mention two factors which affect pressure due to liquid contained in a vessel​

Answer:

0.289J of heat are added

Explanation:

We can relate the change in heat of a substance with its increasing in temperature using the equation:

q = m*ΔT*S

Where Q is change in heat

m is mass of substance (In this case, 0.0948g of water)

ΔT = 0.728°C

S is specific heat (For water, 4.184J/g°C)

Replacing:

q = 0.0948g*0.728°C*4.184J/g°C

q = 0.289J of heat are added

Answer:

e.

6.7

hope it help

.

.

.

.

.

.

Explanation:

When adding sugar to water it became a syrupy solution. Here sugar acts as solute, the water acts as solvent and syrupy acts as solution. When adding sugar to water, the disaccharide of sucrose is converted into monosaccharides of glucose and fructose

Answer:

syrupy solution

Answer:

the reactants are carbon dioxide ,iron, oxygen

Answer:

See explanation

Explanation:

Intermolecular forces are forces of attraction that exist between molecules of a substance in a particular state of matter.

The dominant intermolecular force of attraction in H2O is the hydrogen bond. The hydrogen bond exists between molecules of a substance when the substance is made of hydrogen atoms bonded to atoms of a highly electronegative element. Hence, strong hydrogen bonding accounts for the high boiling point of water.

The magnitude of hydrogen bonding between molecules depends on the electro negativity of the atoms to which hydrogen is bonded.

The more the electro negativity of the atoms to which hydrogen is bonded, the greater the magnitude of intermolecular hydrogen bonding.

Since the electro negativity of elements decrease down the group, the strength of intermolecular hydrogen bonding between the molecules decreases as follows;

H2O> H2S> H2Se> H2Te

Explanation:

HI friends good morning

Force = The external energy that changes or tends to change the state of any body or object is called force.

Speed = The rate of distance is called speed.

Answer:

Force is a push or pull which changes or tend to change the position of a body.

The rate of change its position with time or magnitude is called speed.

cr2o72+H2o2-(r3+o2)

Explanation:

r62o72+H2o2-(r3+o2)

Answer:

C2H4 Ethylene

Explanation:

Hope it helps! :)

You're going to first balance the chemical equation.

After that, convert the grams of Na into moles of Na, and then multiply that with the ratio of moles of NaCl to Na, and then convert the mol of NaCl into grams in order to obtain the theoretical yield, since we are given that Na is the limiting reactant.

After that, plug the values into the yield formula, doing some basic algebra, and you should get your result.

You're going to first balance the chemical equation.

After that, convert the grams of Na into moles of Na, and then multiply that with the ratio of moles of NaCl to Na, and then convert the mol of NaCl into grams in order to obtain the theoretical yield, since we are given that Na is the limiting reactant.

After that, plug the values into the yield formula, doing some basic algebra, and you should get your result.

The scientific question related to the game of basketball is option D: "Do teams that practice more win more games?"

This question is scientific because it explores a cause-and-effect relationship between practice and game outcomes. It can be investigated through empirical observation and data analysis.

To answer this question, researchers could collect data on the practice hours of different basketball teams and compare them to their corresponding game performance. Statistical analysis could be used to determine if there is a correlation between practice time and winning percentage or other performance metrics.

By examining a large sample of teams over an extended period, researchers could draw conclusions about the impact of practice on game outcomes. This scientific inquiry would contribute to the understanding of the factors that influence team success in basketball and could potentially inform training strategies and coaching techniques.

For more question on basketball

https://brainly.com/question/29505871

#SPJ8

Answer:

C.

Explanation:

Answer A is incorrect because a compound doesn't have to be made with only metals.

Answer B is incorrect because that is actually the definition of a pure element.

Answer C is correct because to make a compound, there has to be a chemical reaction where bonds are formed and an entirely new substance is created.

Answer D is incorrect because compounds cannot be separated by physical means.

Hope this helps :D

Answer:

45 °C.

Explanation:

From the question given above, the following data were obtained:

Heat (Q) = 1125 J

Mass (M) = 250 g

Final temperature (T₂) = 55 °C

Specific heat capacity (C) = 0.45 J/gºC

Initial temperature (T₁) =?

The initial temperature of the iron can be obtained as illustrated below:

Q = MC(T₂ – T₁)

1125 = 250 × 0.45 (55 – T₁)

1125 = 112.5 (55 – T₁)

Divide both side by 112.5

1125/112.5 = 55 – T₁

10 = 55 – T₁

Collect like terms

10 – 55 = –T₁

–45 = –T₁

Multiply through by –1

45 = T₁

T₁ = 45 °C

Therefore, the initial temperature of the iron is 45 °C

Answer:

Analytical Chemist

Forensics

Toxicologist

Biochemist

Chemical Engineer

Laboratory Technician

Pharmacologist

Chemical Technician

Materials Scientist

Environmental Chemist

Answer:

chemical reaction between those a b c it's a reaction which occurs when heating

Answer:

62.5 moles of O₂.

Explanation:

We'll begin by writing the balanced equation for the reaction. This is illustrated below:

2C₈H₁₈ + 25O₂ —> 16CO₂ + 18H₂O

From the balanced equation above,

2 moles of C₈H₁₈ reacted with 25 moles of O₂.

Finally, we shall determine the number of mole of O₂ needed to react with 5 moles of C₈H₁₈. This can be obtained as shown below:

From the balanced equation above,

2 moles of C₈H₁₈ reacted with 25 moles of O₂.

Therefore, 5 moles of C₈H₁₈ will react with = (5 × 25) / 2 = 62.5 moles of O₂.

Thus, 62.5 moles of O₂ is needed for the reaction.

Answer:

sodium bicarbonate solution

Answer:

See explanation

Explanation:

Tyndall effect refers to the scattering of light in a solution. Tyndall effect occurs when the size of particles in the solution exceeds 1 nm in diameter. Such solutions are actually called false solutions.

In tincture of iodine, the size of particles in solution is less than 1 nm in diameter hence the solution does not exhibit Tyndall effect. Hence, tincture of iodine is a true solution.

Therefore, if the size of particles in solution exceeded 1nm in diameter, Tyndall effect is observed.

Answer:

Explanation:

Lithium Sulphate

Answer:

Lithium sulfate is a white inorganic salt with the formula Li2SO4. It is the lithium salt of sulfuric acid.

Answer:  1)  temperature, 2) add a catalyst, and 3) concentrations

Explanation:  A rise in temperature adds kinetic energy to the reactants, leading to more frequent, and energetic collisions, which will often accelerate the reaqction.  A catalyst is an agent that helps the reaction move forward more quickly by offering a substrate that aids in orienting the reactants for more efficient reaction.  A higher concentration increases the chances of collisons that result in products.

Answer:

69

Explanation:

I thought that I answer is correct

Answer:

The answer is 69

Explanation:

Because if you add one its 66, and so on, hope this helps! but if you add five it will be 69, if you need help with easy equations let me know

Explanation:

a unit of mass used to express atomic and molecular weights, equal to one twelfth of the mass of an atom of carbon-12.

Answer:

Atomic Mass Unit is also called Dalton. It is used to express atomic and molecular weight. It is defined as 1/12 of the mass of an unbound neutral atom of carbon.

Water is the solvent in the saline solution. Hence, option D is correct.

A solute is something being dissolved, a solvent is a thing dissolving the item, and the solution is the mixture of the two items.

In a hospital, bags of saline solution are used to rehydrate patients. They are made by dissolving a specific amount of salt in water. Water is the solvent in the saline solution.

Hence, option D is correct.

Learn more about the solution here:

https://brainly.com/question/7932885

#SPJ5

Answer:

sodium chloride

hope that helped :)

Answer:

Chlorine is a greenish yellow gas at room temperature and atmospheric pressure. ... yielding chlorine water, and from this solution a solid hydrate of ideal ...

Answer:

Some examples of solutions are salt water, rubbing alcohol, and sugar dissolved in water. ... In our example of salt water, the solute is the salt. Solvent: this is the substance that makes up the majority of the solution. This is the part where the solute is dissolved.

Explanation:

I hope they should be right answer

Answer:

a

Explanation:

Explanation:

your answer was correct

Explanation:

a) m (metre)

b) mm (millimeter)