In the original solution you have the mixture of a weak acid (Hypochlorous acid) and its conjugate base (Sodium hypochlorite). That is a buffer.
The barium hydroxide will react with hypochlorous acid. If this reaction cause the complete reaction of hypochlorous acid, the buffer break its capacity and the pH change in several units. In this case:
The addition of barium hydroxide will raise the pH slightly because the buffer still working.
The initial moles of those species are:
Hypochlorous acid:
[tex]1L * \frac{0.370mol}{1L} = 0.370 moles[/tex]
Sodium hypochlorite:
[tex]1L * \frac{0.493mol}{1L} = 0.493 moles[/tex]
Now, a strong acid as barium hydroxide (Ba(OH)₂) reacts with a weak acid as hypochlorous acid (HClO) as follows:
Ba(OH)₂ + 2HClO → Ba(ClO)₂ + 2H₂O
For a complete reaction of 0.092 moles of barium hydroxide are required:
[tex]0.092 moles Ba(OH)_2*\frac{2mol HClO}{1molBa(OH)_2} = 0.184 moles HClO[/tex]
As there are 0.370 moles, the moles of HClO after the reaction are:
0.370 moles - 0.184 moles = 0.186 moles of HClO will remain
As you still have hypochlorite and hypochlorous acid you still have a buffer.
Thus, the pH will raise slightly because the amount of acid is decreasing and slightly because the buffer can keep the pH.
Learn more about buffers in:
https://brainly.com/question/24302294
Write balanced equations for the reaction of each of the following carboxylic acids with NaOH. Part A formic acid Express your answer as a chemical equation. A chemical reaction does not occur for this question. Request Answer Part B 3-chloropropanoic acid Express your answer as a chemical equation. nothing A chemical reaction does not occur for this question.
Answer:
Part A
HCOOH(aq) + NaOH(aq) → HCOONa(aq) + H2O(l)
Part B
ClCH2CH2CO2H(aq) + NaOH(aq) ------> ClCH2CH2CO2Na(aq) + H2O(l)
Explanation:
The reaction between an alkanoic acid and a base is a neutralization reaction. The reaction occurs as follows;
RCOOH + NaOH ----> RCOONa + H2O
We have to note the fact that the net ionic reaction still remains;
H^+(aq) + OH^-(aq) ---> H2O(l)
In both cases, the reaction can occur and they actually do occur as written.
Heating water makes most solids in it
soluble, and it makes gases
soluble.
Increasing the pressure on a gas above water makes the gas
soluble. Compounds with comparatively stronger ionic bonds are
soluble.
Answer:
1. more
2. less
3. more
4. less
Explanation:
The density of toluene (C7H8) is 0.867 and that of thiophene (C4H4S) is 1.065 g/ml. A solution is made by dissolving 10.00g thiophene in 250.00ml of toluene. a)Calculate the molarity of the solution
b)Assuming the volume are addictive ,calculate the molarity of the solution
Answer:
Calcular la molaridad de una solución que se preparó disolviendo 14 g de KOH en suficiente
agua para obtener 250 mL de solución. (masa molar del KOH = 56 g/mol).
Resolución: de acuerdo a la definición de “molaridad” debemos calcular primero, el número de mol de soluto (KOH) que
se han disuelto en el volumen dado, es decir, “se transforma g de soluto a mol de soluto” por medio de la masa molar,
así:
56 g de KOH 14 g de KOH
----------------- = ------------------- X = 0,25 mol de KOH
1 mol X
Ahora, de acuerdo con la definición de molaridad, el número de mol debe estar contenido en 1000 mL (o 1 L) de
solución, que es el volumen estándar para esta unidad de concentración, lo que se determina con el siguiente planteamiento:
0,25 mol X
----------------------- = ------------------------- X = 1 mol de KOH
250 mL de solución 1000 mL de solución
Explanation:
Determine the effect each given mutation would have on the rate of glycolysis in muscle cells.
a. loss of binding site for fructose 1 ,6-bisphophate in pyruvate kinase.
b. loss of allosteric binding site for ATP in pyruvate kinase.
c. loss of allosteric binding site for AMP in phosphofructokinase.
d. loss of regulatory binding site for ATP in phosphofructokinase.
1. Increase
2. decrease
3. No effect
Answer:
a. Decrease
b. Increase
c. Increase
d. No effect
Explanation:
Glycolysis is present in muscle cells which converts glucose to pyruvate, water and NADH. It produces two molecules of ATP. Cellular respiration produces more molecules of ATP from pyruvate in mitochondria. Glycolysis increases in pyruvate kinase.
a. Loss of binding site for fructose 1,6-bisphosphate in pyruvate kinase: Decrease
b. Loss of allosteric binding site for ATP in pyruvate kinase: No effect
c. Loss of allosteric binding site for AMP in phosphofructokinase: Increase
d. Loss of regulatory binding site for ATP in phosphofructokinase: Increase
A. An important substrate in the glycolysis pathway is fructose 1,6-bisphosphate. It stimulates pyruvate kinase, an essential enzyme in glycolysis. The amount of pyruvate kinase that is activated will decrease if the fructose 1,6-bisphosphate binding site in pyruvate kinase is eliminated. As a result the rate of glycolysis in the muscle cells will probably decrease.
B. The allosteric ATP binding site of pyruvate kinase controls how active the enzyme is. However, pyruvate kinase is not significantly regulated by ATP in muscle cells. Therefore, it is unlikely that deletion of the ATP-binding allosteric site in pyruvate kinase would have no effect on the rate of glycolysis in muscle cells.
C. The rate-limiting enzyme in glycolysis, phosphofructokinase, is activated from all forms by AMP. It increases the rate of glycolysis by stimulating the activity of phosphofructokinase. If the allosteric binding site for AMP is eliminated, phosphofructokinase activation will be reduced. As a result, the rate of glycolysis in muscle cells will decrease.
D. Phosphofructokinase is inhibited allosterically by ATP. It regulates the rate of glycolysis by a feedback mechanism. High ATP concentrations cause phosphofructokinase to bind to its regulatory site, limiting its activity and delaying glycolysis. If the regulatory binding site for ATP is eliminated, the inhibitory action of ATP on phosphofructokinase would be lost. As a result, muscle cells will glycolysis at a faster rate.
Learn more about glycolysis, here:
https://brainly.com/question/26990754
#SPJ6
What volume of each solution contains 0.14 mol of KCl? Express your answer using two significant figures.
1.8 M KCl
Answer:
Solution given:
1 mole of KCl[tex]\rightarrow [/tex]22.4l
1 mole of KCl[tex]\rightarrow [/tex]74.55g
we have
0.14 mole of KCl[tex]\rightarrow [/tex]74.55*0.14=10.347g
74.55g of KCl[tex]\rightarrow [/tex]22.4l
10.347 g of KCl[tex]\rightarrow [/tex]22.4/74.55*10.347=3.11litre
volume of each solution contains 0.14 mol of KCl contain 3.11litre.
[tex]\:[/tex]
1 mole of KCl → 22.4l
1 mole of KCl → 74.55g
we have
0.14 mole of KCl → 74.55*0.14=10.347g
74.55g of KCl → 22.4l
10.347 g of KCl → 22.4/74.55*10.347=3.11litre
volume of each solution contains 0.14 mol of KCl contain 3.11litre.
When a marble is dropped into a beamer of water
Answer:
The water will rise.Explanation:
hope this helps you
-Sweety<3The mass of the marble is greater than that of the water. The marble weighs more than an equivalent volume of the water. The force from dropping the marble breaks the surface tension of the water. The marble has greater mass and volume than the water.
Tick (√) the statements that are correct.
a) By eating rice alone, we can fulfil nutritional requirement of our body. ( )
b) Deficiency Diseases can be prevented by eating a balanced diet. ( )
c) Balanced diet for the body should contain a variety of food items. ( )
d) Meat alone. is sufficient to provide all nutrients to the body. ( )
b) (√)
c)(✓)
hsjdhfjdkskkshd
Consider the reaction: NaNO3(s) + H2SO4(l) NaHSO4(s) + HNO3(g) ΔH° = 21.2 kJ
How much heat must absorbed by the reaction system to convert 100g of NaNO3 into NaHSO4(s)?
Answer:
endet nach selam nw
4gh7
