 ml = 0.500 liters

Formula weight = 342.3 grams/mole

Purity factor (assumed) = 100% = 1.00 (should be posted on stock bottle label) For example, a 95% pure stock solid => purity factor of 0.95.

∴ grams of sucrose needed = (0.3M*)(0.500L)(342.3g/mole)/(1.00) =51.345 grams sucrose.

Measure 51.345 grams of sucrose into mixing vessel and add solvent water up to, but not to exceed 500 ml total volume. Mix until homogeneous.

Answer:

Phosphorus atoms can bond with oxygen atoms to form ester groups. These can bond with carbon atoms, yielding a large number of organic phosphorus chemicals. These are found in many important biological processes

The concentration of hydronium ions (H₃O⁺) is generally greater than 1 × 10⁻⁷ for all acidic solutions: True.

An acidic solution can be defined as a type of aqeous solution that has a high concentration of hydrogen ions (H⁺), which is typically greater than that of pure water.

As a result of the fact that an acidic solution has a power of hydrogen ions (pH) below 7, the concentration of hydronium ions (H₃O⁺) derived from the protonation of water would be greater than 1 × 10⁻⁷ for all acidic solutions.

In conclusion, we can deduce that a property of all acidic solution is a concentration of hydronium ions (H₃O⁺) that is greater than 1 × 10⁻⁷.

Read more on acidic solution here: https://brainly.com/question/24753206

The answer is ‘Passive Transport’

movement of molecules without the use of energy is due to the shrinkage of water

Answer:

A. 70 K

B. 3.16 atm

Explanation:

We'll begin by calculating the number of mole in 175 g of Ar. This can be obtained as follow:

Mass of Ar = 175 g

Molar mass of Ar = 40 g/mol

Mole of Ar =?

Mole = mass / molar mass

Mole of Ar = 175 / 40

Mole of Ar = 4.375 moles

A. Determination of the temperature.

Mole of Ar (n) = 4.375 moles

Volume (V) = 2.50 L

Pressure (P) = 10 atm

Gas constant (R) = 0.0821 atm.L/Kmol

Temperature (T) =?

PV = nRT

10 × 2.5 = 4.375 × 0.0821 × T

25 = 4.375 × 0.0821 × T

Divide both side by (4.375 × 0.0821)

T = 25 / (4.375 × 0.0821)

T ≈ 70 K

B. Determination of the pressure.

Mole of Ar (n) = 4.375 moles

Volume (V) = 2.50 L

Temperature (T) = 22 K

Gas constant (R) = 0.0821 atm.L/Kmol

Pressure (P) =?

PV = nRT

P × 2.5 = 4.375 × 0.0821 × 22

Divide both side by 2.5

P = (4.375 × 0.0821 × 22) / 2.5

P = 3.16 atm.

Answer:

ii and iv

Explanation:

atomic mass is the sum of protons and neutrons

protons ( postively charged) usually have the same number like electrons( negatively charged)

Answer:

Explanation:

2,5M

Answer:

2,5m

Explanation:

c=n:v

Answer: The answer is they are not closely packed

Explanation: HOPE THIS HELPS!!

Answer:

Mg

Explanation:

Mg forms 2+ ions and mgcl2 has a melting point over 700°C I believe.

Answer:

answer of your question is 4th

Explanation:

P205

Answer:

I would guess more atoms? but there is no graph attached

Answer:

This is because Mendeleev arranged the elements in order of increasing relative atomic mass.

Explanation:

Dmitri Mendeleev is one of the scientists that contributed to the development of periodic table in chemistry. He was able to organise elements into rows according to their atomic mass and into columns based on chemical and physical properties. This is the main reason why his periodic table is still studied even though it has some defects which include:

--> Grouping of elements that are not similar chemically: For example Copper and Silver bear no resemblance with the alkali metals, but they have been placed together in the first group.

--> Position of isotopes: According to his periodic table: Isotopes of an element must be given separate places in the periodic table because they have different atomic masses.

--> Electronic arrangement of elements: It failed to explain the electronic arrangement of elements.

--> Separation of chemically similar elements:

Elements that are chemically similar such as Gold and Platinum have been placed in separate groups.

Answer:

I think option (d) is right answer

Answer:

I think that the answer is option(C)