You can do only number 1 only

Answer:

the power output P = 1484 W

Explanation:

Power P  = Force× speed

Given that motor of a battery-powered scooter can maintain a speed of 5.3 m/s by providing a force of 280 N.

Therefore,the power output of the motor P = 280×5.3 = 1484 W

Hence, the power output P = 1484 W

Answer:

Explanation:

Force= (q1q2)/(4/\Ęr2)

3×10^6= (1.602×10^-19)^2/(r^2)

r^2=(2.27×10^-33)/(3×10^6)

r^2=8.55×10^-45

r= 9.25×10^-23

Answer:

It is connected in series with the circuit

Explanation:

This is because to measure the current in the circuit, the current in the circuit has to flow through the ammeter. As such, the ammeter must be connected in series with the circuit so as to measure the current flowing through the circuit.

So, to measure the current flowing through a circuit with an ammeter, the ammeter must be connected in series with the circuit.

multiplication of two vectors yields a vector oroduy

Answer: The energy incident on the solar panel during that day is [tex]9.24 \times 10^{7} J[/tex].

Explanation:

Given: Mass = 250 kg

Initial temperature = [tex]16^{o}C[/tex]

Final temperature = [tex]38^{o}C[/tex]

Specific heat capacity = 4200 [tex]J/kg^{o}C[/tex]

Formula used to calculate the energy is as follows.

[tex]q = m \times C \times (T_{2} - T_{1})[/tex]

where,

q = heat energy

m = mass of substance

C = specific heat capacity

[tex]T_{1}[/tex] = initial temperature

[tex]T_{2}[/tex] = final temperature

Substitute the values into above formula as follows.

[tex]q = 250 kg \times 4200 J/kg^{o}C \times (38 - 16)^{o}C\\= 250 kg \times 4200 J/kg^{o}C \times 22^{o}C[/tex]

As it is given that water absorbs 25% of the energy incident on the solar panel. Hence, energy incident on the solar panel can be calculated as follows.

[tex]\frac{25}{100} \times q = 250 kg \times 4200 J/kg^{o}C \times 22^{o}C\\q = 9.24 \times 10^{7} J[/tex]

Thus, we can conclude that the energy incident on the solar panel during that day is [tex]9.24 \times 10^{7} J[/tex].

Answer:

5m/sec^2

Explanation:

Distance=1200m

Time=4 min

1=60sec

4=4 x 60

=240sec

Velocity=Distance/Time

Velocity=1200/240

Velocity=5m/sec^2

Mark me as brainliest

Answer:

It depends on the medium

Explanation:

2021 edge

The energy of a sound wave decreases as it travels through a medium to another medium. Thus, the correct option is D.

A sound wave is the pattern of disturbance which is caused by the energy which is travelling away from the source of the sound in that medium. Sound waves are the longitudinal waves. This means that the propagation of these vibration of particles is parallel to the energy which this wave propagation direction has. When the atoms in the medium are set in vibration then they move back and forth in a direction. This continuous to occur in back and forth motion resulting in a high-pressure and a low-pressure region in the medium and thus propagating sound.

Sound wave is the physical vibration wave which travel through the air to reach the ears of organisms. Sound energy is the result when force makes an object to vibrate. A wave can lose energy as it travels through a medium because the medium can also absorb the energy from the wave. The medium changes some of the acoustic energy of the sound wave into heat energy.

Therefore, the correct option is D.

Learn more about Sound wave here:

https://brainly.com/question/21995826

#SPJ2

Answer:

D. Frequency

Explanation:

The energy of an  electromagnetic wave is proportional to frequency, mathematically it is expressed as;

E ∝ f

E = hf

where;

h is Planck's constant = 6.626 x 10⁻³⁴ Js

The equation above can also be expanded to;

[tex]E = hf = h \frac{c}{\lambda}[/tex]

where;

c is speed of light = 3 x 10⁸ m/s

λ is the wavelength of the electromagnetic wave

Since the speed of light is constant, we can conclude that the energy of the electromagnetic wave is directly proportional to its frequency and inversely proportional to its wavelength.

Therefore, the correct option for direct proportionality is FREQUENCY

Answer:

B= 4 A=5

Explanation:

Answer:

Nitric acid, also known as aqua fortis and spirit of niter, is a highly corrosive mineral acid. The pure compound is colorless, but older samples tend to acquire a yellow cast due to decomposition into oxides of nitrogen and water. Most commercially available nitric acid has a concentration of 68% in water.

Explanation:

Good morning...

Nitric acid production is mainly driven by fertilizer industry. Nitric acid is used in the production of ammonium nitrate and calcium ammonium nitrate which find applications as fertilizers.

Complete Question

A flywheel in a motor is spinning at 510 rpm when a power failure suddenly occurs. The flywheel has mass 40.0 kg and diameter 75.0 cm . The power is off for 40.0 s , and during this time the flywheel slows down uniformly due to friction in its axle bearings. During the time the power is off, the flywheel makes 210 complete revolutions. At what rate is the flywheel spinning when the power comes back on(in rpm)? How long after the beginning of the power failure would it have taken the flywheel to stop if the power had not come back on, and how many revolutions would the wheel have made during this time?

Answer:

[tex]\theta=274rev[/tex]

Explanation:

From the question we are told that:

Angular velocity [tex]\omega=510rpm[/tex]

Mass [tex]m=40.kg[/tex]

Diameter d [tex]75=>0.75m[/tex]

Off Time [tex]t=40.0s[/tex]

Oscillation at Power off [tex]N=210[/tex]

Generally the equation for Angular displacement is mathematically given by

 [tex]\theta_{\infty}=\frac{w+w_0}{t}t[/tex]

 [tex]w=\frac{2*\theta_{\infty}}{t}-w_0[/tex]

 [tex]w=\frac{28210}{40*(\frac{1}{60})}-510[/tex]

 [tex]w=120rpm[/tex]

Generally the equation for Time to come to rest is mathematically given by

 [tex]t=(\frac{\omega_0}{\omega_0-\omega})t[/tex]

 [tex]t=(\frac{510}{510-120rpm})(40.0)(\frac{1}{60})[/tex]

 [tex]t=0.87min[/tex]

Therefore Angular displacement is

 [tex]\theta =(\frac{120+510}{2})0.87[/tex]

 [tex]\theta=274rev[/tex]

Answer:

B

A

Explanation:

please mark as brainliest :)

Answer:

For Ryan:

[tex]at \: highest \: point : v = 0 \\ velocity = 0 \: {ms}^{ - 1} [/tex]

For the football kicked:

[tex]s = ut - \frac{1}{2} g {t}^{2} \\ for \: range : s = 0 \\ u \sin( \theta) = \frac{gt}{2} \\ t = \frac{2u \sin(\theta) }{g} \\ range(x) = ut \\ x = \frac{ {2u {}^{2} \sin(\theta) }^{} }{g} \\ \frac{50 \times 9.8}{ {2318.9}^{} } = \sin(\theta) \\ \\but \: 0 = u \sin(25) - 2 \times 9.8 \times 50 \\ u = 2318.9 \: {ms}^{ - 1} \\ \theta = 12.2 \degree[/tex]

Answer:

the highest point for the first question is 0 meters per second

the answer for question 2 is 45 degrees

Answer:

Explanation:

V = I * R

V = 4 * 12.1 = 48.4 v

Answer:

Diana and that

Explanation:

muyayyano

Answer:

it is maybe A but i'm not 100% sure

Explanation:

its the only one that is mixed

Answer:

I think C

Explanation:

If im right give brainliest :)

Answer:

Increase in frequency constantly

Explanation:

This concept can be explained by Doppler shift as per which any form of disturbance spreads out spherically from its point of origin. If the source of sound wave is stationary and the receiver is also stationary, then the frequency remains the same but if the source is moving, then the disturbance caused is closer on one side and distant on the other side thereby producing shorter wavelength in direction the source is moving and longer wavelength in the opposite direction.

c- temperature

The speed of sound increases with increasing temperature .